Acer Aspire 1810t Service Guide
Have a look at the manual Acer Aspire 1810t Service Guide online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 720 Acer manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
Chapter 381 5.Roll the bezel up and away from the hinges.
82Chapter 3 Removing the Camera Board 1.See “Removing the LCD Bezel” on page 79. 2.Disconnect the camera connector. 3.Pull up the camera board.
Chapter 383 Removing the LCD Panel 1.See “Removing the Camera Board” on page 82. 2.Pull up the microphone. 3. Remove the two screws. Screw List StepScrewQuantityScrew Type LCD Panel Disassembly2x3 2
84Chapter 3 4.Lift the LCD panel out lifting the bottom of the panel first.
Chapter 385 Removing the LCD Brackets 1.See “Removing the LCD Panel” on page 83. 2.Remove the four LCD bracket screws. Screw List StepScrewQuantityScrew Type LCD Brackets DisassemblyM2*2.5 4
86Chapter 3 Removing the FPC Cable 1.See “Removing the LCD Panel” on page 83. 2.Place the panel face down on a clean smooth surface. Pull the microphone/camera cable off the adhesive. 3.Lift up the protective plastic tab. 4.Disconnect the LCD connector.
Chapter 387 Removing the Antennas 1.See “Removing the LCD Panel” on page 83. 2.Lift up the two foil flaps at the corners of the LCD module. 3.Lift up the foil of the left antenna. 4.Lift up the left antenna.
88Chapter 3 5.Pull the left antenna cable away from around the edges of the LCD module. 6.Lift up the foil of the right antenna.
Chapter 389 7.Lift up the right antenna. 8.Pull the right antenna cable away from the LCD module.
90Chapter 3 LCD Reassembly Procedure NOTE: Adhesive is required to be added at various steps to cables and components. Locations of adhesive to be added is designated with a: NOTE: During manufacture a cyanoacrylate glue is used provided by Holdtite Adhesives LTD. This is not a specified requirement. The reassembler is free to select an alternative appropriate adhesive. Replacing the Antennas 1.Stick the two antennas into position left and right, pressing down firmly. 2.Stick down the antenna foil pads.