Addonics Technologies NAS Adapter NAS40ESU quick install User Manual

							Quick Install 
 
In order to start sharing storage as soon as possible, follow these steps: 
 
1. Attach the NAS 4.0 unit to a network with a DHCP server present (most home routers 
provide this by default).  
 
2. All of the NAS 4.0 units functions and features are configured using a Web Interface. 
The default administrator user name is ‘admin’ and password is ‘123456’. To access this 
Web interface: 
 
Windows PC:  
a) Run the Search utility NasFindAddonics.exe from the included CD. Click the 
SCAN button. After the IP address appears, click on the Web Config button.  
b)  Alternatively you can access the Web Interface with a web browser on a 
computer attached to the same network by typing in “http://addnas” - this will 
work on most Windows systems. Be sure the computer accessing the NAS has the 
Workgroup name set to WORKGROUP. 
 
MAC PC: Mac users may need to determine the NAS 4.0 units IP address by 
opening a Terminal window and typing the following command: smbutil lookup 
addnasThis utility should return the NAS 4.0 units IP address. Typing this 
address into the web browser should open the NAS 4.0 units Web Interface. 
 
Linux PC: Linux users may need to determine the NAS 4.0 units IP address if 
Windows name resolution support is not fully installed and configured, by 
examining the DHCP servers clients table and attempting to connect to each 
unidentified IP address using a browser until the NAS 4.0 units Web Interface 
appears. 
 
3. Attach one hard disk. The Status LED should begin to blink after a few moments, then 
settle back to a steady glow. Confirm at least one partition was detected using the View 
Drive Information feature in the Configuration Menu. If not, the drive may be formatted 
with ext3 or XFS using the Format Drive feature in the Configuration Menu. 
 
4. Define at least one share, granting either read-only or full access rights to “Everyone.”