Addonics Technologies Storage Tower ST13 user guide web

							Technical Support
If you need any assistance to get your unit functioning properly, please have your 
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/
v5.1.11
www.addonics.com
T E C H N O L O G I E S
User Guide
Storage Tower  XIII(ST13)         
						

							www.addonics.comTechnical Support (M-F 8:30am - 6:00pm PST)    Phone: 408-453-6212  Email: www.addonics.com/support/query/
Removing Cover of Storage 
Tower XIII
Loosen the 3 screws at the back of the tower for 
each side panel using a Philips screwdriver. 
Push each side panel toward the rear of the 
tower to disengage and remove.
Installing drives into the 
Storage Tower 
Each of the 13 bays in Storage Tower XIII can 
directly secure one 5.25” device such as an 
optical drive or a 3.5” device such as a hard 
drive mounted in a 3.5”-5.25” bracket. The bays 
may also be used in groups to secure larger 
devices such as a disk array without the need 
for modification.
For each of the 13 bays there is one LED 
located at the bottom of the cabinet for drive 
status indication, suitable for connecting to an 
internal controller unit such as a Port Multiplier. 
On the rear of the Tower are four SCSI-1 
cutouts and one mounting plate, suitable for 
installing a variety of Port Multipliers, bridge 
devices and/or adapters for bringing the internal 
drive data connections to the outside of the 
tower.
Powering up the Storage Tower
STEP 1. On the rear of the Storage Tower, 
check the red AC input switch for the correct 
main voltage setting and change it if necessary 
before connecting the power cord.
STEP 2. Turn on the main AC switch on the 
back of the tower.
STEP 3.  Press the power button on the front of 
the tower. The green Power LED next to the 
front power switch will glow.
Screws
SCSI-1
cutouts
Mounting
plate
AC input
switch Main AC  switch