Home > Acer > Notebook > Acer Aspire 3600 Service Guide

Acer Aspire 3600 Service Guide

Here you can view all the pages of manual Acer Aspire 3600 Service Guide. The Acer manuals for Notebook are available online for free. You can easily download all the documents as PDF.

Page 71

Chapter 465
46h 2-1-2-3 Check ROM copyright notice
48h Check video configuration against CMOS
49h Initialize PCI bus and devices
4Ah Initialize all video adapters in system
4Bh QuietBoot start (optional)
4Ch Shadow video BIOS ROM
4Eh Display BIOS copyright notice
50h Display CPU type and speed
51h Initialize EISA board
52h Test keyboard
54h Set key click if enabled
58h 2-2-3-1 Test for unexpected interrupts
59h Initialize POST display service
5Ah Display prompt “Press F2 to enter SETUP”
5Bh Disable CPU...

Page 72

66Chapter 4
8Ch Initialize floppy controller
8Fh Determine number of ATA drives (optional)
90h Initialize hard-disk controllers
91h Initialize local-bus hard-disk controllers
92h Jump to UserPatch2
93h Build MPTABLE for multi-processor boards
95h Install CD ROM for boot
96h Clear huge ES segment register
97h Fixup Multi Processor table
98h 1-2 Search for option ROMs. One long, two short 
beeps on checksum failure.
99h Check for SMART drive (optional)
9Ah Shadow option ROMs
9Ch Set up Power Management
9Dh...

Page 73

Chapter 467
D2h Unknown interrupt
CodeBeeps
E0h Initialize the chipset
E1h Initialize the bridge
E2h Initialize the CPU
E3h Initialize the system timer
E4h Initialize system I/O
E5h Check force recovery boot
E6h Checksum BIOS ROM
E7h Go to BIOS
E8h Set Huge Segment
E9h Initialize Multi Processor
EAh Initialize OEM special code
EBh Initialize PIC and DMA
ECh Initialize Memory type
EDh Initialize Memory size
EEh Shadow Boot Block
EFh System memory test
F0h Initialize interrupt vectors
F1h Initialize Run...

Page 74

68Chapter 4
Index of Symptom-to-FRU Error Message
LCD-Related Symptoms
Symptom / ErrorAction in Sequence
LCD backlight doesnt work
LCD is too dark
LCD brightness cannot be adjusted
LCD contrast cannot be adjustedEnter BIOS Utility to execute “Load Setup Default Settings”, then 
reboot system.
Reconnect the LCD connectors.
Keyboard (if contrast and brightness function key doesnt work).
LCD inverter ID
LCD cable
LCD inverter
LCD
System board
Unreadable LCD screen 
Missing pels in characters
Abnormal screen...

Page 75

Chapter 469
Battery can’t be charged See “Check the Battery Pack” on page 59. 
Battery pack
System board
PCMCIA-Related Symptoms
Symptom / ErrorAction in Sequence
System cannot detect the PC Card (PCMCIA)  PCMCIA slot assembly
System board
PCMCIA slot pin is damaged. PCMCIA slot assembly
Memory-Related Symptoms
Symptom / ErrorAction in Sequence
Memory count (size) appears different from 
actual size.Enter BIOS Setup Utility to execute “Load Default Settings, then 
reboot system.
DIMM
System board...

Page 76

70Chapter 4
NOTE: If you cannot find a symptom or an error in this list and the problem remains, see “Undetermined 
Problems” on page 72.
Battery fuel gauge in Windows doesn’t go higher 
than 90%. Remove battery pack and let it cool for 2 hours.
Refresh battery (continue use battery until power off, then charge 
battery).
Battery pack
System board
System hangs intermittently. Reconnect hard disk/CD-ROM drives. 
Hard disk connection board
System board
Peripheral-Related Symptoms
Symptom / ErrorAction in...

Page 77

Chapter 471
Intermittent Problems
Intermittent system hang problems can be caused by a variety of reasons that have nothing to do with a 
hardware defect, such as: cosmic radiation, electrostatic discharge, or software errors. FRU replacement 
should be considered only when a recurring problem exists.
When analyzing an intermittent problem, do the following:
1.Run the advanced diagnostic test for the system board in loop mode at least 10 times.
2.If no error is detected, do not replace any FRU.
3.If any...

Page 78

72Chapter 4
Undetermined Problems
The diagnostic problems does not identify which adapter or device failed, which installed devices are incorrect, 
whether a short circuit is suspected, or whether the system is inoperative.  
Follow these procedures to isolate the failing FRU (do not isolate non-defective FRU).
NOTE: Verify that all attached devices are supported by the computer.
NOTE: Verify that the power supply being used at the time of the failure is operating correctly. (See “Power 
System Check” on...

Page 79

Chapter 573
To p  V i e w
 
SW3 Power Switch SW1 Lid Swtich
JP1 Bluetooth Connector JP5 Touchpad Connector
SW2 E-mail Switch JP4 Keyboard Connector
SW4 Internet Browser Switch JP42 Speaker Connector
SW5 Emanager Switch JP7 PCMCIA Slot
SW6 User Programmable Switch JP10 Microphone Connector
2
JP1
2
JP42
JP5
2
KQ:
JP1022
JP42
2
JP7
2
2
SW1 SW2
SW3SW4
SW5
SW6
Jumper and Connector Locations
Chapter 5 

Page 80

74Chapter 5
Bottom View
JP21 Fan Connector JP24 USB Port
PJP11 Battery Connector JP25 USB Port
JP20 CPU Socket JP30 IEEE 1394 Port
JP16 LVDS Connector JP36 Card Reader Connector
JP22 VGA Board Connector IR Infrared Receiver
PCN1 AC-IN JP40 Headphone out/line-out Jack 
(support SPDIF)
JP13 USB Port JP41 Mic-in Jack
JP12 Reserved for Acer ezDock. No 
ezDock for this model.JP28 HDD Connector
JP14 Modem Board Connector JP35 Wireless LAN Card Connector
JP3 External Display Port U42 BIOS
JP17 S-Video Port JP26...
Start reading Acer Aspire 3600 Service Guide

Related Manuals for Acer Aspire 3600 Service Guide

All Acer manuals