Acer Aspire 6530 User Manual
Have a look at the manual Acer Aspire 6530 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 720 Acer manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Chapter 381 Removing the LCD Bezel 1.Remove the LCD module. See “Removing the LCD Module” on page 67. 2.Remove the four upper screw caps and screws, and the six remaining lower securing screws. 3.Lift up the bezel, topside first, and remove it from the LCD Module. StepSizeQuantityScrew Type LCD Bezel M2.5*6.5-I (BZN(NYLOK-RED)10
82Chapter 3 4.Turn the bezel and pry the left side upwards, followed by the right side. 5.After removing the top part of the bezel, grasp the bottom corners and continue lifting up the bezel as shown. 6.Lift the bezel away from the panel and lay it flat to expose the Mic cable.
Chapter 383 7.Disconnect the Mic cable and remove the LCD bezel.
84Chapter 3 Removing the Inverter Board 1.Remove the LCD Bezel. See “Removing the LCD Bezel” on page 81. 2.Disconnect both cables from the Inverter Board. NOTE: If you are having difficulty removing the cables, first lift the Inverter Board from the back cover before disconnecting the cables. 3. Remove the Inverter board from the LCD Module.
Chapter 385 Removing the Camera Module 1.Remove the LCD Bezel. See “Removing the LCD Bezel” on page 81. 2.Disconnect the Camera Module cable as shown. NOTE: If necessary lift the camera module to provide better access to the cables. 3.Place your finger on the ends of the module and pry it away from the cover.
86Chapter 3 Removing the LCD Panel 1.Remove the LCD Bezel. See “Removing the LCD Bezel” on page 81. 2.Remove the six securing screws from the LCD hinges. 3.Grasp the top of the LCD Panel and pivot upwards to a 90 degree angle. 4.Once the panel is upright, lift the panel upwards taking care of the cables located in the hinges. StepSizeQuantityScrew Type LCD Panel M2.5*2.5-I (NI)(NYLOK)6
Chapter 387 Removing the LCD Brackets and FPC Cable 1.Remove the LCD panel. See “Removing the LCD Panel” on page 86. 2.Dislodge the LCD cable from the left LCD hinge as shown in the following image. 3.Turn the LCD Panel over on a clean surface, and grip the LCD cable by both ends and pull it back. 4.Grip the adhesive strip and pull it back. 5.Continue to pull back the LCD cable.
88Chapter 3 6.Peel back the adhesive strip holding the cable to the bottom. 7.Remove the eight securing screws (four on each side) from the LCD Panel brackets. 8.Remove the LCD brackets by pulling them away from the LCD Panel. StepSizeQuantityScrew Type LCD Brackets M2.0*3.0-I (BKAG) (NYLOK) IRON8
Chapter 389 LCD Module Reassembly Procedure Replacing the LCD Panel 1.Align the LCD brackets with the eight screw holes (four on each side) on the LCD Panel as shown. 2.Secure the LCD brackets to the LCD panel. 3.Turn the panel over. Insert the LCD Panel cable into the LCD Panel as shown. Secure the cable by replacing the securing strip.
90Chapter 3 4.Replace the remaining securing strips and press down along the length of the cable to secure it in place ensuring the cable ends are in line with the edge of the panel. 5.Turn the LCD Panel over and re-insert the LCD cable into the hinge retainer. 6.Align the brackets with the alignment wells in the back panel and lower the LCD brackets into the bracket wells as shown.