Acer X1160pzc Users Guide

							29
EnglishReplacing the Lamp
Use a screwdriver to remove the screw(s) from the cover, and then pull out the 
lamp.
The projector will detect the lamp life. You will be shown a warning message 
Lamp is approaching the end of its useful life in full power operation. 
Replacement Suggested! When you see this message, change the lamp as soon 
as possible. Make sure the projector has been cooling down for at least 30 
minutes before changing the lamp.
Warning: The lamp compartment is hot! Allow it to cool down 
before changing the lamp.
To Change the Lamp
1 Turn off the projector by pressing the power button.
2 Allow the projector at least 30 mins to cool down.
3 Disconnect the power cord.
4 Use a screwdriver to remove the screw from the cover. (Illustration #1)
5 Push up and remove the cover.
6 Remove the two screws that secure the lamp module (Illustration #2) and 
pull up the lamp bar.(Illustration #3)
7 Pull out the lamp module by force. (Illustration #4) 
To replace the lamp module, reverse the previous step.
Warning: To reduce the risk of personal injury, do not drop the 
lamp module or touch the lamp bulb. The bulb may shatter and 
cause injury if it is dropped.
1
23
4
Downloaded From projector-manual.com Acer Manuals 
						

							30
English
Ceiling Mount Installation
If you wish to install the projector using a ceiling mount, please refer to the 
steps below:
1 Drill four holes into a solid, structurally sound part of the ceiling, and 
secure the mount base.
Note: Screws are not included. Please obtain the appropriate 
screws for your type of ceiling.
2 Secure the ceiling rod using the appropriate type of four-cylinder screws.
Ceiling Mount Base    - Attach to ceiling
Screw Type A50 mm length / 8 mm diameter -   
   
Long Rod
Extension Rod
Long Cylinder Cap
Allen Key
    - For tightening/looseniTightening Screw
Medium Rod Ceiling Mount Base
Downloaded From projector-manual.com Acer Manuals 
						

							31
English3 Use the appropriate number of screws for the projector size to attach the 
projector to the ceiling mount bracket.
Note: It is recommended that you keep a reasonable space 
between the bracket and the projector to allow for proper heat 
distribution. Use two washers for extra support, if deemed 
necessary.
4 Attach the ceiling bracket to the ceiling rod.
Screw Type B
Smaller Washer
Large Washer
Projector Bracket
Supports projector and allows -   
  for adjustments     
Spacer
    - For heat dissipation
Large cylinder cap
Tightening Screw Allen Key
    - For tightening/looseningScrew Type A50 mm length -   
  08 mm diameter     
Downloaded From projector-manual.com Acer Manuals 
						

							32
English
5 Adjust the angle and positioning as necessary.
Note:  The appropriate type of screw and washer for each model is 
listed in the table below. 3 mm diameter screws are enclosed in 
the screw pack.
Models Screw Type B Washer Type
Diameter (mm) Length (mm) Large Small
X1160/Z/ZC/P/PZ/
PZC, X1260/Z/ZC/P/
PZ/PZC/K/KC320VV
Tightening Screw
Allen Key
Allen Key
Tightening Screw
110.00 mm
82.30 mm
SCREW SPEC.  M3 x 20 mm
Downloaded From projector-manual.com Acer Manuals 
						

							33
EnglishSpecifications
The specifications listed below are subject to change without notice. For final 
specs, please refer to Acers published marketing specifications.
Projection system
DLP®
Resolution X1160/Z/ZC/P/PZ/PZC:  Native: SVGA (800 x 600) , 
Maximum: SXGA (1280 x 1024), WXGA+ (1440 x 900)
X1260/Z/ZC/P/PZ/PZC/K/KC:  Native: XGA (1024 x 768), 
Maximum: SXGA+ (1400 x 1050), WXGA+ (1440 x 900)
Computer compatibility IBM PC and compatibles, Apple Macintosh, iMac and 
VESA standards: SXGA, XGA, VGA, SVGA, SXGA+, 
WXGA, WXGA+
Video compatibility NTSC (3.58/4.43), PAL (B/D/G/H/I/M/N), SECAM (B/D/G/
K/K1/L), HDTV (720p, 1080i), EDTV (480p, 576p), SDTV 
(480i, 576i)
Aspect ratio 4:3 (native), 16:9
Displayable colors 16.7 million colors
Projection lens X1160/P: F/ 2.41, f = 21.79mm, Manual Focus
X1160Z/ZC/PZ/PZC, X1260/Z/ZC/P/PZ/PZC/K/KC: F/ 2.41 - 
2.55, f = 21.79 mm - 23.99 mm, 1.1X manual zoom lens
Projection screen size (diagonal) X1160/P: 25 (0.64 m) - 303 (7.70 m)
X1160Z/ZC/PZ/PZC, X1260/Z/ZC/P/PZ/PZC/K/KC: 
23 (0.58 m) - 303 (7.70 m)
Projection distance 3.3 (1.0 m) - 39.4 (12.0 m)
Throw ratio X1160/P: 50@2m (1.95:1)
X1160Z/ZC/PZ/PZC, X1260/Z/ZC/P/PZ/PZC/K/KC: 
50@2m (1.95 - 2.15:1)
Horizontal scan rate X1160/Z/ZC/P/PZ/PZC: 31k - 69 kHz
X1260/Z/ZC/P/PZ/PZC/K/KC: 31k - 80 kHz
Vertical refresh scan rate 50 - 85 Hz
Lamp type
X1160/Z/ZC, X1260/Z/ZC: 160 W user-replaceable lamp
X1160P/PZ/PZC, X1260P/PZ/PZC/K/KC: 180W user-
replaceable lamp
Keystone correction +/- 40 degrees
Audio Internal speaker with 2 W output  (X1260/Z/ZC/P/PZ/
PZC/K/KC series)
Weight 2.3 Kg (5 lbs.)
Dimensions (W x D x H) 267 mm x 187 mm x 80 mm (10.5 x 7.4 x 3.1)
Digital Zoom 2X
Power supply AC input 100 - 240 V auto-switching power supply
Power consumption X1160/Z/ZC, X1260/Z/ZC: 225W
X1160P/PZ/PZC, X1260P/PZ/PZC/K/KC: 250W
Operating temperature 5ºC to 35ºC / 41ºF to 95ºF
Downloaded From projector-manual.com Acer Manuals 
						

							34
English
* Design and specifications are subject to change without notice.
I/O connectors•Power socket x1
•VGA input x1
•Composite video x1
•S-Video x1
•USB x1: for remote computer control
Below items are for X1260/Z/ZC/P/PZ/PZC/K/KC series 
only:
•RS232 x 1•VGA output x 1
•3.5 mm audio jack input x 1
Standard package contents
•AC power cord x1
•VGA cable x1
•Composite video cable x1
•Remote control x1
•Battery x 1 (for remote control)
•Users guide (CD-ROM) x 1
•Quick start guide x 1
•Security card x 1
Below item is for X1160Z/ZC/PZ/PZC, X1260/Z/ZC/P/PZ/
PZC/K/KC series only:
•Carrying case x 1
Downloaded From projector-manual.com Acer Manuals 
						

							35
EnglishCompatibility modes
A. VGA Analog 
1 VGA Analog - PC Signal
ModesResolutionV.Frequency [Hz]H.Frequency [KHz]
VGA640x4806031.5
640x4807237.9
640x4807537.5
640x4808543.3
720x4007031.5
720x4008537.9
SVGA800x6005635.1
800x6006037.9
800x6007248.1
800x6007546.9
800x6008553.7
832x6247549.7
XGA1024x7686048.4
1024x7687056.5
1024x7687560.0
1024x7688568.7
SXGA1152x8647063.8
1152x8647567.5
*1152x8648577.1
1280X10246064.0
*1280X10247277.0
*1280X10247580.0
QuadVGA1280x9606060.0
*1280x9607575.2
SXGA+*1400x10506065.3
Power Mac G4 640x480 66.6(67) 34.9
800x6006037.9
1024x7686048.4
1152x870 75 68.7
*1280x960 75 75.0
PowerBook G4 640x480 60 31.4
640x480 66.6(67) 34.9
800x6006037.9
Note: * X1260/Z/ZC/P/PZ/PZC/K/KC series
Downloaded From projector-manual.com Acer Manuals 
						

							36
English
2 VGA Analog - Extended Wide Timing
1024x7686048.4
1152x870 75 68.7
*1280x960 75 75.0
i Mac DV (G3) 1024x768 75 60.0
ModesResolutionV.Frequency [Hz]H.Frequency [KHz]
WXGA1280x7686047.8
1280x7687560.3
*1280x7688568.6
1280x7206044.8
1280x8006049.6
1440x9006059.9
Note: * X1260/Z/ZC/P/PZ/PZC/K/KC series
Downloaded From projector-manual.com Acer Manuals 
						

							37
English
EnglishRegulations and safety notices
FCC notice
This device has been tested and found to comply with the limits for a Class B 
digital device pursuant to Part 15 of the FCC rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential 
installation. This device generates, uses, and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause 
harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular 
installation. If this device does cause harmful interference to radio or television 
reception, which can be determined by turning the device off and on, the 
user is encouraged to try to correct the interference by one or more of the 
following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the device and receiver.
•Connect the device into an outlet on a circuit different from that to which 
the receiver is connected.
•Consult the dealer or an experienced radio/television technician for help.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables 
to maintain compliance with FCC regulations.
Notice: Peripheral devices
Only peripherals (input/output devices, terminals, printers, etc.) certified to 
comply with the Class B limits may be attached to this equipment. Operation 
with non-certified peripherals is likely to result in interference to radio and TV 
reception.
Caution
Changes or modifications not expressly approved by the manufacturer could 
void the users authority, which is granted by the Federal Communications 
Commission, to operate this device.
Operation conditions
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) this device may not cause harmful interference, 
and (2) this device must accept any interference received, including interference 
that may cause undesired operation.
Notice: Canadian users
This Class B digital apparatus complies with Canadian ICES-003.
Downloaded From projector-manual.com Acer Manuals 
						

							38
English
Remarque à lintention des utilisateurs canadiens
Cet appareil numérique de la classe B est conforme a la norme NMB-003 du 
Canada.
Canada — Low-power license-exempt radio
communication devices (RSS-210)
a Common information
Operation is subject to the following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference 
that may cause undesired operation of the device.
b Operation in 2.4 GHz band
To prevent radio interference to the licensed service, this device is 
intended to be operated indoors and installation outdoors is subject 
to licensing.
Declaration of Conformity for EU countries
Acer hereby, declares that this projector series is in compliance with the 
essential requirements and other relevant provisions of Directive 1999/5/EC. 
(Please visit http://global.acer.com/support/certificate.htm
 for complete 
documents.)
Compliant with Russian regulatory certification
 Radio device regulatory notice
Note: The regulatory information below is for models with 
wireless LAN and/or Bluetooth only.
General
This product complies with the radio frequency and safety standards of any 
country or region in which it has been approved for wireless use. Depending on 
configurations, this product may or may not contain wireless radio devices (such 
as wireless LAN and/or Bluetooth modules). The below information is for 
products with such devices.
Downloaded From projector-manual.com Acer Manuals