ADT Security Services Safewatch EZ User Manual

11 
EXITING WITH THE SYSTEM ALREADY ARMED 
1 
 
Press the AWAY button. 
 
  
 
The ARMED indicator will begin to flash, indicating the 60 second exit delay period.  
2 
 
Unlock the deadbolt from the inside.  System will disarm. 
3 
 
Open the door and exit.   If the system is Armed STAY and you are leaving with NO other family members remaining home: 
 
4 
 
Lock the deadbolt from the outside to arm the system.  The EZ Touchpad will give one chirp to 
indicate the system has armed. 

If the deadbolt...

12 
EMERGENCY BUTTONS 
 
 The Emergency Buttons, if programmed, are always active, whether the system is armed 
or disarmed.  The Emergency Button 
must be Held Down for 3 seconds to activate the 
emergency alarm and transmit the signals to central station.
 
 
 
Police Emergency  Hold down the Police Emergency button to alert the central station of 
a police emergency.   * 
(Police Emergency programmed?   
‰YES  
‰NO)
 
 
 
Fire Emergency  Hold down the Fire button to alert the central station of a fire...

13 
DISARMING THE SYSTEM 
 
 
Disarming when returning home: 
 
When returning home, simply unlocking your deadbolt from the outside will automatically disarm the 
system.  The red ARMED light will go out and the green READY  light will come on.  
 
If an alarm has occurred while you were away, the red ARMED light will be flashing and the EZ Touch-
pad sounder will be active.  
 Proceed with caution!  If you suspect that an intruder may still be in the premises, leave immediately 
and call authorities...

14 
If an alarm occurs while you are at home:
 
The EZ Touchpad siren will sound and the red 
ARMED
 light will flash. 
 Proceed with caution!  If you suspect that an intruder may still be in the premises, leave 
immediately and call authorities from a neighbors telephone. 
 
 To silence the alarm, insert your EZ-IFOB key into the IFOB slot on the EZ Touchpad and remove 
when alarm has silenced. 
 
   The red 
ARMED
 light will continue to flash the number of the zone(s) on which the alarm occurred....

15 
 
 
If a fire is detected, the siren will sound a distinct pulsating tone and the FIRE indicator on the EZ 
Touchpad will be flashing.  If a Fire Alarm does occur: 
  * Note: This feature may not apply to your system. Consult your installer to determine if your system includes fire protection. 
 
1 
 
If a fire is in progress, evacuate the premises immediately!  Call the Fire Department from an outside phone.
 
2  
 
If there is no evidence of a fire, press 
SILENCE 
OR insert your EZ-IFOB key into...

16 
FIRE PROTECTION 
Preparing a Fire Escape Plan 
Even with the most advanced fire 
alarm system, adequate protection 
requires an escape plan. 
To prepare your plan, draw floor 
plans of your building.  Show two 
exits - a front or back door and a 
window from each room.  (Make sure 
the window works.  You may need a 
special fire-escape ladder if the 
window is high up).  Write down your 
outside meeting place. 
 
Family Rehearsal 
Rehearse each of the following 
activities: 
1.   Everyone in his room...

17 
Your ADT Safewatch EZ System is constantly monitoring its own components, as well as all critical services, such as AC power and 
the telephone line, to insure that it is always ready to provide the protection for which it was designed.  When a system trouble occurs, the 
EZ Touchpad will caution you with a Trouble 
TBL light and a beeping sounder.  
If you cannot immediately fix the trouble, the system can still be used.  Simply press SILENCE to view the trouble as described below 
and press SILENCE...

18 
SYSTEM TROUBLE ERROR CODES              
TBL 
Flashes / 
Touchpad beeps READY  
Flashes Trouble Condition  Action 
6  NONE  Lost Key Mode  This is a reminder that the system has been put into the lost key mode ([STAY] & 
[AWAY] pressed simultaneously).  While in this mode, the system can only be dis-
armed with your EZ-IFOB. When you have replaced or re-keyed your deadbolt, 
press [STAY] & [AWAY] simultaneously again to exit lost key mode. 
7  NONE  Fire Zone Trouble  A problem has been detected with...

19 
The space below is for recording the descriptions of the zones in your system.  
•If the system has a faulted zone, count the number of 
READY
 light flashes and refer to the list below to see which 
zone is open and secure it (close the door or window, etc.). 
•If an alarm has occurred, count the number of 
ARMED
 light flashes and refer to the list below to see which zone 
caused the alarm: 
ZONE 1   
  
ZONE 2   
  
ZONE 3   
  
ZONE 4   
  
ZONE 5   
  
ZONE 6   
  
ZONE 7   
  
ZONE 8...

20 
 
 
The EZ-IFOB is a uniquely coded digital key which performs the following functions when inserted into the EZ-IFOB slot on the 
EZ Touchpad:  
•Disarm an armed system  •Silence an active alarm •Reset a fire alarm 
 
The Master EZ-IFOB supplied with your system will perform all of these functions, plus it may also be used to add up to 5 addi-
tional EZ-IFOBs to the system.  The following instructions will guide you through adding additional EZ-IFOBs as well as remov-
ing EZ-IFOBs in the event that...