Acumen Camera IP Speed Dome Series AiPI34H03N2B User Manual

  20   
 
 
Preset Go   To
 have the camera move to a specified Preset position, please select the Preset Point from the drop -down Preset 
Point  list. Then the camera shall readily move to the target position.  
 
Chapter 3-6-2 PTZ Advanced Settings  3-
6-2.1 Lens Advance  
Lens Advance Setting Menu can be found under this path:  PTZ> PTZ Advance> Lens Advance 
In the Lens Advance Setup Menu, users can set various Lens  parameters including Focus, Focus 
Sensitivity, Digital Zoom, Zoom Speed and Focus...

  21   
3-
6-2.2 Pan -Tilt Setup  
Pan-Tilt Setting Menu can be found under this path:  PTZ> PTZ Advance> Pan-Tilt Setup  
In the Pan -Tilt Setup Menu, users can set various Pan-Tilt parameters including Home Position, 
Self Return Time, Self Return Mode and Auto Mode. Each setting is specified as follows: 
  Home Position  Specify home position for one of the presets.
  
Self Return Time  User Define if IP 
Speed Dome idles for a period of time,  the selected function will be activated automat ically....

  22  The IP Speed Dome Camera supports totally 
four Tour Path; each Tour Path consists of up to  32 
Preset Points. Please refer to the instructions below to program a Tour table.   
NOTE: Before setting this function, users must pre-define at least two Preset Points. 
  Tour Path Setting 

  Tour Path 
Please select the number of Tour Path to be set from the drop-down list in the top of the Tour Setup menu. 
   Sequential Preset Points Setting 
Please setup each Preset Point of the programmed Tour...

  23   
 
Chapter 3-7 SD Card Recording  To record video on  SD Card, please insert SD card into the SD card slot.    Enable SD card recording 
feature.    The IP camera can start to record video into the SD  card.  
 
Chapter  3-7-1. SD Card Recording Setting 
For SD card recording setting, please see the following for detail.   
 
 
To un -mount the SD card, please click  “un- mount SD Card ” button.    It might crash the file system of 
the SD card, if a user does not un -m ount the SD card properly....

  24   
 
Chapter 3-8  Alarm Settings 
H.264 D1 video server or IP PTZ camera ’s hardware alarm system contains motion detection, alarm 
sensors , and one  alarm/relay output.    Many alarm features such as motion/alarm email notification 
and F TP archiving can be found at this section.     
 
Chapter 3-8-1 Motion/Alarm Setup 
There are  motion detection zone s allowed in  the H.264 D1 video server or IP PTZ camera .    A user 
can enable the detection zones with different sensitivities ranging from  1...

  25   
 
Chapter 3-8-4 Audio Detection 
For audio model, the IP camera  has audio detector detecting acoustic level.    If the  volume exceeds 
the audio sensitivity value, audio detector triggers an alarm for notification.           
 
Chapter  3-9. Audio Setting 
Audio setting is based on the following:         MIC Volume: MIC or line input volume  
   Audio Input Mode: Choose MIC input or Line input.  
   Audio Input Gain:  Voice input gain magnification  
   Audio Output Volu me: Line output...

  26  Appendix  
Advance Network DDNS and PPPoE Technologies 
The advantage of using DDNS and PPPoE is to  save the cost of IP address.    H.264 AVC IP 
camera ’s PPPoE service gets a dynamic global IP address after system reboot.    This IP address 
may get changed periodically.    This is th e address needed to access the video server over Internet.   
When ISP re -assigns a new IP address to H.264 AVC IP  camera, H.264 AVC IP camera  notifies 
DDNS service.    A remote PC can access H.264 AVC IP...

  27   
 
 
 
 
 
 
 
 
Execute Live Cams Pro application. Please click on “Add Camera” button on your phone while using 
Live Cams Pro. Task bar gets prompted as below:   
Please selection one of the following drivers for cameras
: Profile 1: H.264 HD or D1 IP camera. 
 
 
 
 
 
 
 
 
 
 
 
Android Access:  
Please use your Android phone and select Android Market for downloading IP Cam Viewer/IP Cam 
Viewer Lite application developed by Robert Chou. 
 
Execute IP Cam Viewer/IP Cam Viewer Lite...

  28  “Add/Edit IP Camera” dialog box gets prompted for editing an IP camera or a DVR.
 
 
In “Add/Edit IP Camera” dialog box, please enter the following information:   
  1.  Name: Name of the IP camera or DVR’s camera 
2.  Category: Please select AI . 
3.  Type: Select device type,    AI D1 / AI  HD/  AI DVR. 
4.  IP Address: Please type IP address, for example  http://122.116.191.129:86  where 
86 is the  port number. 
5.  Provide username and password information. For IP camera, the default username...

  29  Specification
 
  Design and specification are subject to change without  further notice. 
  Network Function  
Video compression   H.264 ,  Motion JPEG  
Resolution   1080P(1920x1080),H264 480P(7
20 x 480), JPEG 480P (720 x 480), CIF(352 x 240)  
Frame rate   H.264 : 30 FPS at 1080P
(1920 x 1080 )  
Motio n JPEG : 30 FPS at D1(720 x 480 )  
Video streaming   RTP/HTTP, RTP/TCP, RTP/UDP  
Video bitrate   128Kbps ~  5 Mbps  
Frame rate and bitrate controllable on - the - fly  
VBR / CBR / GOP...