1991 1999 ford explorer chilton User Manual

Always follow any instruction labels on the vehicle, especially if they differ from another source
It is very important to be careful about running the engine, on vehicles equipped with limited slip differentials,
while the vehicle is up on a jack. This is because if the drive train is engaged, power is transmitted to the
wheel with the best traction and the vehicle will drive off the jack, resulting in possible damage or injury.
Lift the front by positioning the jack under the lower front shock absorber...

Always safely support the vehicle on jackstands, either under the suspension member or the
frame
Jack the truck from under the axles, radius arms, or spring hangers and the frame. Be sure and block the
diagonally opposite wheel to prevent the vehicle from moving. Place jackstands under the vehicle at the points
mentioned above when you are going to work under the vehicle.
Lift the rear by positioning the jack under the rear spring mount on the axle HOW TO USE THIS BOOK
JACKING 161 

The jackstand can be positioned under the spring-to-frame mount
CAUTION
On models equipped with an under chassis mounted spare tire, remove the tire, wheel or tire carrier from the
vehicle before it is placed in a high lift position in order to avoid sudden weight release from the chassis.
When raising the vehicle on a hoist, position the front end adapters under the center of the lower suspension
arm or the spring supports as near to the wheels as practical. The rear hoist adapters should be placed...

SPECIFICATION CHARTS
Standard and Metric Conversion Factors ChartClick to enlarge
SPECIFICATION CHARTS 163 

Vehicle Indentification Chart
Click to enlarge
HOW TO USE THIS BOOK
164 SPECIFICATION CHARTS 

Engine Identification
Click to enlarge
HOW TO USE THIS BOOK
SPECIFICATION CHARTS 165 

General Engine Specifications
Click to enlarge
HOW TO USE THIS BOOK
166 SPECIFICATION CHARTS 

CAPACITIES
Click to enlarge
HOW TO USE THIS BOOK
SPECIFICATION CHARTS 167 

MANUFACTURER RECOMMENDEDMAINTENANCE INTERVALS
Click to enlarge
MANUFACTURER RECOMMENDEDSEVERE MAINTENANCE INTERVALS Click to enlarge
Chilton® Automotive Information Systems. © 2004 Thomson Delmar Learning. HOW TO USE THIS BOOK
168 SPECIFICATION CHARTS 

DISTRIBUTOR IGNITION SYSTEM
General Information
Only the 1991-92 2.9L and the 1991-94 3.0L engines are equipped with the distributor ignition system. The
distributor ignition system consists of the following components:
Ignition Control Module (ICM)
· 
Distributor
· 
Camshaft Position (CMP) sensor
· 
Ignition coil
· 
The distributor ignition system designed by Ford has two distinct configurations. The first configuration is
known as the distributor mounted system, because the ICM is mounted directly on...