A&D Balance FXi09 HRA09 User Manual

 
 
 
 
 
 
 
 
  
 
 
  
 
 
 
  
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
1WMPD4001369A  

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
    This is a hazard mark (caution mark). 
 
 
 
 
 
 
 
 © 2006 
No part of this publication may be reproduced, transmitted, transcribed, or 
translated into any language in any form by any means without the written 
permission of A&D Company Ltd. 
 
 
The contents of this manual and the specifications of the instrument 
covered by this manual are subject to change for improvement without 
notice.  

 1
Warning Definitions 
The warnings described in this manual have the following meanings: 
Caution 
A potentially hazardous situation which, if not avoided, may result in minor or moderate injury. 
It may also be used to alert against unsafe practices. 
Note 
An important description for proper use of the instrument. 
 
 
Precautions 
When handling the balance with the rechargeable battery unit installed, observe the 
following precautions. 
Caution 
  Do not place the unit in water, heat it, or...

 2
Introduction 
  The rechargeable battery unit (FXi-09, HRA-09) is exclusively designed for 
A&D-manufactured balances (of FX-i series, HR-A series). Using the battery unit, a balance 
can be operated in a location where an AC power source is not available.   
  The battery unit consists of a battery panel and a built-in rechargeable battery that have 
been installed inside the balance prior to delivery. 
  To install the battery unit into an balance that was not equipped with this option, contact...

 3
*1:  Operation time of the battery depends on operating conditions. 
*2: The FXi-02, FXi-08 and FXi-09 can not be used at the same time.   
In addition, the HRA-02, HRA-08 and HRA-09 can not be used at the same time. 
*3:  The battery unit is neither dust-tight nor waterproof. Therefore, upon installing the battery 
unit onto the FX-iWP and FZ-iWP series dust-tight and waterproof series, the balances will 
no longer comply with dust-tight and waterproof specifications. 
 
  Notes For The Battery Unit...

 4
Charging the Battery 
Note 
  Charging the battery before it is completely discharged will shorten the battery life.   
  Charge the battery fully until the CHARGE LED indicator goes out. This procedure will take about 
10 hours. 
  During the charging operation, the balance can not be used. 
 
 
Procedure: 
1.  Make sure that the battery is completely discharged 
before recharging. 
  How to determine when the battery is completely 
discharged:  
  When the power switch on the rear of the balance is...

 5
Using the Balance Powered by the Battery 
  Use the battery to supply power to the balance as follows: 
 
 
Procedure: 
1.  After charging is complete, disconnect the AC 
adapter from the balance. 
 
 
2.  Turn the power switch on the rear of the balance 
ON. The battery will start supplying power to the 
balance. 
 
 
3.  When the balance is not to be used, turn the power 
switch on the rear of the balance OFF. Under this 
condition, the battery is not used.   
Note 
  When the power switch is turned...

 6
Using the Balance Powered by the AC Adapter 
Use the AC adapter to supply power to the balance as follows: 
  The balance can be used powered by the AC adapter even if the battery is depleted. 
  While the balance is used powered by the AC adapter, the battery is not used and charging 
is not performed. 
 
 
Procedure: 
1.  Turn the power switch on the rear of the balance ON.   
Note 
  Be sure to turn the power switch ON. If the power 
switch is turned OFF and the AC adapter is connected 
to the...

 7
MEMO 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
  

 8
MEMO