3M Super Close Projection System SCP715/SCP740/SCP 717 Operators Guide

							
6 © 3M 2008.  All Rights Reserved.

Usage Notice  3M™ Super Close Projection System  
Important Note
 1.  
This product will detect the life of the lamp itself. Please be 
sure to change the lamp when it shows warning messages.
 2.   Reset the “Lamp Counter Reset” function from the On 
Screen Display “Management” menu after replacing the 
lamp module (refer to page 28).
 3.   When switching the projector off, please allow the projector 
to complete its cooling cycle before disconnecting the power.
 4.   
Turn on the projector first and then the signal sources.
 5.   When the lamp reaches the end of its life, it will burn out 
and may make a loud popping sound. If this happens, the 
projector will not turn back on until the lamp module has 
been replaced. To replace the lamp, follow the procedures 
listed under “Replacing the Lamp”. (see page 47) 
						

							
© 3M 2008.  All Rights Reserved.  7

3M™ Super Close Projection System Introduction
Product Features
3M Super Close Projection System SCP715/SCP717 
are XGA single chip 0.7” DLP® projectors and 3M Super 
Close Projection System SCP740 is a WXGA single chip 
0.65” DLP® projector. Outstanding features include:
   SCP715/SCP717 - True XGA, 1024 x 768 addressable 
pixels
  SCP740 - True WXGA, 1280 x 800 addressable pixels
 Texas Instruments Single chip DLP® Technology
 NTSC/NTSC4.43/PAL/PAL-M/PAL-N/SECAM and HDTV 
compatible (480i/p, 576i/p, 720p, 1080i/p)
 Multi-Auto functions: Auto detection, Automatic saving of 
user adjustments
 Full function IR remote control with mouse function
 User friendly multilingual on screen menu
 Advanced digital keystone correction and high quality full 
screen image re-scaling
 User friendly control panel
 Two built-in speakers with 2 Watt amplifier
 Multiple for Audio inputs
 Computer Compatibility: UXGA, SXGA+, SXGA 
compression and SVGA, VGA re-sizing
 Mac compatible
 DVI support (HDCP compliant)
 Support Network function (LAN/RS232) 
						

							
8 © 3M 2008.  All Rights Reserved.

Introduction  3M™ Super Close Projection System

US AC Power Cord
VGA Cable
Wireless Remote Controller
Projector
Package Overview
This projector comes with all the items shown below. 
Check to make sure your unit is complete. Contact your 
dealer immediately if anything is missing.
Documents : 
	Operator’s Guide
	Quick Start Card
	Product Safety Guide
	WEEE Card
2 x AA Batteries
UK AC Power Cord
EUR AC Power Cord3.5mm Audio Cable
USB Cable 
						

							
© 3M 2008.  All Rights Reserved.  9

3M™ Super Close Projection System Introduction

1. Control Panel
2.  Focus Ring
3.  Projection Lens
4.  Elevator Button
5.  Elevator Foot
6.  Power Socket
7.  Connection Ports
8.  IR Receivers
Main Unit
Product Overview
1
2
3
5
87
6
4 
						

							
10  © 3M 2008.  All Rights Reserved.

Introduction  3M™ Super Close Projection System

Control Panel
1. Four Directional Select Keys
2.  Keystone +/-
3.  Enter
4.  Menu (On/Off)
5.  Source Select
6.  Re-Sync
7.  Power/Standby
8.  Power/Standby LED 
9.  Lamp Indicator LED
10.  Temp Indicator LED
1246
23579
810 
						

							
© 3M 2008.  All Rights Reserved.  11

3M™ Super Close Projection System Introduction

Connection Ports
1. Power Socket
2.  5V-Relay Connector (Output: 5VDC, 2A 
)
3.  RS232 Connector
4.  Audio Input Connector
 (for S-Video or Composite)
5.  Audio Output Connector
6.  Audio Input Connector (for DVI-D or RGB1-In or RGB2-In)
7.  Kensington
TM Lock Port
8.  Networking Connector RJ45
9.  USB Connector (connect to PC for Remote Mouse function) 
10.  Composite Video Input Connector
11.  S-Video Input Connector
12.  Monitor Loop-through Output Connector
13.  RGB2-In Connector (PC Analog Signal/HD/Component 
Video Input)
14.  RGB1-In SCART Connector (PC Analog Signal/SCART 
RGB/HD/Component Video Input)
15.  DVI-D Input Connector (PC Digital/HDTV/HDCP Input)
1234567
89101112131415 
						

							
12  © 3M 2008.  All Rights Reserved.

Introduction  3M™ Super Close Projection System
Remote Control with Mouse Function
1. Power
2.  Mute
3.  Timer
4.  Display Format
5.  Mouse
6.  Mouse Right Click
7.  Page Up
8.  Page Down
9.  Four Directional Select 
Keys
10.  Re-Sync
11.  Enter
12.  S-Video Source
13.  Composite Video 
Source
14.  DVI Source
15.  Source Lock
16.  Blank
17.  Freeze
18.  Display Mode
19.  Mouse Left Click
20.  Zoom In
21.  Zoom Out
22.  Clear 
23.  Menu 
24.  VGA1 Source
25.  VGA2 Source
26.  Number Buttons
1
2
3
4
5
6
7
8
9
11
12
13
1415
16
17
18
19
20
21
22
24
25
26
23
10 
						

							
© 3M 2008.  All Rights Reserved.  13

3M™ Super Close Projection System Installation
Connecting the Projector
1.........................................................................\
...........................Power Cord2.........................................................................\
..............Audio Output Cable3..............................................................Network Cable (optional accessory)4.........................................................................\
............................USB Cable5................................................................RS232 Cable (optional accessory)6.........................................................................\
............................VGA Cable7..........................................................DVI to DVI Cable (optional accessory)8.........................................................Audio Input Cable (optional accessory)
Connect the Computer/Notebook
1
4
3
5
8
67
2
VGADVI
RS232
USB
5V Relay Output
Audio Output (For Active Speakers) 
						

							
14  © 3M 2008.  All Rights Reserved.

Installation  3M™ Super Close Projection System  

Connect the Video
1.........................................................................\
...........................Power Cord2.........................................................................\
..............Audio Output Cable3................................................Composite Video Cable (optional accessory)4.............................................................S-Video Cable  (optional accessory)5.........................................................Audio Input Cable (optional accessory)6...................VGA to 3 RCA Component/HDTV Adapter (optional accessory)7................................RCA Component Cable for YPbPr (optional accessory)8.........................................................................\
............................VGA Cable9....................................................HDMI to DVI Adapter (optional accessory)10................................................................HDMI Cable (optional accessory)
S-Video Output
Video Output
Audio Output (For Active Speakers)
DVD Player, Set-top Box, HDTV receiver
5V Relay Output
1
3
5
5
4
6
8
9
107
2 
						

							
© 3M 2008.  All Rights Reserved.  15

3M™ Super Close Projection System Installation

Powering On the Projector
1. Ensure that the power cord and signal cable are securely 
connected. The Power LED will turn red.
2.  Turn on the lamp by pressing “Power/Standby” button on the 
control panel. And the Power LED will turn blue.
3. Turn on your source (computer, notebook, video player, 
etc.). The projector should automatically detect your source 
within “Management” menu; check that “Input Source” has 
been set to “Auto Searching”.
	To access the built-in test pattern, please press the “Blank” 
button, then up arrow.
	If you connect multiple sources at the same time, use the 
“Source” button on the control panel or direct source key on 
remote control to switch.
Powering On/Off the Projector
Power/Standby
 •  Turn on the projector first and then the signal sources.
Test Pattern
1
1