3M Multimedia Projector Mp8760 Operators Manual

63M Multimedia Projector MP8760 3M IPC 2000
ENGLISH
3-5. Image Size (Projector-to-Screen Distance)
Adjust the size of the projected image using the zoom control buttons. The projected image size values, as they relate
to the distance-to-screen value, are shown for focal lengths of f=25mm and f=45mm. Also shown is the maximum
image height shift value that can vary depending on the focal length and the distance-to-screen.  Figure 3.4.
Maximum (f=25mm) Minimum (f=45mm)
Distance to Screen
m (ft.)Image...

 3M IPC 2000 3M Multimedia Projector MP8760 7
ENGLISH
 Section 4: Operating Instructions
4-1. Power Up Projector
Read the Important Safeguards before operating the MP8760 projector. After all cable connections have been
completed, the projector can be powered up. During operation, keep the exhaust and intake air vents clear of
obstructions to allow proper cooling.
!Caution
Allow a projector that has been stored in a cold place to warm up to room
temperature before applying power.
Figure 4-1. Power Up...

83M Multimedia Projector MP8760 3M IPC 2000
ENGLISH
4-2. Standby Mode
When the projector is not being used, place it into standby mode.
1. Press the Standby button.
2. The lamp will switch off and the red LED will illuminate.
!! ! !
 Note
The fan motor will continue to run for a few minutes until the projector
cools down and then the fan will turn off.
3. Press the Standby button again to illuminate the lamp and project an image on the screen.
4-3. Projector Power Down
1. Press the Standby button to...

 3M IPC 2000 3M Multimedia Projector MP8760 9
ENGLISH
Sub-Menu: Select the desired sub-menu (see Main Menu). Press the Disc Pad to the right or the Enter button to
display the sub-menu.
The sub-menu name (1) is on the top line.
A check box field 
 (2) at the right of a sub-menu
line indicates that you can toggle that value On/Off by
pressing the Enter button.
A slider bar (3) at the right of a sub-menu line
indicates you can increase or decrease the value.
A number field (4) at the right of a sub-menu...

10 3M Multimedia Projector MP8760 3M IPC 2000
ENGLISH4-5.  Menu Adjustments/Settings, continued
In active Video mode:
Picture (Video)
Submenu ItemsDescription / Action Default
Setting
Height
Adjust projected image height 
Brightness Adjust the brightness
Contrast Adjust the contrast
Color Adjust color saturation
Tint Adjust HUE for NTSC
Audio
Submenu ItemsDescription / Action Default
Setting
Volume Adjust volume
Audio Audio mute    -on / -off-on
Speaker Speakers    -on / -off-on
Balance Adjust balance...

 3M IPC 2000 3M Multimedia Projector MP8760 11
ENGLISH
4-5.  Menu Adjustments/Settings, continued
In active PC/RGB mode:
Advanced Setup
(PC/RGB)
Submenu ItemsDescription / Action Default
Setting
Projection
(drop down window)Select projection orientation
(standard / Rear / Rear/Ceiling /
Ceiling)standard
Color Manager Display Color Manager submenu
Remote Control Remote control receiver -on / -off-on
RC Address Select remote control address
(1 / 2 / 3 / 4)1
Sync Mode1
(drop down window)Select Sync Mode...

12 3M Multimedia Projector MP8760 3M IPC 2000
ENGLISH
4-5.  Menu Adjustments/Settings, continued
Color Manager
Submenu ItemsDescription / Action Default
Setting
Brightness red Adjust brightness for red portion
Contrast red Adjust contrast for red portion
Brightness green Adjust brightness for green portion
Contrast green Adjust contrast for green portion
Brightness blue Adjust brightness for blue portion
Contrast blue Adjust contrast for blue portion
Default Sets color settings to default values
Test...

 3M IPC 2000 3M Multimedia Projector MP8760 13
ENGLISH
 Section 5: Remote Control
5-1. Remote Control Functions
Aim the remote control toward the projection screen or at the sensor.  Press desired remote button to send a signal to
the projector.
An icon will display to indicate a presentation
tool is active.
Pointer Freeze
imageMouse Mute Magnify
imageReveal
image
! Note
The buttons marked with an asterisk (*) also appear on
the operator touch panel keypad.
ENTER
FOCUS ZOOM
PCMENUVIDEOAUX
123
456
789...

14 3M Multimedia Projector MP8760 3M IPC 2000
ENGLISH
5-2. Meaning Of The Icons
An icon will display to indicate a presentation tool is active.
Pointer mode
Activate with Pointer button on IR-Remote control
In the Pointer mode you can move a pointer over and arround the picture area.
By pressing the Pointer button on the remote control a second time it will be turned off.
Freeze mode
Activate with Freeze button on IR-Remote control
In the Freeze mode the picture will be freezed.
Pressing the Freeze...

 3M IPC 2000 3M Multimedia Projector MP8760 15
ENGLISH
5-2.  Meaning Of The Icons, continued
Question mark
A question mark in a box will appear if the projector can’t recognize
the mode of the data input source.
Even if you select a standard VESA mode on your system this can happen, because some device drivers of the graphic
cards in the PC using timing parameters which differ from the parameters given out from the VESA organization.
As a result of this, the projector may detects a wrong predefined...