Advidia A64 Dome Camera Quick Start Guide

							  1              A64 Dome Camera Quick Start Guide  
						

							Network Dome Camera · Quick Start Guide  1Thank you for purchasing our product. If there are any questions, or requests, please do not hesitate to contact the dealer.  About This Document This manual applies to the following models. Model A64 This manual may contain several technical incorrect places or printing errors, and the content is subject to change without notice. The updates will be added to the new version of this manual. We will readily improve or update the products or procedures described in the manual. DISCLAIMER STATEMENT  “Underwriters Laboratories Inc. (“UL”) has not tested the performance or reliability of the security or signaling aspects of this product.  UL has only tested for fire, shock or casualty hazards as outlined in UL’s Standard(s) for Safety, UL60950-1.  UL Certification does not cover the performance or reliability of the security or signaling aspects of this product.  UL MAKES NO REPRESENTATIONS, WARRANTIES OR CERTIFICATIONS WHATSOEVER REGARDING THE PERFORMANCE OR RELIABILITY OF ANY SECURITY OR SIGNALING RELATED FUNCTIONS OF THIS PRODUCT.    0502001040703 Regulatory Information  
						

							Network Dome Camera · Quick Start Guide  2FCC Information FCC compliance: This equipment has been tested and found to comply with the limits for a digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. FCC Conditions This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation. EU Conformity Statement This product and - if applicable - the supplied accessories too are marked with "CE" and comply therefore with the applicable harmonized European standards listed under the Low Voltage Directive 2006/95/EC, the EMC Directive 2004/108/EC, the RoHS Directive 2011/65/EU.  2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted  
						

							Network Dome Camera · Quick Start Guide  3municipal waste in the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.info. 2006/66/EC (battery directive): This product contains a battery that cannot be disposed of as unsorted municipal waste in the European Union. See the product documentation for specific battery information. The battery is marked with this symbol, which may include lettering to indicate cadmium (Cd), lead (Pb), or mercury (Hg). For proper recycling, return the battery to your supplier or to a designated collection point. For more information see: www.recyclethis.info 
						

							Network Dome Camera · Quick Start Guide  4Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss.  The precaution measure is divided into “Warnings” and “Cautions” Warnings: Serious injury or death may occur if any of the warnings are neglected. Cautions: Injury or equipment damage may occur if any of the cautions are neglected.  Warnings ● In the use of the product, you must be in strict compliance with the electrical safety regulations of the nation and region. Please refer to technical specifications for detailed information. ● Input voltage should meet both the SELV (Safety Extra Low Voltage) and the Limited Power Source with 24 VAC or 12 VDC according to the IEC60950-1 standard. Please refer to technical specifications for detailed information.   Warnings Follow these safeguards to prevent serious injury or death. Cautions Follow these precautions to prevent potential injury or material damage.   
						

							Network Dome Camera · Quick Start Guide  5● Do not connect several devices to one power adapter as adapter overload may cause over-heating or a fire hazard. ● Please make sure that the plug is firmly connected to the power socket. When the product is mounted on wall or ceiling, the device shall be firmly fixed.  ● If smoke, odor or noise rise from the device, turn off the power at once and unplug the power cable, and then please contact the service center.   Cautions ● Make sure the power supply voltage is correct before using the camera. ● Do not drop the camera or subject it to physical shock. ● Do not touch sensor modules with fingers. If cleaning is necessary, use clean cloth with a bit of ethanol and wipe it gently. If the camera will not be used for an extended period, please replace the lens cap to protect the sensor from dirt.  ● Do not aim the camera at the sun or extra bright places. Blooming or smearing may occur otherwise (which is not a malfunction), and affect the endurance of sensor at the same time. ● The sensor may be burned out by a laser beam, so when any laser equipment is in using, make sure that the surface of sensor will not be exposed to the laser beam. ● Do not place the camera in extremely hot, cold (the operating temperature shall be-30°C ~+60°C,or -40°C ~ 60°), dusty or  
						

							Network Dome Camera · Quick Start Guide  6damp locations, and do not expose it to high electromagnetic radiation.  ● To avoid heat accumulation, good ventilation is required for operating environment.  ● Keep the camera away from liquid while in use. ● While in delivery, the camera shall be packed in its original packing, or packing of the same texture. ● Regular part replacement: a few parts (e.g. electrolytic capacitor) of the equipment shall be replaced regularly according to their average enduring time. The average time varies because of differences between operating environment and using history, so regular checking is recommended for all the users. Please contact with your dealer for more details. ● Improper use or replacement of the battery may result in hazard of explosion. Replace with the same or equivalent type only. Dispose of used batteries according to the instructions provided by the battery manufacturer.  ● If the product does not work properly, please contact your dealer or the nearest service center. Never attempt to disassemble the camera yourself. (We shall not assume any responsibility for problems caused by unauthorized repair or maintenance.)  
						

							Network Dome Camera · Quick Start Guide  7Table of Contents 1 Appearance Description ................................................................. 8 2 Installation .................................................................................... 10 2.1 Ceiling Mounting ........................................................... 11 2.2 Wall Mounting .............................................................. 15 2.3 3-axis Adjustment and Lens Adjustment ....................... 17 2.3.1 3-axis Adjustment ............................................... 17 2.3.2 Lens Adjustment................................................. 18 3 Setting the Network Camera over the LAN .................................. 20  .................................................................................... 23 4 Accessing via Web Browser .......................................................... 25              
						

							Network Dome Camera · Quick Start Guide  81 Appearance Description The overview of the network dome camera is shown below.  Figure 1-1 Overview 101112234567891314151 Figure 1-2 Detailed Components Table 1-1 Description   
						

							Network Dome Camera · Quick Start Guide  9No. Description No. Description 1 Black Liner 9 Audio Out  2 Bubble 10 Reset Button 3 Power Interface 11 CVBS Interface 4 Alarm Output A 12 SD Card Slot 5 Alarm Output B 13 Mounting Base 6 Grounding 14 Lens 7 Alarm Input 15 Network Interface 8 Audio In     Press RESET about 10s when the camera is powering on or rebooting to restore the default settings, including the user name, password, IP address, port No., etc.  This series of camera supports 12V DC, 24V AC, and PoE power supply. Please make sure your power supply meets the demands.