Acer X1160pzc Users Guide

29
EnglishReplacing the Lamp
Use a screwdriver to remove the screw(s) from the cover, and then pull out the 
lamp.
The projector will detect the lamp life. You will be shown a warning message 
Lamp is approaching the end of its useful life in full power operation. 
Replacement Suggested! When you see this message, change the lamp as soon 
as possible. Make sure the projector has been cooling down for at least 30 
minutes before changing the lamp.
Warning: The lamp compartment is hot! Allow it to cool...

30
English
Ceiling Mount Installation
If you wish to install the projector using a ceiling mount, please refer to the 
steps below:
1 Drill four holes into a solid, structurally sound part of the ceiling, and 
secure the mount base.
Note: Screws are not included. Please obtain the appropriate 
screws for your type of ceiling.
2 Secure the ceiling rod using the appropriate type of four-cylinder screws.
Ceiling Mount Base    - Attach to ceiling
Screw Type A50 mm length / 8 mm diameter -   
   
Long Rod...

31
English3 Use the appropriate number of screws for the projector size to attach the 
projector to the ceiling mount bracket.
Note: It is recommended that you keep a reasonable space 
between the bracket and the projector to allow for proper heat 
distribution. Use two washers for extra support, if deemed 
necessary.
4 Attach the ceiling bracket to the ceiling rod.
Screw Type B
Smaller Washer
Large Washer
Projector Bracket
Supports projector and allows -   
  for adjustments     
Spacer
    - For heat...

32
English
5 Adjust the angle and positioning as necessary.
Note:  The appropriate type of screw and washer for each model is 
listed in the table below. 3 mm diameter screws are enclosed in 
the screw pack.
Models Screw Type B Washer Type
Diameter (mm) Length (mm) Large Small
X1160/Z/ZC/P/PZ/
PZC, X1260/Z/ZC/P/
PZ/PZC/K/KC320VV
Tightening Screw
Allen Key
Allen Key
Tightening Screw
110.00 mm
82.30 mm
SCREW SPEC.  M3 x 20 mm
Downloaded From projector-manual.com Acer Manuals 

33
EnglishSpecifications
The specifications listed below are subject to change without notice. For final 
specs, please refer to Acers published marketing specifications.
Projection system
DLP®
Resolution X1160/Z/ZC/P/PZ/PZC:  Native: SVGA (800 x 600) , 
Maximum: SXGA (1280 x 1024), WXGA+ (1440 x 900)
X1260/Z/ZC/P/PZ/PZC/K/KC:  Native: XGA (1024 x 768), 
Maximum: SXGA+ (1400 x 1050), WXGA+ (1440 x 900)
Computer compatibility IBM PC and compatibles, Apple Macintosh, iMac and 
VESA standards: SXGA, XGA,...

34
English
* Design and specifications are subject to change without notice.
I/O connectors•Power socket x1
•VGA input x1
•Composite video x1
•S-Video x1
•USB x1: for remote computer control
Below items are for X1260/Z/ZC/P/PZ/PZC/K/KC series 
only:
•RS232 x 1•VGA output x 1
•3.5 mm audio jack input x 1
Standard package contents
•AC power cord x1
•VGA cable x1
•Composite video cable x1
•Remote control x1
•Battery x 1 (for remote control)
•Users guide (CD-ROM) x 1
•Quick start guide x 1
•Security card x...

35
EnglishCompatibility modes
A. VGA Analog 
1 VGA Analog - PC Signal
ModesResolutionV.Frequency [Hz]H.Frequency [KHz]
VGA640x4806031.5
640x4807237.9
640x4807537.5
640x4808543.3
720x4007031.5
720x4008537.9
SVGA800x6005635.1
800x6006037.9
800x6007248.1
800x6007546.9
800x6008553.7
832x6247549.7
XGA1024x7686048.4
1024x7687056.5
1024x7687560.0
1024x7688568.7
SXGA1152x8647063.8
1152x8647567.5
*1152x8648577.1
1280X10246064.0
*1280X10247277.0
*1280X10247580.0
QuadVGA1280x9606060.0
*1280x9607575.2...

36
English
2 VGA Analog - Extended Wide Timing
1024x7686048.4
1152x870 75 68.7
*1280x960 75 75.0
i Mac DV (G3) 1024x768 75 60.0
ModesResolutionV.Frequency [Hz]H.Frequency [KHz]
WXGA1280x7686047.8
1280x7687560.3
*1280x7688568.6
1280x7206044.8
1280x8006049.6
1440x9006059.9
Note: * X1260/Z/ZC/P/PZ/PZC/K/KC series
Downloaded From projector-manual.com Acer Manuals 

37
English
EnglishRegulations and safety notices
FCC notice
This device has been tested and found to comply with the limits for a Class B 
digital device pursuant to Part 15 of the FCC rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential 
installation. This device generates, uses, and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications....

38
English
Remarque à lintention des utilisateurs canadiens
Cet appareil numérique de la classe B est conforme a la norme NMB-003 du 
Canada.
Canada — Low-power license-exempt radio
communication devices (RSS-210)
a Common information
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference 
that may cause undesired operation of the device.
b Operation in 2.4 GHz band
To prevent radio...