Home > ADT Security Services > Home Security > ADT Security Services BHS 1202 User Manual

ADT Security Services BHS 1202 User Manual

    Download as PDF Print this page Share this page

    Have a look at the manual ADT Security Services BHS 1202 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 68 ADT Security Services manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

    							21
    Emergency Evacuation Plans
    An emergency evacuation plan should be established for an actual fire
    alarm condition. For example, the following steps are recommended by
    the National Fire Protection Association and can be used as a guide for
    establishing this plan for homes or commercial buildings.
    1. Draw up a floor plan of your premises. Show windows, doors, stairs,
    and rooftops that can be used for escape. Indicate each room’s
    escape routes. Determine two means of escape from each room.
    One will be the door leading to the normal exit from the premises.
    The other may be a window that opens easily. An escape ladder
    may have to be located near the window if there is a long drop to
    the ground below.
    2. Set a meeting place outdoors for a head count of all occupants.
    Practice escape procedures. For increased home safety, sleep with
    the bedroom door closed. It will increase your escape time. If you
    suspect fire, test the door. If it feels hot, the hall is already too hot
    to enter. If you think it is safe, brace your shoulder against the
    door and open it cautiously. Be ready to slam the door if smoke or
    heat rush in. Practice escaping to the outdoors and meeting in an
    assigned spot. Call the fire department from a neighbor’s phone. 
    						
    							22
    NOTE: After having the alarm system installed, please contact your local
    fire and police departments to find out if an alarm permit is required.
    Early warning fire detection is best achieved by fire detection equipment
    installed in all rooms and areas of the household as follows: a smoke
    detector installed in each separate sleeping area (vicinity of, but outside of
    the bedrooms), and heat and smoke detectors in living rooms, dining rooms,
    bedrooms, kitchens, hallways, attics, furnace rooms, closets, utility and
    storage rooms, basements, and attached garages. This equipment should
    be installed in accordance with the National Fire Protection Association’s
    Standard 72. For additional information write:
    National Fire Protection Association
    1 Battery March Park
    Quincy, Massachusetts 02269
    California residents may also write:
    California State Fire Marshal
    7171 Bowing Drive, Suite 600
    Sacramento, California 95823
    WARRANTY INFORMATION
    This manual does not create any additional expressed or implied warranties. 
    						
    							23
    QUESTIONS AND ANSWERS
    1. Who pays false alarm fines?
    Because the vast majority of false alarms are outside of Brink’s
    control, we require that the customer be responsible for all their
    false alarm fines.
    2. How can I avoid false alarms?
    Review the instructions on page 2. If you have any further
    questions, call Brink’s Customer Service at 1-800-445-0872.
    Customer Service is available 24 hours a day, seven days a week.
    3. If I go on vacation, should I give my master code to my
    neighbor who takes care of my house?
    It is best not to give out your master code or code word. You can
    program an auxiliary code for your neighbor to use. See the
    instructions on page 13. An auxiliary code WORD can be added
    for their use by calling Brink’s Customer Service at
    1-800-445-0872. You should give your emergency contacts a
    telephone number where you can be reached.
    4. How often do I test the system?
    You should test the system weekly. Follow the test sequence outline
    in the testing section of this manual on page 14. DO NOT try to
    test the system by intentionally activating an alarm. This may result
    in the unnecessary dispatching of emergency response personnel
    to your site and a possible false alarm fine.
    5. Should the smoke/heat detector be cleaned?
    Yes. Follow the instructions on page 20.
    6. If I lose electrical power will the system still be functional?
    Yes. Each system is equipped with a battery which normally
    provides back-up power from four to six hours. Once electrical
    power is restored, the battery will automatically recharge. Like all
    batteries, the alarm system battery will eventually need to be
    replaced. When this happens, a service call can be scheduled to
    replace the battery by calling Brink’s Customer Service at 
    						
    							24
    1-800-445-0872. Brink’s Customer Service is available 24 hours a
    day, seven days a week. There will be a charge for this service call
    unless you purchased an extended service plan.
    7.  If there is an alarm, will the system reset?
    Yes. Once an alarm has sounded, provided there are no further
    violations, the system will reset in approximately five minutes.
    NOTE: If a fire alarm is activated, the siren will sound
    continuously until a valid user code is entered.
    8. Who should I list as an emergency contact?
    You should list people who live fairly close to you and usually know
    where you are and how to contact you. Ideally, at least one of your
    contacts should have keys to your house and permission to
    authorize service in your absence.
    9. What should I tell my emergency contacts?
    Be sure to tell them that you have listed them as an emergency
    contact. Tell them that Brink’s may attempt to reach them after
    notifying an emergency agency. Discuss what action you would
    like them to take if Brink’s calls them. The emergency agency may
    request that someone with keys meet them at your house.
    Emergency contacts should not attempt to investigate an intrusion
    alarm, unless the police request that someone meet them. You
    should also tell your emergency contacts if they have your
    permission to authorize service of the system in your absence.
    10. What happens if my phone lines are cut?
    Although a cut is very unlikely, if an intrusion occurs after your
    phone line is cut, the system’s siren can still sound an audible
    alarm, but our Monitoring Center will not receive a signal. Your
    Brink’s technician or Customer Service representative may be able
    to recommend ways for your to protect your phone line. Brink’s
    has available a cellular backup device which is designed to send
    a signal if phone lines are not operable. Please ask a Brink’s
    representative if you are interested in learning more about this
    device. 
    						
    							25
    11. Do I pay for service calls or repairs?
    Repair service during the first 90 days is free of charge. Normal
    service hours are 8:00 am to 5:00 pm, Monday through Friday.
    After hours, on weekends or holidays there is a premium rate
    charge. After the first 90 days, we charge for labor. Brink’s Home
    Security has service plans available which provide for repair of
    the equipment after the first 90 days.
    12. Can I set a specific time for a service call?
    Our service center schedules service calls for the morning or
    afternoon on specific dates. Morning calls are 8:00 am to 12:00
    pm and afternoon calls are from 12:00 pm to 5:00 pm.
    13. Can I have additional equipment installed later?
    Yes, additional equipment may be installed. The installation price
    plus a service call charge to install the equipment will be applied.
    This service call charge does not apply if the equipment is installed
    during the initial installation.
    14. Do you keep a record of my master code number, and can it
    be changed?
    For your protection, we do not retain a record of your master code
    number. If you need to change your master code, notify Brink’s
    Customer Service at 1-800-445-0872 to schedule the change.
    Customer Service is available 24 hours a day, seven days a week.
    A service charge will apply for this request.
    15. How do I change my emergency contacts?
    You may call Brink’s Customer Service at 1-800-445-0872, give
    your code word and provide the updated information.
    16. How do I change my master code word?
    The new master code word must be provided in writing by the
    same party who signed the Protective Service Agreement. The
    code word cannot exceed five characters. The written
    documentation must identify the account and include the current
    master code word, the new master code word and your signature.
    Mail your request to Brink’s’s Home Security, Customer Service
    Department, 8880 Esters Boulevard, Irving, Texas 75063. If there 
    						
    							26
    is an immediate need to change your master code word, call Brink’s
    Customer Service for our fax number.
    17.What happens if I move within the initial term of my contract?
    You may have the system moved to another residence, if we service
    the area and you pay the applicable move charge. As an alternative,
    the new owner of the home may takeover the system by signing a
    new agreement and paying our current reprogramming fee. This
    will release you from the remaining contract obligations. If the new
    owner does not wish to takeover the system, and you do not choose
    to move the system, the original contract obligation will continue.
    18. Will I own the system?
    If you choose to pay only the connection fee, Brink’s will own the
    protective equipment. You may choose to own the protective
    equipment by paying an additional purchase charge.
    19.Is the system “U.L. Listed”?
    Yes. Our equipment is U.L. Listed for residential use. Our Monitoring
    Center has a U.L. listing for residential burglar alarm systems
    and fire alarm systems. U.L. Listing #BP5666.
    20. Do I need an alarm permit?
    Alarm permit ordinances vary from area to area. Please check
    your local emergency agencies, or city or county clerk’s office to
    determine if a permit is needed in your area. False alarm fines are
    generally much higher if you do not have the required permit. It is
    your responsibility to get the alarm permit, pay the applicable fee,
    and insure that you inform Brink’s of your permit number. Some
    emergency agencies will not respond to our call without this
    number.
    21. Will I receive a discount on my insurance for having a security
    system installed?
    Most home owner’s policies offer discounts. Questions should be
    addressed to your insurance company. For your records, we furnish
    a Certificate of Installation at the time of your installation. 
    						
    							27
    22. Do you provide an incentive for referring another customer?
    Brink’s offers you one month free monitoring for each new customer
    you refer that has the Brink’s Home Security system installed.
    23. How do I receive credit for referring another customer?
    Please have the person you refer write your name and telephone
    number in the space provided at the bottom of their contract. Your
    account will be credited within 60 days of their installation date.
    24. What taxes will I pay on the system?
    Taxes will vary according to the laws of your state, city and county.
    Most states require collection of a sales tax on equipment you
    purchase. Some states require collection of a service tax which
    would apply to the basic equipment connection fee, monthly
    monitoring charges and charges for repair labor. Unless you choose
    to purchase the Standard Protective Equipment, Brink’s will bill
    you once per year for property tax assessed by your local taxing
    authority. This tax is generally less than $10.
    25. What happens if I add DSL (Digital Subscriber Line) service
    to my home?
    Converting your phone to a DSL (Digital Subscriber Line) service
    or other high speed data line could affect the ability of the Brink’s
    Home Security system to transmit alarm signals. If you have
    switched to DSL or other high speed line service, you should
    immediately test the Brink’s system’s transmission capability by
    following the directions in this manual. If the transmission is not
    successful, call Brink’s Customer Care at 1-800-445-0872. It may
    be necessary for Brink’s to install a filter provided by your DSL
    company in connection with the Brink’s control panel. Note that
    although installation of the filter will generally allow communication,
    due to the nature of DSL service the Brink’s system will not be
    able to communicate if your telephone is in use or otherwise off
    the hook.
    IF YOU HAVE OTHER QUESTIONS, PLEASE CALL OUR CUSTOMER
    SERVICE DEPARTMENT AT 1-800-445-0872, OR WRITE:
    BRINK’S HOME SECURITY
    CUSTOMER SERVICE DEPARTMENT
    8880 ESTERS BOULEVARD
    IRVING, TEXAS 75063 
    						
    All ADT Security Services manuals Comments (0)

    Related Manuals for ADT Security Services BHS 1202 User Manual