Acer Aspire 8935G User Manual

Chapter 3141
4.Align the LCD brackets with the screw holes on the panel. Replace the eight screws (four on each side) in the 
brackets as shown.
5.Align the Camera Board with the locating pins on the LCD Module and place the board as shown.
6.Press down as shown to secure the board in place with adhesive.
7.Place the LCD Panel adjacent to the LCD Module as shown and connect the Camera cable to the Camera 
Module. 

142Chapter 3
8.Flip the LCD Panel over and place it in the LCD Module. 
IMPORTANT: Ensure that the LCD cable is not trapped under the panel.
9.Run the LVDS and Antenna cables through the hinge wells as shown.
10.Secure the LCD module with nine securing screws. 

Chapter 3143
NOTE: The six bracket screws are numbered from 1 to 3 on each bracket. Replace the screws in order from 1 to 3.
1 2 332
1 

144Chapter 3
Replacing the LCD Bezel
1.Place the LCD Bezel adjacent to the LCD Module as shown and connect the Microphone cable.
2.Flip the LCD Panel over and place it in the LCD Module.  

Chapter 3145
3.Press down around the perimeter of the bezel to secure it in place. 

146Chapter 3
Replacing the Flush LCD Bezel Cap
1.Place the Bezel Cap on to the LCD Module as shown.
2.Ensure that the LCD cables pass through the hinge wells as shown and pinch the hinge covers together to 
secure them in place. 

Chapter 3147
3.Press the Bezel Cap down as shown to secure it to the LCD Module.
4.Replace the two screws and screw caps. 

148Chapter 3
Main Module Reassembly Procedure
Replacing the CPU
IMPORTANT: The CPU has a Pin1 locator that must be positioned corresponding to the marker on the CPU 
socket.
1.Carefully turn the mainboard upside down (CPU side up), and place the CPU into the CPU socket as shown, 
taking note of the Pin1 locator.
2.Turn the securing screw 180° to secure the CPU in the socket. 

Chapter 3149
Replacing the Graphics Card
3.Insert the Graphics Card into the Mainboard connector.
4.Insert the single screw to secure the Graphics Card to the Mainboard.
StepSizeQuantityScrew Type
Graphics Card M2.5*6.5 1 

150Chapter 3
Replacing the Graphics Card Heatsink
IMPORTANT: Apply a suitable thermal grease and ensure all heat pads are in place before replacing the Thermal 
Module.
The following thermal grease types are approved for use:
•Silmore GP50
•Honeywell PCM45F-SP
•ShinEtsu 7762
The following thermal pads are approved for use:
• Eapus XR-PE
1.Remove all traces of thermal grease from the CPU using a lint-free cloth or cotton swab and Isopropyl Alcohol, 
Acetone, or other approved cleaning agent. 
2.Apply a...