Acer Ferrari 1200 Service Guide

							Chapter 381
9.See “Removing the Middle Cover” on page 72.
10.See “Removing the LCD Module” on page 74.
11 .See “Separating the Upper Case from the Lower Case” on page 78.
12.Release the latch and disconnect the two cables from the button board.    
						

							82Chapter 3
13.Disconnect the fingerprint cable from the button board.  
						

							Chapter 383
14.Remove the two screws (B) securing the button board bracket and remove the button board bracket 
together with the button board.   
15.Remove the one screw (B) and remove the button board from the bracket.  
StepSize (Quantity)ColorTo r q u e
1~2 M2 x L3 (2) Black 1.6 kgf-cm 
						

							84Chapter 3
 
Removing the Fingerprint Board Module
1.See “Removing the Battery Pack” on page 64.
2.See “Removing the SD dummy card” on page 64.
3.See “Removing the ExpressCard dummy card” on page 65.
4.See “Removing the Lower Cover” on page 65.
5.See “Removing the DIMM” on page 66.
6.See “Removing the WLAN Board Modules” on page 67.
7.See “Removing the Hard Disk Drive Module” on page 68.
8.See “Removing the Keyboard” on page 71.
9.See “Removing the Middle Cover” on page 72.
10.See “Removing the LCD Module” on page 74.
11 .See “Separating the Upper Case from the Lower Case” on page 78.
12.See “Removing the Button Board” on page 80.
StepSize (Quantity)ColorTo r q u e
1 M2 x L3 (1) Black 1.6 kgf-cm 
						

							Chapter 385
13.Remove the adhesive tape. 
14.Remove the three screws (B) securing the fingerprint module to the upper case.  
15.Remove the fingerprint board module from the upper case. 
StepSize (Quantity)ColorTo r q u e
1~3 M2 x L3 (3) Black 1.6 kgf-cm 
						

							86Chapter 3
Removing theTouch Pad Board Module
1.See “Removing the Battery Pack” on page 64.
2.See “Removing the SD dummy card” on page 64.
3.See “Removing the ExpressCard dummy card” on page 65.
4.See “Removing the Lower Cover” on page 65.
5.See “Removing the DIMM” on page 66.
6.See “Removing the WLAN Board Modules” on page 67.
7.See “Removing the Hard Disk Drive Module” on page 68.
8.See “Removing the Keyboard” on page 71.
9.See “Removing the Middle Cover” on page 72.
10.See “Removing the LCD Module” on page 74.
11 .See “Separating the Upper Case from the Lower Case” on page 78.
12.See “Removing the Button Board” on page 80.
13.See “Removing the Fingerprint Board Module” on page 84.
14.Carefully pry loose and remove the touch pad board.  
WARNING:The touchpad board is glued to the upper case, only remove the touchpad board if it is defective. 
						

							Chapter 387
Removing the Optical Drive Module
1.See “Removing the Battery Pack” on page 64.
2.See “Removing the SD dummy card” on page 64.
3.See “Removing the ExpressCard dummy card” on page 65.
4.See “Removing the Lower Cover” on page 65.
5.See “Removing the DIMM” on page 66.
6.See “Removing the WLAN Board Modules” on page 67.
7.See “Removing the Hard Disk Drive Module” on page 68.
8.See “Removing the Keyboard” on page 71.
9.See “Removing the Middle Cover” on page 72.
10.See “Removing the LCD Module” on page 74.
11 .See “Separating the Upper Case from the Lower Case” on page 78.
12.Remove the two screws (F) securing the optical drive module.  
13.Carefully slide out and lift the optical drive module to remove it. 
StepSize (Quantity)ColorTo r q u e
1~2 M2 x L4 (2) Black 1.6 kgf-cm 
						

							88Chapter 3
14.Remove the one screw (G) securing the locker bracket and remove the locker bracket from the optical 
disk drive module.   
StepSize (Quantity)ColorTo r q u e
1 M2 x L2.5 (1) Black 1.6 kgf-cm 
						

							Chapter 389
Removing the Main Board
1.See “Removing the Battery Pack” on page 64.
2.See “Removing the SD dummy card” on page 64.
3.See “Removing the ExpressCard dummy card” on page 65.
4.See “Removing the Lower Cover” on page 65.
5.See “Removing the DIMM” on page 66.
6.See “Removing the WLAN Board Modules” on page 67.
7.See “Removing the Hard Disk Drive Module” on page 68.
8.See “Removing the Keyboard” on page 71.
9.See “Removing the Middle Cover” on page 72.
10.See “Removing the LCD Module” on page 74.
11 .See “Separating the Upper Case from the Lower Case” on page 78.
12.Disconnect the RTC battery cable from RTC1 on the main board. 
13.Disconnect the speaker cable from the SPKR1 on the main board.  
						

							90Chapter 3
14.Disconnect the bluetooth cable from the BLUE1 on the main board. 
15.Disconnect the modem cable from the MDCDK1 on the main board.
16.Disconnect the cable from the modem board.