3M MP8020 Manual

193ME Multimedia Projector MP8020
W 1996
Retaining Screws: Use a standard screwdriver to
unscrew the lamp module retaining screws
(Figure 6-2).
Note
There are two lamp module screws that must
be loosened. These screws are
self-containing screws that cannot be
removed from the lamp module.
Screw Screw
Lamp
Module
Figure 6-2. Lamp Module Retaining Screws
Remove Lamp Module: Grasp the lamp module
with one hand and the projector body opening with
the other hand (Figure 6-3). Apply upward pressure
to the...

Figure 7-1. Cleaning the Lens
203ME Multimedia Projector MP8020
W 1996
Section 7: Maintenance
7-1. Cleaning
For best performance, keep your projector free of excess dust and surface dirt.
Daily Cleaning
Use a soft cloth to remove dust from the projector housing.
Cleaning the Projection Lens
Use 3MEOverhead Cleaner 676 to remove surface dirt and smudges from 
the projection lens (Figure 7-1).
Cleaning the Air Filter
For best performance, clean the air filter every 100 hours of operations.
Unplug the power...

213ME Multimedia Projector MP8020
W 1996
Insert the air cleaner in the door (Figure 7-5),
position the retaining frame over the air cleaner and
push the tabs down into the tab slots to hold the air
cleaner and frame to the door.
Tab Slot
Figure 7-5. Insert Frame and Air Cleaner
Insert the hinge tabs on the door into the slots in the
projector body and swing the door down.  Push on
the handle to fully engage the door latch and then
tighten the retaining screws to secure the door.
(Figure 7-6).
Note
The...

223ME Multimedia Projector MP8020
W 1996
Section 8: Troubleshooting
The MP8020 has been designed to be as simple and trouble-free to use as possible. If you should run into
problems operating the projector, please review the troubleshooting information below.
Problem
Possible Solutions
Power does not come onPower cord must be plugged into an electric outlet.
Power switch must be turned on.
No picture and sound
Set the projector to the correct input source.
Check all cable connections from input source to...

233ME Multimedia Projector MP8020
W 1996
Section 9: Technical Specifications
9-1. Specifications
Width 32 cm (12.59 inch)
Height 17 cm (6.66 inch)
Depth 46 cm (18.16 inch)
Weight 10.4 kg (23.2 lbs)
Panel size 3.3 cm (1.3 inches)
Number of pixels 311,696 pixels (H644 X V484)
Zoom lens F/Number: F/3.0±F/3.8 
Focal Length: F=46.5-74.4 mm
Metal halide lamp 250W, 300 lumens, rated at 700 hours
Power supply 100-120VAC, 50/60Hz
198-264VAC, 50/60Hz
Power consumption Maximum 350W
Storage temperature range ±205C...

243ME Multimedia Projector MP8020
W 1996
9-3. Physical Dimensions
 The MP8020 projector has the following physical dimensions:
232 mm
 (9  in.)115 mm
 (4.6  in.)
432 mm
 (17.3  in.) 30 mm
 (1.2  in.)26 mm
 (1  in.)
195 mm
 (7.8  in.) 12 mm
 (.48  in.)308 mm
 (12.3  in.)
90 mm
 (3.6  in.)
169 mm
 (6.7  in.)
387 mm
 (15.4  in.)
193 mm
 (7.7  in.)211 mm
 (8.4  in.) 165 mm
 (6.6  in.) 196 mm
 (7.8  in.)135 mm
 (5.4  in.)
9-4. Computer Video (RGB) Input Signal
The following table lists the ranges for the...

253ME Multimedia Projector MP8020
W 1996
9-5. Computer Video (RGB) Input Terminal
The following illustration (Figure 9-1) shows the terminal connections for the D-sub 15 pin HD connector.
Refer to the table below for a description of the wire to pin connections.
1
6
11
15 10
Figure 9-1. D-sub 15 pin HD Connector
Pin #DescriptionPin #Description
1Video signal (red)9N.O.
2Video signal (green)10Ground
3Video signal (blue)11Ground
4N.O.12N.O.
5Ground13Horizontal/composite sync sig-
nal
6Ground...

263ME Multimedia Projector MP8020
W 1996
Section 10: Accessories
10-1. MP8020 Multimedia Projector  Accessories
If you wish to purchase accessories or replacement parts for the 3M MP8020 Multimedia Projector, please
refer to the following list:
Accessory Parts List
Part DescriptionPart Number
Metal Halide Lamp Module, 250W 78-6969-8131-1
Power Cord 26-1009-7103-0
VGA Cable (15±15 pin M/M) 26-1011-3421-6
Apple MAC II Video Adaptor Cable (15-15 pin F/M) 26-1011-3422-4
Video Cable (S-Video mini DIN-4pin)...