Acer Aspire 1200 Service Guide
Here you can view all the pages of manual Acer Aspire 1200 Service Guide. The Acer manuals for Notebook are available online for free. You can easily download all the documents as PDF.
Page 81
Chapter 473 Index of Symptom-to-FRU Error Message LCD-Related Symptoms Symptom / ErrorAction in Sequence LCD backlight doesnt work LCD is too dark LCD brightness cannot be adjusted LCD contrast cannot be adjustedEnter BIOS Utility to execute “Load Setup Defaults” on Exit screen, then reboot system. Reconnect the LCD connectors. Keyboard (if contrast and brightness function key doesnt work). LCD inverter ID LCD cable LCD inverter LCD System board Unreadable LCD screen Missing pels in characters Abnormal...
Page 82
74Chapter 4 PCMCIA-Related Symptoms Symptom / ErrorAction in Sequence System cannot detect the PC Card (PCMCIA) PCMCIA slot assembly System board PCMCIA slot pin is damaged. PCMCIA slot assembly Memory-Related Symptoms Symptom / ErrorAction in Sequence Memory count (size) appears different from actual size.DIMM System board Speaker-Related Symptoms Symptom / ErrorAction in Sequence In Windows, multimedia programs, no sound comes from the computer. Audio driver Speaker System board Internal speakers...
Page 83
Chapter 475 NOTE: If you cannot find a symptom or an error in this list and the problem remains, see “Undetermined Problems” on page 77. Peripheral-Related Symptoms Symptom / ErrorAction in Sequence System configuration does not match the installed devices. Enter BIOS Setup Utility to execute “Load Setup defaults”, then reboot system. Reconnect hard disk/CD-ROM/diskette drives. External display does not work correctly. Press Fn+F5, LCD/CRT/Both display switching See “System Diagnostic Diskette” on...
Page 84
76Chapter 4 Intermittent Problems Intermittent system hang problems can be caused by a variety of reasons that have nothing to do with a hardware defect, such as: cosmic radiation, electrostatic discharge, or software errors. FRU replacement should be considered only when a recurring problem exists. When analyzing an intermittent problem, do the following: 1.Run the advanced diagnostic test for the system board in loop mode at least 10 times. 2.If no error is detected, do not replace any FRU. 3.If any...
Page 85
Chapter 477 Undetermined Problems The diagnostic problems does not identify which adapter or device failed, which installed devices are incorrect, whether a short circuit is suspected, or whether the system is inoperative. Follow these procedures to isolate the failing FRU (do not isolate non-defective FRU). NOTE: Verify that all attached devices are supported by the computer. NOTE: Verify that the power supply being used at the time of the failure is operating correctly. (See “Power System Check” on...
Page 86
78Chapter 4 Index of AFlash BIOS Error Message Error MessageAction in Sequence Hardware Error See “System Diagnostic Diskette” on page 45 VPD Checksum Error Reboot the system and then restest with this diskette. BIOS Update Program Error Turn off the power and restart the system. System Error Make sure this AFlash BIOS diskette for this model. Without AC adapter make sure to connect AC adapter Battery Low make sure to install a highly charged battery, and reboot system.
Page 87
Chapter 479 Index of PQA Diagnostic Error Code, Message Error CodeMessageAction in Sequence 16XXX Backup battery error Backup battery 01XXX CPU or main board error Reload BIOS default setting. System board 02XXX Memory error DIMM System board 03XXX Keyboard error Reset Keyboard Keyboard System board 04XXX Video error System board 05XXX Parallel Port error System board 06XXX Serial port or main board error System board 07XXX Diskette drive error Diskette drive System board 08XXX Hard disk error Reload...
Page 89
Chapter 581 To p V i e w PCB 01200-S SW2 POWER.-BTN JP2 LCD SW2 Power On/Off button JP1 It is software debug only, normally shiping on this connector JP2 LCD connector JP7 FDD connector SW1 LID switch JP6 Internal keyboard connector JP3 System Board connector JP4 Switch board connector PIN NOSignalPIN NOSignal 1. ON/OFF BTN# 2. ON/OFF BTN# 3. GND 4. GND PIN NOSignalPIN NOSignal 1. +5VALW 2. GND 3. +5VALW 4. GND 5. NC 6. NC 7. 20 INVT_PWN 8. DISPOFF# 9. +5VALW 10. LCDDVDD Jumper and Connector Locations...
Page 90
82Chapter 5 SW1 LID-SW JP3 HEADERX.PRT JP1 DEBUG-9.PRT 11. +5VALW 12. LCDVDD 13. +3VS 14. LCDDVGA 15. +3VS 16. LCDDVGA 17. GND 18. GND 19. NC 20. L LCD0 21. GND 22. L LCD1 23. PID0 24. GND 25. PID1 26. L LCD2 27. PID2 28. L LCD3 29. PID3 30. GDN 31. ENVDD 32. L LCD4 33. DISPOFF# 34. L LCD5 35. L LCD15 36. GDN 37. L LCD14 38. L LCD6 39. GND 40. L LCD7 41. L LCD13 42. GDN 43. L LCD12 44. L LCD8 45. GND 46. L LCD9 47. L LCD11 48. GDN 49. L LCD10 50. NC PIN NOSignalPIN NOSignal 1. GND 2. GND 3. LID_SW# 4....