Addonics Technologies Port Multiplier AD5SAPM user guide

							Technical Support
If you need any assistance to get your unit functioning properly, please have your 
product information ready and contact Addonics Technical Support at:
Hours: 8:30 am - 6:00 pm PST
Phone: 408-453-6212
Email: http://www.addonics.com/support/query/
v7.1.11
T E C H N O L O G I E S
User Guide
5X1 SATA Port Multiplier (AD5SAPM)
www.addonics.com         
						

							www.addonics.com
Phone:   408-573-8580
Fax:     408-573-8588
Email:   http://www.addonics.com/sales/query/
CONTACT US
Note:  When the internal port multiplier (PM) is connected to a SATA Host 
controller with SiI3124 or SiI3132 chip, in the RAID BIOS of the host controller, 
you will only see one drive and that is the drive connected to port 1 on the 
hardware PM.
All the SATA drives connected to the PM will show in the SATARAID5 Array 
Manager.
1.  Mount the internal SATA Port Multiplier onto the PCI bracket of any  
  standard desktop or low profile system.
2.  Attach the SATA hard drives (up to 5) to ports 1-5 on the Port Multiplier  
  using SATA cables. 
3.  Attach a 4-pin floppy power cable from the power supply unit to the  
  Port Multiplier power connecter.
4.  Connect a SATA cable to the Host SATA port of the Port Multiplier then  
  to the SATA port of the raid controller.
Port 1 - 5
Port 1
Port 2
Port 3
Port 4
Port 5 Host SATA Port
4-Pin Floppy Power Connector
+
GNDP     S        0      1     2     3     4     H
LED KEY
0-4 Power and Drive Activity LED
H    Host Device LED
P    Power LED
S    System Ready LED