AEG Gas cooker 49190GOMN User Manual

  ENGLISH 21
5.5 Adjustments
• All seal must be replaced by the technician following any adjustment 
or regulation. 
• The adjustment of the reduce rate (simmer) must be undertaken only 
with burners functioning on natural 
gas while in the case of burners 
functioning on L.P.G, the screw must 
be locked down fully (in clockwise 
direction).
• “Primary air adjustment” on hob gas burners is unnecessary.
Taps 
All gas taps are male cone type with only 
one way of passage. 
Adjustment of the “Reduced rate”...

22 www.aeg.com
fig. 14
5.5 Adjustments  
• Always disconnect the appliance from the electricity supply before making 
any adjustment.All gas taps are male 
cone type with 
5.7 Maintenance
Prior to any maintenance work or 
changing parts, disconnect the 
appliance from the gas and electricity 
power sources.
Replacing the taps
Proceed in the following way when 
replacing a tap or the thermostat:
• Remove pan supports, burner heads.• Unscrew the burner fixing screws (four for ultrarapid burner and two for...

  ENGLISH 23
Changing the flexible gas hose
In order to guarantee that the gas hose is 
always in excellent condition we strongly 
recommend changing it on the date you 
will find printed on it.
Replacing the electrical 
coponents
• The rear protection will have to be removed in order to change the 
electrical heating elements, spit 
motor, terminal board and power 
cable.
• If you have to change the power cable (see the cross section on table in the 
“Technical information” section), 
always keep the...

24 www.aeg.com
Burner disposition and hob burner technical data table
BurnersOperating 
pressure gas RateDiameter 
injector  Sabaf Heat input
By-pass
N. Denomination mbarg/h1/100 mm MinMax1/100 mm
 1  Ultrarapid GPL  30
Natural gas 20  23692
124-Y 1350
13503250
3250
65
 2  Rapid GPL  30
Natural gas 20  21888
117-Y 800
8003000
3000
44
 3  Semi-rapide GPL  30
Natural gas 20 13168
98-Z 600
6001800
1800
34
 4  Auxiliary GPL  30
Natural gas 20 7351
75-X 400
4001000
1000
28
ELECTRIC COMPONENTS     Description...

  ENGLISH 25
The appliance was designed and made 
in accordance with the European 
standards listed below:
=> EN 30-1-1, EN 30-2-1 and EN 437 plus 
subsequent amendments (gas)
=> EN 60 335-1 and EN 60 335-2-6 (electrical) plus relative amendments
The appliance complies with the 
prescriptions of the European Directives 
as below:
=> 2006/95 EC concerning electrical safety (BT).
=> 2004/108 EC concerning electromagnetic compatibility (EMC)
=> 2009/142 EC concerning gas safety .
Oven accessories that could...

26 www.aeg.com 

  ENGLISH 27 

461308335   03/2014
www.aeg.com/shop