Acer Aspire 5332 Service Guide

Chapter 3111
4.Replace the three (3) screw caps as shown.
5.Connect the following cables to the Mainboard.
AB
C
D 

11 2Chapter 3
6.Connect A as shown.7.Connect C as shown.
8.Connect B and close the locking latch to secure the cable in place.
9.Connect D and close the locking latch to secure the cable in place.
AC
B
D 

Chapter 311 3
Replacing the LCD Module
10.Turn the computer over and replace the eleven screws as shown.
1.Align the screw holes on the LCD Module and 
Upper Cover and replace the LCD Module.2.The left and right screw covers are shaped 
differently. Ensure that the correct cover is used.
3.Replace the left screw cover as shown. Ensure that the securing tab on the rear of the cover is seated 
correctly in the Upper Cover.
Left Screw
CoverRight Screw
Cover 

11 4Chapter 3
4.Replace the right screw cover as shown. Ensure that the securing tab on the rear of the cover is seated 
correctly in the Upper Cover.
5.Replace the four (4) screws securing the LCD Module to the Upper Cover.
6.Ensure that the Hinge Covers are replaced 
correctly. Identify the rear edge of the covers by the 
two securing clips.7.Align the left Hinge Cover as shown and press 
down to replace the cover.
8.Repeat the process for the right side Hinge Cover.
Rear Securing 
Clips 

Chapter 311 5
9.Run the black Antenna cable along the cable 
channel as shown using all available retaining 
clips.10.Replace the adhesive strip to secure the cable in 
place.
11 .Run the white Antenna cable along the cable channel as shown using all available retaining clips.
12.Run the LCD cable along the cable channel using 
all available cable clips.13.Connect the LCD cable to the Mainboard as 
shown. 

11 6Chapter 3
14.Stand the computer on the LCD Panel and pass the Antenna cables through the chassis.
15.The Upper Cover appears as shown when the Antenna and LCD cables are correctly installed.
16.Turn the computer over. Run the Antenna cables along the cable channel as shown, using all available 
cable clips. 

Chapter 311 7
17.Replace the two (2) screws securing the LCD Module to the Lower Cover. 

11 8Chapter 3
Replacing the Keyboard
1.Connect the Keyboard FFC to the Mainboard and close the locking latch to secure the cable in place.
2.Turn the Keyboard over and insert it front edge first 
into the chassis. 
NOTE: Ensure that the six locating tabs are 
correctly seated.3.Press down as indicated to secure the Keyboard in 
place. 

Chapter 311 9
Replacing the Switch Cover
Replacing the Hard Disk Drive Module
1.Place the Switch Cover left side first on to the Upper Cover.
2.Press down as indicated to snap the Switch Cover into place.
1.Place the HDD in the HDD carrier.2.Replace the four (4) screws (two each side) to 
secure the carrier. 

120Chapter 3
3.Insert the HDD, as indicated and lower it into 
place.4.Slide the HDD in the direction of the arrow to 
connect the interface.