AEG Freestanding washer dryer L87695NWD User Manual

5.6.7.8.9. 13.8 Emergency drain
Because of a malfunction, the appliance cannot drain the water.
If this occurs, do steps (1) through (9) of
'Cleaning the drain filter'. If necessary,
clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:1. Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2. Start the programme to drain the
water.13.9  Frost precautions
If the appliance is installed in an area
where the...

1.Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in
a container and let the water flow out of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.WARNING!
Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not responsible for damages
caused by low temperatures.14.  TROUBLESHOOTINGWARNING!
Refer to...

ProblemPossible solution Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority. Make sure that the water tap is not clogged.Make sure that the filter of the inlet hose and the filter of the
valve are not clogged. Refer to “Care and cleaning”.Make sure that the inlet hose has no kinks or bends.Make sure that the connection of the water inlet hose is cor-
rect.The appliance does not
fill with water and drain
immediately.Make sure that the...

ProblemPossible solution Set the drain or the spin programme if there is water in the
drum.Make sure that the appliance receives electrical power.This problem may be caused by a failure of the appliance.
Contact the Authorised Service Centre. If you need to open
the door, please read carefully «Emergency door opening».The appliance makes an
unusual noise.Make sure the levelling of the appliance is correct. Refer to 'In-
stallation'. Make sure that the packaging and/or the transit bolts are re-...

After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.14.3  Emergency door opening
In case of power failure or functioning failure the appliance door remainslocked. The washing programme
continues when the power is restored. If
the door remains locked in...

Water supply pressure1)Minimum
Maximum0,5 bar (0,05 MPa)
8 bar (0,8 MPa)Maximum wash loadCotton9 kgMaximum dry loadCotton
Synthetics6 kg
3 kgSpin SpeedMaximum1600 rpm1)  The appliance works correctly if the water pressure is not lower than 0.05 MPa (0.5 bar). If you cannot
connect the water inlet hose to the cold water tap of the primary hydraulic system, connect it to your
domestic cold water storage system. Make sure not to exceed a distance of 5.02 m (16.5 ft) between the
appliance inlet hose and the...

ENGLISH37 

www.aeg.com38 

ENGLISH39 

www.aeg.com/shop132950400-A-282015