Acer Travelmate 350 Service Guide
Here you can view all the pages of manual Acer Travelmate 350 Service Guide. The Acer manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 81
Chapter 475 Device Address Conflict Run “Load Default Settings” in BIOS Setup Utility. RTC battery Main Board Allocation Error for device Run “Load Default Settings” in BIOS Setup Utility. RTC battery Main Board Failing Bits: nnnn DIMM BIOS ROM Main Board Fixed Disk n None Invalid System Configuration Data BIOS ROM Main Board I/O device IRQ conflict Run “Load Default Settings” in BIOS Setup Utility. RTC battery Main Board Operating system not found Enter Setup and see if fixed disk and drive A: are...
Page 82
76Chapter 4 Index of Symptom-to-FRU Error Message LCD-Related Symptoms Symptom / ErrorAction in Sequence LCD backlight doesnt work LCD is too dark LCD brightness cannot be adjusted LCD contrast cannot be adjustedEnter BIOS Utility to execute “Load Setup Default Settings”, then reboot system. Reconnect the LCD connectors. Keyboard (if contrast and brightness function key doesnt work). LCD inverter ID LCD cable LCD inverter LCD Main Board Unreadable LCD screen Missing pels in characters Abnormal screen...
Page 83
Chapter 477 PCMCIA/Smart Card-Related Symptoms Symptom / ErrorAction in Sequence System cannot detect the PC Card (PCMCIA) PCMCIA/Smart Card slot assembly Main Board System cannot detect the Smart Card Smart Card PCMCIA/Smart Card slot assembly Main Board PCMCIA/Smart Card slot pin is damaged. PCMCIA/Smart Card slot assembly Memory-Related Symptoms Symptom / ErrorAction in Sequence Memory count (size) appears different from actual size.Enter BIOS Setup Utility to execute “Load Default Settings, then...
Page 84
78Chapter 4 NOTE: If you cannot find a symptom or an error in this list and the problem remains, see “Undetermined Problems” on page 80. System hangs intermittently. See “Thermal and Fan Utility” on page 38. Reconnect hard disk/CD-ROM drives. Hard disk connection board Main Board Peripheral-Related Symptoms Symptom / ErrorAction in Sequence System configuration does not match the installed devices. Enter BIOS Setup Utility to execute “Load Default Settings”, then reboot system. Reconnect hard...
Page 85
Chapter 479 LAN-Related Symptoms Symptom / ErrorAction in Sequence Internal LAN does not work correctly. LAN board Main Board Wireless LAN-Related Symptoms Symptom / ErrorAction in Sequence Internal wireless LAN does not work correctly. right or left antenna kits wireless LAN board Main Board
Page 86
80Chapter 4 Intermittent Problems Intermittent system hang problems can be caused by a variety of reasons that have nothing to do with a hardware defect, such as: cosmic radiation, electrostatic discharge, or software errors. FRU replacement should be considered only when a recurring problem exists. When analyzing an intermittent problem, do the following: 1. Run the advanced diagnostic test for the main board in loop mode at least 10 times. 2. If no error is detected, do not replace any FRU. 3. If any...
Page 87
Chapter 481 Index of AFlash BIOS Error Message Index of PQA Diagnostic Error Code, Message Error MessageAction in Sequence Hardware Error See “System Diagnostic Diskette” on page 39 VPD Checksum Error Reboot the system and then restart with this diskette. BIOS Update Program Error Turn off the power and restart the system. System Error Make sure this AFlash BIOS diskette for this model. Without AC adapter make sure to connect AC adapter Battery Low make sure to install a highly charged battery, and...
Page 89
Chapter 583 To p Vi e w CN 1 DC-in port CN 17 Modem board connector CN 2 External monitor port K6 Mini PCI socket CN 3 LAN port CN 18 Touch PAD connector CN 4 Modem port CN 22 Hard disk drive connector CN 5 RJ45 connector CN 24 Internal MIC connector CN 6 Expansion port CN 26 Line-in jack/external MIC jack CN 7 LCD signal connector CN 25 Speaker/Headphone-out jack CN 8 2NT/speaker connector CN 23 Smart Card connector CN 9 USB daughter board connector CN 21 PCMCIA socket connector CN 10 Inverter...
Page 90
84Chapter 5 SW3 Switch Settings SW3-6: Check password SW3-6 = ON, Enable SW3-6 = OFF, Disable SW3-7: BIOS boot block erasable SW3-7 = OFF, Disable SW3-7 = ON, Enable SW3-4, SW3-5, SW3-8: Reserve SW3-1SW3-2SW3-3 English KBD ON ON ON Japan KBD OFF ON ON Europe KBD ON OFF ON