Acer Aspire 5732z Service Guide

Chapter 391
Removing the Antennas 
1.See “Removing the LCD Panel” on page 87.
2.Remove the adhesive strips holding the left antenna cable in place. Ensure the cable is free from obstructions.
3.Remove the cable from the cable channel. Ensure that the cable is free from all cable clips and adhesive strips.
4.Remove the adhesive tape securing the left Antenna to the LCD Module. 

92Chapter 3
5.Lift the left Antenna clear of the cover.
6.Remove the adhesive strips holding the right antenna cable in place. Ensure the cable is free from 
obstructions.
7.Remove the cable from the cable channel. Ensure that the cable is free from all cable clips and adhesive strips. 

Chapter 393
8.Remove the adhesive tape securing the right Antenna to the LCD Module.
9.Lift the right Antenna clear of the cover. 

94Chapter 3
LCD Module Reassembly Procedure
Replacing the Antennas
1.Replace the right Antenna as shown. Ensure that the locating pins on the Antenna are correctly seated. 
2.Replace the adhesive strip to secure the Antenna 
in place.3.Lay the cable down the side of the LCD Module 
using all available clips and adhesive.
4.Run the cable along the cable channel as shown, using all available cable clips.
Locating Pin
Locating Pin 

Chapter 395
5.Replace the left Antenna as shown. Ensure that the locating pins on the Antenna are correctly seated. 
6.Replace the adhesive strip to secure the Antenna 
in place.7.Run the cable down the side of the LCD Module 
using all available clips and adhesive.
8.Run the cable along the cable channel as shown, using all available cable clips and adhesive.
Locating PinLocating Pin 

96Chapter 3
9.The Antennas and cables appear as shown when correctly installed. 

Chapter 397
Replacing the LCD Panel
1.Connect the LCD cable to the panel connector as 
shown.2.Press down the adhesive strip to secure the cable 
in place.
3.Run the cable along the back of the panel and 
press down as indicated to secure the cable in 
place.4.Run the cable across the back of the panel as 
shown and press down as indicated to secure the 
cable in place.
IMPORTANT: Ensure that the LCD cable runs between the green callouts to avoid trapping when the panel is 
replaced in the LCD Module. 

98Chapter 3
5.Align the LCD brackets with the screw holes on the panel. Replace the six (6) screws (three on each side) in 
the brackets as shown.
6.Place the LCD Panel in the LCD Module, top edge first, and secure the LCD cable with adhesive tape.
IMPORTANT: Ensure that the LCD power cable passes through the hinge well and is not trapped under the 
panel. 

Chapter 399
Replacing the Camera Module
7.Replace the Camera cable cluster in the LCD 
Module.8.Secure the LCD module with the two securing 
screws.
1.Place the camera in the LCD Module.2.Connect the cable to the camera module. 

100Chapter 3
Replacing the LCD Bezel
1.Replace the bezel and press down until there are no gaps between the bezel and the LCD Module.
IMPORTANT: Ensure that the LCD cables pass through the hinge wells and are not trapped by the bezel.