Acer TravelMate 240 250 User Manual

Chapter 362
2.See “Removing the Middle Cover” on page 56.
3.See “Removing the Launch Board” on page 56.
4.See “Removing the LCD Module” on page 57.
5.See “Removing the LCD Bezel” on page 59.
6.See “Removing the Inverter Board (15” LCD)” on page 59.
7.See “Removing the 15” TFT LCD” on page 60.
8.Remove the screw holding the right hinge, then remove the right hinge.
9.Remove the screw holding the left hinge, then remove the left hinge. 

63TravelMate 240/ 250
Disassembling the Main Unit
Removing the Keyboard
1.See “Removing the Battery” on page 52.
2.See “Removing the Middle Cover” on page 56.
3.To remove the keyboard, first pull out and upward to expose the keyboard.
 
4.Use a plastic tweezers or a plastic flat screwdriver to disconnect the keyboard cable from the main board 
carefully, then remove the keyboard from the main board.
Removing the RTC Battery
1.See “Removing the Battery” on page 52.
2.See “Removing the Middle Cover” on...

Chapter 364
 
Removing the Thermal Module
1.See “Removing the Battery” on page 52.
2.See “Removing the Middle Cover” on page 56.
3.See “Removing the LCD Module” on page 57.
4.See “Removing the RTC Battery” on page 63.
5.See “Removing the MimiPCI Card Plate” on page 63.
6.Disconnect the fan cable then remove the four screws fastening the thermal module.
7.Then remove the thermal module.
Removing the Processor
1.See “Removing the Battery” on page 52.
2.See “Removing the Middle Cover” on page 56.
3.See...

65TravelMate 240/ 250
Installing the Processor
1.See “Removing the Battery” on page 52.
2.See “Removing the Middle Cover” on page 56.
3.See “Removing the Keyboard” on page 63.
4.See “Removing the RTC Battery” on page 63.
5.See “Removing the MimiPCI Card Plate” on page 63.
6.See “Removing the Thermal Module” on page 64.
7.Lift up the CPU lever, then place the CPU back to the CPU socket. Please remember to press the CPU 
lever after you put the CPU back to the socket.
Removing the Upper Case Assemly 
1.See...

Chapter 366
4.Then take the upper case assembly off the main unit.
Removing the Touchpad Board
1.See “Removing the Battery” on page 52.
2.See “Removing the Middle Cover” on page 56.
3.See “Removing the Keyboard” on page 63.
4.See “Removing the Upper Case Assemly” on page 65.
5.To detach the touch pad board, first disconnect the touch pad cable from the touch pad board with a 
plastic tweezers.Then release the touchpad cover lock on the back as the picture shows.
6.Remove the touchpad cover, the remove...

67TravelMate 240/ 250
3.See “Removing the LCD Module” on page 57.
4.See “Removing the Keyboard” on page 63.
5.See “Removing the Upper Case Assemly” on page 65.
6.See “Removing the Touchpad Board” on page 66.
7.Remove the touchpad scroll key then remove the touchpad cable.
Removing the Floppy Disk Drive Module
1.See “Removing the Middle Cover” on page 56.
2.See “Removing the LCD Module” on page 57.
3.See “Removing the Keyboard” on page 63.
4.See “Removing the Upper Case Assemly” on page 65.
5.Disconnect...

Chapter 368
3.Remove another two screws holding the FDD bracket on the other side. Then take the FDD off the FDD 
bracket.
Removing the VGA Heatsink Plate
1.See “Removing the Battery” on page 52.
2.See “Removing the Middle Cover” on page 56.
3.See “Removing the Keyboard” on page 63.
4.See “Removing the Floppy Disk Drive Module” on page 67.
5.Remove the three screws that secure the VGA heatsink plate then remove the plate.
 
Removing the CPU Heatsink Plate
1.See “Removing the Battery” on page 52.
2.See...

69TravelMate 240/ 250
Removing the ODD Module(1)
1.See “Removing the Battery” on page 52.
2.Remove the screw that fastens the ODD bracket on the bottom. Push the ODD module at the point the 
red arrow indicates hard.Then remove the ODD module from the lower case.
NOTE: If you need to replace the ODD module only, you can remove the ODD module as the steps above.
Removing the ODD Module(2)
1.See “Removing the Battery” on page 52.
2.See “Removing the Middle Cover” on page 56.
3.See “Removing the Keyboard”...

Chapter 370
Removing the Main Board
1.See “Removing the Battery” on page 52.
2.See “Removing the Middle Cover” on page 56.
3.See “Removing the Keyboard” on page 63.
4.See “Removing the Floppy Disk Drive Module” on page 67.
5.See “Removing the VGA Heatsink Plate” on page 68.
6.See “Removing the CPU Heatsink Plate” on page 68.
7.See “Removing the ODD Module(1)” on page 69.
8.See “Removing the HDD Bracket” on page 69.
9.Disconnect the launch board cable. Tear off the tape that fastens the speaker set cable....

71TravelMate 240/ 250
7.See “Removing the ODD Module(1)” on page 69.
8.See “Removing the HDD Bracket” on page 69.
9.See “Removing the Main Board” on page 70.
10.Remove the two screws that fasten the DC board. Then detach the DC board from the lower case.
Removing the I/O Port Bracket
1.See “Removing the Battery” on page 52.
2.See “Removing the Middle Cover” on page 56.
3.See “Removing the Keyboard” on page 63.
4.See “Removing the Floppy Disk Drive Module” on page 67.
5.See “Removing the VGA Heatsink...