Acer Aspire 7315 Service Guide

Chapter 381
 LCD Module Disassembly Process
LCD Module Disassembly Flowchart
Screw List
StepScrewQuantityPart No.
LCD Bezel M2.5*6 4 86.N2802.002
LCD Panel M2.5*6 2 86.N2802.002
LCD Brackets M2*3 6 86.N2802.006
Rem ove
LCD Panel
Rem ove
LCD Bezel
Rem ove
LCD FPC Cable
Remove LCD
Panel from  Main
Unit before
proceeding
Rem ove
LCD BracketsRem ove
Antennas
Rem ove
Camera Module 

82Chapter 3
Removing the LCD Bezel
1.See “Removing the LCD Module” on page 59.
2.Remove the two upper and two lower bezel screw caps and screws.
3. Starting from the bottom edge of the bezel, pry the bezel upwards and away from the panel. Work along the 
right side toward the top of the bezel, prying the covers apart. Continue along the top edge and down the left 
side to remove the bezel.
NOTE: If necessary, use a pry to lift up the outside edges of the bezel. 
StepSizeQuantityScrew Type
LCD Bezel...

Chapter 383
Removing the Camera Module
1.See “Removing the LCD Bezel” on page 82.
2.Locate the Camera Module at the top of the LCD Module and disconnect the camera cable.
3.Remove the Camera from the module. 

84Chapter 3
Removing the LCD Panel
1.See “Removing the Camera Module” on page 83.
2.Remove the two securing screws from the LCD Panel.
3.Remove the adhesive strip holding the cables in place.
4.Remove the Camera cable cluster from the LCD Module as shown.
StepSizeQuantityScrew Type
LCD Panel M2.5*6 2 

Chapter 385
5.Lift the LCD Panel clear of the module. 

86Chapter 3
Removing the LCD Brackets and FPC Cable
1.See “Removing the LCD Panel” on page 84.
2.Remove the six securing screws (three on each side) from the LCD Panel brackets.
3.Remove the LCD brackets by pulling away from the LCD Panel.
StepSizeQuantityScrew Type
LCD Brackets M2*3 6 

Chapter 387
4.Turn the LCD panel over to expose the rear. Lift the adhesive protector and disconnect the cable from the LCD 
Panel.
5.Lift the cable as shown to disengage the adhesive strip securing it in place.
6.Lift the FPC cable to disengage the remaining adhesive and remove the cable from the panel. 

88Chapter 3
Removing the Antennas 
1.See “Removing the LCD Panel” on page 84.
2.Remove the adhesive strips holding the left antenna cable in place. Ensure the cable is free from obstructions.
3.Remove the cable from the cable channel. Ensure that the cable is free from all cable clips and adhesive strips.
4.Remove the adhesive tape securing the left Antenna to the LCD Module. 

Chapter 389
5.Lift the left Antenna clear of the cover.
6.Remove the adhesive strips holding the right antenna cable in place. Ensure the cable is free from 
obstructions.
7.Remove the cable from the cable channel. Ensure that the cable is free from all cable clips and adhesive strips. 

90Chapter 3
8.Remove the adhesive tape securing the right Antenna to the LCD Module.
9.Lift the right Antenna clear of the cover.