Acer Travelmate 4530 Service Guide

Chapter 391
4.Lift the Camera Module clear of the LCD Module and remove the single securing screw on the bracket.
StepSizeQuantityScrew Type
Camera Board M2*2.3 1 

92Chapter 3
Removing the LCD Panel
1.See “Removing the LCD Bezel” on page 88.
2.Lift the LCD Panel clear of the LCD Module, taking care to ensure the cables are free from the back cover. 

Chapter 393
Removing the LCD Brackets and FPC Cable
1.See “Removing the Battery Pack” on page 46.
2.See “Removing the Lower Covers” on page 49.
3.See “Removing the WLAN Module” on page 52.
4.See “Removing the Keyboard” on page 61.
5.See “Removing the LCD Panel” on page 92.
6.Turn the LCD panel over to expose the rear. Disconnect the cable from the LCD Panel using the tab provided.
7.Grip the FPC cable and lift upward to detach the adhesive pads.
8.Remove the eight securing screws (four on each side) from...

94Chapter 3 

Chapter 395
Removing the Antennas 
1.See “Removing the Battery Pack” on page 46.
2.See “Removing the Lower Covers” on page 49.
3.See “Removing the WLAN Module” on page 52.
4.See “Removing the LCD Panel” on page 92.
5.Remove the strips holding the antenna cables in place. Ensure the cables are free from obstructions.
6.Remove the tabs securing the left and right antennas to the LCD module. 
7.Remove the antenna cables and assembly from the LCD module. 

96Chapter 3
Removing the MIC Module
1.See “Removing the Battery Pack” on page 46.
2.See “Removing the Lower Covers” on page 49.
3.See “Removing the WLAN Module” on page 52.
4.See “Removing the LCD Panel” on page 92.
5.Remove the strips holding the MIC Module cable in place. Ensure the cable is free from obstructions.
6.Remove the MIC cable and Module from the LCD module. 

Chapter 397
LCD Module Reassembly Procedure
Replacing the LCD Panel
1.Align the LCD brackets with the eight screw holes (four on each side) on the LCD Panel as shown.
2. Secure the LCD brackets to the LCD panel.
3. Turn the panel over. Insert the LCD Panel cable into the LCD Panel as shown. 

98Chapter 3
4. Replace the MIC cable under the mylar tab strips, and replace the MIC as shown. Secure the cable by 
pressing down on the strips.
5. Replace the antenna cables and assembly.
6. Replace the tabs securing the left and right antennas to the LCD module. 
7. Replace the strips holding the antenna cables in place. Ensure the cables are free from obstructions. 

Chapter 399
8. Secure the cable by pressing down on the securing 
strip.9. Replace the two securing screws on the LCD 
Module.
10.Replace the camera board in the bracket.11 .Replace the securing screw on the camera board.
12.Replace the Camera Module in the bottom cover.13.Press the module in place and replace the securing 
screw on the Camera Module bracket. 

100Chapter 3
14.Connect the Camera Module cable as shown. 15. Connect the left and right Inverter board cables as 
shown.
16.Connect the left and right Inverter board cables as shown.
17.Press the inverter board in place to secure.