AEG Freestanding dishwasher FSILENCEW0P User Manual

7.2 Setting and starting a
programme
Setting mode
For some settings it is necessary that the
appliance is in setting mode.
Press the on/off button to activate the
appliance. The appliance is in setting
mode when all the programme indica-
tors come on and the display shows 2
horizontal status bars. If the control pan-
el does not show this condition, press
and hold, at the same time Delay and
Start until the appliance is in setting
mode.
Starting a programme without
delay start
1.Open the water tap....

Important
• Let the dishes become cold before
you remove them from the appliance.
Hot dishes can be easily damaged.
• First remove the items from the lower
basket, then from the upper basket.• There can be water on the sides and
on the door of the appliance. Stainless
steel becomes cool more quickly than
the dishes.
8. HINTS AND TIPS
8.1 The water softener
Hard water contains a high quantity of
minerals that can cause damage to the
appliance and bad washing results. The
water softener neutralises these...

• The position of the items in the bas-
kets is correct.
• The programme is applicable for the
type of load and for the degree of soil.
• The correct quantity of detergent is
used.• There is dishwasher salt and rinse aid
(unless you use combi detergent tab-
lets).
• The cap of the salt container is tight.
9. CARE AND CLEANING
WARNING!
Before maintenance, deactivate
the appliance and disconnect the
mains plug from the mains sock-
et.Dirty filters and clogged spray
arms decrease the washing re-
sults.
Make...

9.3 External cleaning
Clean the appliance with a moist soft
cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning
pads or solvents.
9.4 Internal cleaning
If you regularly use short duration pro-
grammes, these can leave deposits ofgrease and limescale inside the appli-
ance.
To prevent this, we recommend to run
long duration programmes at least 2
times per month.
10. TROUBLESHOOTING
The appliance does not start or it stops
during operation.
Before you contact the Service,...

ProblemPossible solution
 Make sure that the drain hose has no kinks
or bends.
The anti-flood device is on.Close the water tap and contact the Service.
After the checks are completed, activate
the appliance. The programme contin-
ues from the point of interruption.
If the problem occurs again, contact the
Service.
If the display shows other alarm codes,
contact the Service.
10.1 If the washing and drying
results are not satisfactory
Whitish streaks or bluish layers on
glasses and dishes
• The released...

 Frequency50 Hz
Water supply pressureMin. / max. (bar / MPa)(0.5 / 0.05 ) / (8 / 0.8 )
Water supply 1)Cold water or hot water2)max. 60 °C
CapacityPlace settings12
Power consumptionLeft-on mode0.10 W
Off-mode0.10 W
1) 
Connect the water inlet hose to a water tap with a 3/4'' thread.
2) 
If the hot water comes from alternative sources of energy, (e.g. solar panels, aeolian
energy), use the hot water supply to decrease energy consumption.
12. ENVIRONMENT CONCERNS
Recycle the materials with the...

ENGLISH17 

18www.aeg.com 

ENGLISH19 

www.aeg.com/shop
117906220-A-272013