Acer Aspire 6530 User Manual

Chapter 391
7.Pivot the LCD Panel down in place.
NOTE: Ensure the CMOS and Inverter cables are not under the LCD Panel and correctly aligned.
8.Replace the six screws to secure the panel within the LCD module.
9.Locate the alignment pins (2) and replace the 
Camera Board taking care the pins protrude 
through the sockets.10.Connect the Camera Module cable as shown. 

92Chapter 3
11 .Connect the right Inverter board cable as shown.12.Connect the left Inverter board cable as shown.
13.Replace the Inverter board as shown and press down to secure in place.
NOTE: Tuck the cables securely to prevent damage to the cables or module. 

Chapter 393
Replacing the LCD Bezel
1. Align the edge of the bezel with the bottom cover and reconnect the Mic Cable. 
2. Align the hinge covers taking care to tuck in all cabling, and lower the bezel down in place.
3.Continue to press the bezel down in place to lock the upper and lower covers in place.
  

94Chapter 3
4.Replace the ten securing screws and screw caps on the LCD bezel.
  

Chapter 395
Main Module Reassembly Procedure
Replacing the CPU
Replacing the Thermal Module
WARNING:To prevent damage to the Thermal Module or the CPU, hold the Thermal Module by both ends at 
the same time. 1.Carefully turn the mainboard upside down (CPU 
side up), and insert the CPU into the CPU bracket 
as shown.2.Using a flat-tipped screw driver, lock the CPU in 
the socket as shown.
1.Align and place the Thermal Module in the on the 
mainboard as shown.2.Replace the two securing screws (red) and...

96Chapter 3
3.Connect fan cable to the mainboard as shown. 

Chapter 397
Replacing the Mainboard
1.Ensure that the Mainboard is face up. Place the 
Mainboard in the chassis, left hand rear edge first.2.While holding the left side of the Lower Base, lower 
and pivot the mainboard in to the base.
3. Ensure the screw sockets and locating pin are aligned. Replace the three securing screws as shown.
NOTE: Make sure the I/O ports are positioned correctly through the lower cover, and the screw sockets are 
visible through the mainboard.
4.Reconnect the subwoofer cable to...

98Chapter 3
5.Replace the RJ-11 cable in the retaining clip on the mainboard and stick it in place using the adhesive strip.
6.Reconnect the Bluetooth and USB cables to the mainboard. 

Chapter 399
Replacing the Bluetooth Board
Replacing the Modem Module
1.Position the module over the aligning pins and 
insert in place.2.Replace the bluetooth cable as shown and replace 
the single securing screw.
1.Align the screw sockets and press the modem 
module down to connect to the mainboard.2.Replace the two securing screws.
3.Connect the modem cable as shown
. 

100Chapter 3
Replacing the USB Board
1.Replace the USB board on the lower base and secure with the single screw (provided).
2.Reconnect the USB cable as shown.
Replacing the Finger Print Reader
1.Replace the Finger Print Reader board in the upper cover and secure with the three screws as shown.