3M Projector SPR1000 User Manual

							3M™ Streaming Projector SPR1000
© 2012 3M. All Rights Reserved.
 31
EnglishRemote Control
The 3M remote control controls the projector, the Roku Streaming Stick™, or any 
other MHL enabled device plugged into the projector.
Remove Protective Film
Before you can begin using the remote control, you must remove the protective film 
from the battery compartment. Remove the film as shown below.
Using the Remote
When using the remote control, point the remote control's infrared transmitter at the 
receiver on the projector. Sometimes you can control the projector by pointing the 
remote at the surface in front, beside, or above the projector. The remote control's 
range is up to 20 feet. 
Note: Sunlight and some indoor lighting may reduce the range of the remote 
control. 
						

							3M™ Streaming Projector SPR1000
 32 © 2012 3M. All Rights Reserved.
English
Replacing the Battery in the Remote Control
Replace the battery in the remote control with a CR2025 battery.
1 Remove the battery and 
battery tray by holding the 
latch toward the center 
of the tray and then pull 
the tray out of the remote 
control.
latch
2 Place the new battery into 
the tray and orientate the 
battery positive side (+) as 
indicated on the tray.
3 Finally, slide the tray into 
the remote control. 
						

							3M™ Streaming Projector SPR1000
© 2012 3M. All Rights Reserved.
 33
EnglishConnecting to other devices
The 3M Streaming Projector connects to other digital video devices such as tablets, 
computers, smartphones, and dvd players. Compatible device will most likely have one 
of the following video output connectors:
Description Connector on Device Cable Connector Example Devices
HDMI®
DVD Players, BluRay DVD 
Players, Game 
Consoles, Set-Top 
Boxes, Computers
Mini-HDMI
Portable Digital Media Players, 
Computers
Micro HDMI
Tablets and 
Smartphones
Micro USB (MHL)
Tablets and 
Smartphones
Display Port®
Computers 
						

							3M™ Streaming Projector SPR1000
 34 © 2012 3M. All Rights Reserved.
English
Notes:
1. Not all devices with a microUSB port are MHL enabled devices. Check the 
device's specification before purchasing a MHL cable. 
2. Some products have proprietary connectors not shown above (such as the 
dock connector on the Apple iPad or iPhone.) Check for digital video accessory 
adapters or cables from the manufacturer.
Connecting to the Projector
The HDMI/MHL port on the projector can accept a standard HDMI connector. Once 
you plug the cable into the port, you can close the cover.
1 Open Cover
DC in
2 Plug in HDMI cable
DC in 
						

							3M™ Streaming Projector SPR1000
© 2012 3M. All Rights Reserved.
 35
English3 Route the cable (1) 
and close the cover (2)
DC in
2
1
Connecting to a MHL Device
The 3M Streaming Projector supports MHL through the HDMI port. While playing video 
and audio from your MHL compatible device, the 3M Streaming Projector charges your 
device. Additionally, you can control your device using the projector's remote control. 
The standard MHL cable has a microUSB connector on one end and a HDMI connector 
on the other. 
1 Connect the HDMI end of cable to the projector’s HDMI/MHL input.
2 Connect the other end of the cable to the device’s microUSB port (MHL).  
						

							3M™ Streaming Projector SPR1000
 36 © 2012 3M. All Rights Reserved.
English
2
1
Notes: 
1. MHL cable not included. This cable is also known as a "passive MHL cable".
2. Please reference the device's user manual and specification for compatibility 
with MHL. 
						

							3M™ Streaming Projector SPR1000
© 2012 3M. All Rights Reserved.
 37
EnglishConnecting to a HDMI Video Device 
The 3M Streaming Projector can playback video and audio from a device with HDMI 
output. 
1 Connect one end of the HDMI cable to the projector’s HDMI/MHL input.
2 Connect the other end of the cable to the video device’s HDMI output.
VIDEO COAXIALOPTICALPCM/DTS/
DOLBY
DIGITALLINE OUT
COMPONENT VIDEO OUT
HDMI OUT DIGITAL
OUT
2
1
Notes: 
1. HDMI cable not included. 
2. Please reference the device's user manual and specification for compatibility 
with HDMI. 
						

							3M™ Streaming Projector SPR1000
 38 © 2012 3M. All Rights Reserved.
English
Connecting to a Display Port® Video Device 
The 3M Streaming Projector can play video and audio from your Display Port 
compatible device. You will need a Display Port to HDMI adapter or cable.
1 Connect the DisplayPort to HDMI adapter to the device. 
2 Connect one end of the HDMI cable to the projector’s HDMI/MHL input.
3 Connect the other end of the cable to the HDMI port on the adapter. 
3
1
2 
						

							3M™ Streaming Projector SPR1000
© 2012 3M. All Rights Reserved.
 39
EnglishNotes: 
1. The DisplayPort adapter and HDMI Cable are not included. 
2. Please reference the device's user manual and specification for compatibility 
with Display Port. 
						

							3M™ Streaming Projector SPR1000
 40 © 2012 3M. All Rights Reserved.
English
Menu
The projector's menu allows you to adjust the brightness, contrast, lamp power, and 
picture mode. The following section describes each setting and how to navigate the 
menu system. 
1
2
3
4
5
6
ItemMenu Item Description
1 Brightness Adjusts the dark levels of the image.
2 Contrast Adjusts the bright levels of the image.
3 Lamp Power Switches between standard and eco mode. Eco mode extends the 
battery life by reducing the power and brightness of the lamp.
 - Eco - Normal (Default)