Acer TravelMate 7720 7320 User Manual
Here you can view all the pages of manual Acer TravelMate 7720 7320 User Manual. The Acer manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 81
Chapter 371 2.Turn the base unit over, then remove the one screw (A) on the bottom side of the unit. 3.Carefully use a plastic screw driver to eject the optical drive tray. 4.Pull the optical drive module out from the main unit. StepSize (Quantity)ColorTo r q u e 1 M2.5 x L6 (1) Black 3.0 kgf-cm SG_Tangiz.book Page 71 Tuesday, July 10, 2007 11:01 AM
Page 82
72Chapter 3 5.Remove the two screws (K) securing the locker bracket and remove the locker bracket from the optical disk drive module. StepSize (Quantity)ColorTo r q u e 1~2 M2 x L3 (2) Black 1.6 kgf-cm SG_Tangiz.book Page 72 Tuesday, July 10, 2007 11:01 AM
Page 83
Chapter 373 Main Unit Disassembly Process Main Unit Disassembly Flowchart Removing the Modem Board 1.See “Removing the Battery Pack” on page 62. 2.See “Removing the Lower Cover” on page 64. Screw List ScrewPart No. A M2.5 x L6 86.00E33.736 C M2 x L4 86.9A552.4R0 D M2.5 x L5 86.00E74.335 H M2.5 x L8 86.00E34.738 J M2 x L4 86.00F24.724 MAIN UNIT KEYBOARD MAIN BOARD Cx4 MAIN UNIT DISASSEMBLY MIDDLE COVER LCD MODULE Hx2 Ax 2 UPPER CASE Ax 20 LEFT AND RIGHT SPEAKER MODULE Cx4 MODEM BOARD Cx2 Cx2 CPU/VGA...
Page 84
74Chapter 3 3.See “Removing the DIMM” on page 68. 4.See “Removing the WLAN Board Modules” on page 68. 5.Remove the 2 screws (C) securing the modem card. 6.Lift partially to detach the modem board from the main board. NOTE: The modem cable is still attached to the modem board. 7.Disconnect the modem cable from the modem board. Removing the Heatsink Fan Module 1.See “Removing the Battery Pack” on page 62. 2.See “Removing the Lower Cover” on page 64. StepSize (Quantity)ColorTo r q u e 1~2 M2 x L4 (2)...
Page 85
Chapter 375 3.Disconnect the heatsink fan connector from FAN1 on the main board. 4.Remove the two screws (C) securing the heatsink fan module. 5.Remove the heatsink fan module from the main board. Removing the CPU and VGA Heatsink Module 1.See “Removing the Battery Pack” on page 62. 2.See “Removing the Lower Cover” on page 64. StepSize (Quantity)ColorTo r q u e 1~2 M2 x L4 (2) Silver 1.6 kgf-cm SG_Tangiz.book Page 75 Tuesday, July 10, 2007 11:01 AM
Page 86
76Chapter 3 3.Remove the nine screws (C) securing the CPU and VGA heatsink module in place. a.For system without the discrete graphic card, there are only 5 screws holding the heatsink. 4.Slide out and remove the heatsink module. StepSize (Quantity)ColorTo r q u e 1~9 M2 x L4 (9) Silver 3.0 kgf-cm SG_Tangiz.book Page 76 Tuesday, July 10, 2007 11:01 AM
Page 87
Chapter 377 Removing the CPU 1.See “Removing the Battery Pack” on page 62.. 2.See “Removing the Lower Cover” on page 64.. 3.See “Removing the Heatsink Fan Module” on page 74. 4.See “Removing the CPU and VGA Heatsink Module” on page 75. 5.Using a flat screwdriver, turn the CPU socket latch counter-clockwise to release the CPU, then remove the CPU. NOTE: When installing the CPU, make sure to install the CPU with PIN 1 at the corner as shown. Removing the VGA board (for Discrete model only) 1.See...
Page 88
78Chapter 3 5.Remove the two screws (D) securing the VGA board. 6.Carefully remove the VGA board from the main board. Removing the Middle Cover and the Power Board 1.See “Removing the Battery Pack” on page 62. 2.Open the LCD screen all the way to facilitate the easy removal of the middle cover. 3.To remove the Middle Cover, carefully insert the plastic flat screwdriver under the side of the middle cover and gently pry up the middle cover. Continue prying on the other side until you could detach the...
Page 89
Chapter 379 4.Detach the cover and turn it over on the keyboard. 5.Disconnect the Power board cable from the main board and disconnect the Power board cable. SG_Tangiz.book Page 79 Tuesday, July 10, 2007 11:01 AM
Page 90
80Chapter 3 6.Remove the one screw (C) securing the Power board to the middle cover, and remove the Power board from the middle cover. Removing the Keyboard 1.See “Removing the Battery Pack” on page 62.. 2.See “Removing the Middle Cover and the Power Board” on page 78. 3.Release the top latches securing the keyboard in place. StepSize (Quantity)ColorTo r q u e 1 M2 x L4 (1) Silver 1.6 kgf-cm SG_Tangiz.book Page 80 Tuesday, July 10, 2007 11:01 AM