Home > 3M > Projector > 3M Multimedia Projector Mp7740 Operators Manual

3M Multimedia Projector Mp7740 Operators Manual

Here you can view all the pages of manual 3M Multimedia Projector Mp7740 Operators Manual. The 3M manuals for Projector are available online for free. You can easily download all the documents as PDF.

Page 21

213M™ Multimedia Projector MP7640
© 3M IPC 2000
Cleaning the Air Filter
✔ Note: Clean the air filter about every 50 hours or if the message “CHECK AIR FLOW” is
displayed on the screen. If air is restricted due to dust accumulation on filter, the
projector may overheat and shut down automatically.
1. Turn off the MAIN POWER switch of the projector and pull out power cord. Let cool for
20 minutes.
2. Push tab up slightly and lift the air filter cover upward and outward to remove it.
3. Vacuum dust and dirt...

Page 22

3M™ Multimedia Projector MP764022© 3M IPC 2000
Section 6: Lamp
Lamp
The following symptoms may indicate that the lamp needs to be replaced:
• LAMP indicator lights up red.
• “CHANGE THE LAMP” message appears on the screen.
Display Lamp Operation Hours
To determine the lamp operation hours:
1. While the projector is running, press and hold the TIMER button on the remote control for three
seconds.
2. The operating time of the lamp will be displayed at the bottom of the screen.  The message
“CHANGE THE...

Page 23

233M™ Multimedia Projector MP7640
© 3M IPC 2000
Replacing the Lamp
WARNING
✔ Note: For maximum lamp life, do not shock, handle or scratch the lamp glass when it is
hot. Do not use an old or previously used lamp as a replacement lamp.
1.Remove lamp access door:  The lamp access door is located on the bottom of the machine. Use a
screwdriver to loosen the lamp access door retaining screw, gently remove the door, and set it
aside.
2. Use a screwdriver to loosen the lamp module retaining screw.
✔ Note: These...

Page 24

3M™ Multimedia Projector MP764024© 3M IPC 2000
Section 7: Troubleshooting
Symptom Cause Solution
Power cannot be•MAIN POWER switch is not turned on.•Turn the MAIN POWER switch on.
turned on.•The power cord is disconnected.•Insert the power cord into an AC socket.
•60 seconds have not elapsed since•Wait 60 seconds before turning on power.
the power was turned off.
No picture or sound.•The setting of the input source is not•Set the correct input using the input select button of
correct. the projector or...

Page 25

253M™ Multimedia Projector MP7640
© 3M IPC 2000
Section 7: Troubleshooting
Indicator Lights
R E W O P
r o t a c i d n I
t h g i LP M A L
t h g i L r o t a c i d n IP M E T
t h g i L r o t a c i d n Ig n i n a e M
e g n a r o s t h g i Lff o s n r u Tff o s n r u Tsu t a t s y b d n a t S
n e e r g s k n i l Bff o s n r u Tff o s n r u T.t i a W . p u g n i m r a W
. n e e r g s t h g i L.f f o s n r u T.f f o s n r u T.s u t a t s n o i t a r e p O
. e g n a r o s k n i l B.f f o s n r u T.f f o s n r u...

Page 26

3M™ Multimedia Projector MP764026© 3M IPC 2000
Section 7: Troubleshooting
Service Information
For product information, product assistance, service information, or to order accessories, please call:
• In U.S. or Canada:  1-800-328-1371
• In other locations, contact your local 3M sales office.
Section 8: Accessories
Accessories Part Number
UHB lamp module, 130 W 78-6969-9205-2
Power cord (US) DY-0205-1356-9
Power cord (UK) DY-0205-1355-1
Power cord (Germany) DY-0205-1354-4
VGA cable 78-8118-3401-5
MAC...

Page 27

273M™ Multimedia Projector MP7640
© 3M IPC 2000
Section 9: Appendix
Technical Specifications
Product name Liquid crystal projector
Model CP-S220W
Liquid Crystal Panel
Panel size 1.8 cm (0.7 type)
Drive System TFT active matrix
Pixels 485,616 pixels (604 horizontal x 804 vertical)
Lens Zoom lens F = 2.0 ~ 2.3  f = 18 ~ 21
Lamp 130W UHB
Speaker 0.7 W
Power supply AC100 ~ 120V, 2.0 A / AC220 ~ 240V, 0.9A
Power consumption 200 W
Temperature Range 0 ~ 35°C (32 ~ 95°F) operating
Size 289 mm (11.37 in.) W x 76...

Page 28

3M™ Multimedia Projector MP764028© 3M IPC 2000
Section 9: Appendix
Technical Specifications
LAMPTEMPPOWER
STANDBY/ON
INPUTMUTERESET
MENU
11.37 in.
289 mm
2.93 in.
74.5 mm 8.26 in.
210 mm
2.99 in.
76 mm
1.79 in.
45.6 mm 

Page 29

293M™ Multimedia Projector MP7640
© 3M IPC 2000
Section 9: Appendix
Connection to the Video Signal Terminal
a) Input signal
b) Signal input terminal
 Note: Video input signal terminals have priority in the following order:
1. S-VIDEO input terminal
2. RCA jack (composite) input terminal
Audio sound from input devices is output to the RGB/Video out jack.
l a n g i S O E D I V - Sl a n g i S e c n a n i m u L
l a n g i S e c n a n i m o r h Cn o i t a n i m r e t W 5 7 , p - p V 0 . 1
n o i t a n i m r e...

Page 30

3M™ Multimedia Projector MP764030© 3M IPC 2000
Section 9: Appendix
c) Example of computer signal
n o i t u l o s e R
V x H) z H k ( H f) z H ( V fg n i t a Rl a n g i S
e d o my a l p s i D
e d o m1 e t o N
0 5 3 x 0 4 69. 7 31. 5 8AS E V1- A G Vni m o o Z
0 0 4 x 0 4 69. 7 31. 5 8AS E V2- A G Vni m o o Z
0 0 4 x 0 2 79. 7 30. 5 8AS E VTX E Tni m o o Z
0 8 4 x 0 4 65. 1 39. 9 5AS E V3- A G Vni m o o Z
0 8 4 x 0 4 60. 5 37. 6 6 3 1 c a M
e d o mn i m o o ZN O 1 W S
N O 2 W S
0 8 4 x 0 4 69. 7 38. 2 7AS E...
Start reading 3M Multimedia Projector Mp7740 Operators Manual

Related Manuals for 3M Multimedia Projector Mp7740 Operators Manual

All 3M manuals