3.If your antenna has a support boom, align its support straps
and mast clamp with the main boom’s support strap holes
and mast clamp. Attach the support straps to the main boom
using the supplied 1
1/2-inch screws and large wing nuts.
4. Press the supplied large end plugs into the main boom and
cradle boom.
5. Pull the two halves of the UHF dipole away from the main
boom until they lock into place. Then place each half’s un-
attached end over one of the antenna’s lead-in terminals
(one for each half of...
Model Number:HD-1850
General:
Channels2 - 69Electronic Elements84Output Impedance 300 ohms
Physical:
Boom Length 180Maximum Width 112Vertical Height 38Turning Radius 102Element Diameter .375Shipping Weight 16.0Carton Dimensions 7 x 9 x 98
Performance:
1Gain (dB) VHF Low Band6.2VHF High Band10.7UHF Band10.0
2Half-Power Beamwidth (deg.) VHF Low Band65.0VHF High Band34.0UHF Band37.5
3Front-To-Back Ratio (dB) VHF Low Band20.2VHF High Band17.3UHF Band13.7
1: Over Half-Wave Tuned Dipole (Ch. 2 -...
Model Number:HD-850
General:
Channels2 - 69Electronic Elements36Output Impedance 300 ohms
Physical:
Boom Length 85Maximum Width 111Vertical Height 24Turning Radius 64Element Diameter .375Shipping Weight 9.0Carton Dimensions 6.5 x 6.75 x 101
Performance:
1Gain (dB) VHF Low Band3.3VHF High Band6.9UHF Band7.7
2Half-Power Beamwidth (deg.) VHF Low Band72.0VHF High Band36.0UHF Band40.0 3Front-To-Back Ratio (dB) VHF Low Band11.0VHF High Band13.0UHF Band12.0
1: Over Half-Wave Tuned Dipole (Ch. 2 -...
WARNING: INSTALLATION OF
THIS PRODUCT NEAR POWERLINES
IS DANGEROUS. FOR YOUR SAFETY,
FOLLOW THE INSTALLATION
DIRECTIONS.
Before Installation Note: to CATV SYSTEM INSTALLER—Article 820-40 of the NEC specified that the cable ground shall be connected to the grounding system of the building “as close to the point of cable entry as practical”.
Note: Do not plug your Mini-State power supply into an AC outlet or DC power source until all electrical and antenna connections have been made. Doing so may...
Mounting Your Antenna
Install your antenna on the supplied mast using hand tools
and the following items available at your local electronics
or hardware store.
► 75-ohm coaxial cable (RG/6 recommended)
► Connection sealant tape or weather boot
Pre-Installation Test
Before installing your antenna, connect the power injec-
tor to the antenna and TV, and plug in the AC adapter as
described in “Connecting Your Antenna”. Place the an-
tenna away from trees or obstructions and face...
General
Engineering Specification Sheet
Channels/Frequency:2 - 69
Output Impedance (ohms):75
PhysicalLength (in):4 (6.5 incl. mast mount)
Maximum Width (in):20
Vertical Height (in):18
Turning Radius (in):10.5
Shipping Weight (lbs.):10.0
Carton Dimensions (in):23 x 22 x 8
Antenna Performance
Average Gain Over Reference Dipole (dB):
Low Band:-20.0
High Band:-6.6
UHF Band:6.4
Half-Power Beamwidth (deg.):
Low Band:NA
High Band:NA
UHF Band:60
Front-To-Back Ratio (dB):
Low Band:NA
High Band:NA
UHF Band:17.0...
3. Screw the cable’s F-connector onto the matching transformer. Then slip
the weatherboot over the connection. Note: If you use a cable without a
weatherboot, cover the connection with weatherproof tape.
UNFOLDING THE ANTENNA ELEMENTS
1. Hold each wing boom and turn its elements until they snap squarely into
place (perpendicular to the boom).
2. Press the supplied small end plugs into the ends of the wing booms.
3. Fold out the wing booms and secure them into position with...
Model Number:MXU-47
General:
Channels14 - 69Electronic Elements47Output Impedance 300 ohms
Physical:
Boom Length 80Maximum Width 20Vertical Height 32Turning Radius 52.5Element Diameter .375Shipping Weight 6.0 lbs.Carton Dimensions 6.25 x 6.25 x 81
Performance:
1Gain (dB) VHF Low BandN/AVHF High BandN/AUHF Band10.1
2Half-Power Beamwidth (deg.) VHF Low BandN/AVHF High BandN/AUHF Band33.0
3Front-To-Back Ratio (dB) VHF Low BandN/AVHF High BandN/AUHF Band16.1
1: Over Half-Wave Tuned Dipole (Ch. 14 -...
Model Number:MXU-59
General:
Channels14 - 69Electronic Elements59Output Impedance 300 ohms
Physical:
Boom Length 100Maximum Width 20Vertical Height 38Turning Radius 66Element Diameter .375Shipping Weight 7.0 lbs.Carton Dimensions 6.25 x 6.25 x 101
Performance:
1Gain (dB) VHF Low BandN/AVHF High BandN/AUHF Band10.7
2Half-Power Beamwidth (deg.) VHF Low BandN/AVHF High BandN/AUHF Band32.4
3Front-To-Back Ratio (dB) VHF Low BandN/AVHF High BandN/AUHF Band17.0
1: Over Half-Wave Tuned Dipole (Ch. 14 -...
BEFORE YOU BEGIN
Your antenna has elements which are resonant in the 30-54 MHz,
108-174 MHz, 450-470 MHz, 470-512 MHz, and 800-912 MHz
bands. They work together to give you frequency coverage from
30 MHz to 1300 MHz. Before you begin assembly, read this manual
and the Consumer Product Safety Commission information. For
your safety and convenience, plan each step of the installation
and purchase the necessary hardware in advance. The order in
which you perform the steps and the hardware required depends...
This outdoor VHF/UHF antenna covers from 108 to 1300
MHz. It uses three vertical radiators and three horizontal
radials, all stainless steel, with a chrome-plated brass ra-
diator assembly for efficient reception and lasting service.
WARNING: INSTALLATION OF THIS PRODUCT
NEAR POWER LINES IS DANGEROUS. FOR
YOUR SAFETY, FOLLOW THE INSTALLATION
DIRECTIONS.
If any metal antenna part touches a power line,
it completes a circuit path through anyone
touching the antenna. Power...
BEFORE YOU BEGIN
Read this manual and the separate Consumer Product Safety
Committee “Safety Instructions”.
WARNING: When you start to install an antenna,
use extreme caution. If the antenna starts to fall, let it
go! It could contact overhead power lines. IF the an-
tenna touches the power line, contact with the antenna,
mast, cable, or guy wires can cause electrocution and
death. Call the power company to remove the antenna.
DO NOT attempt to remove it yourself.
For...
U8000 U4000 U2000
8-Bay UHF Antenna 4-Bay UHF Antenna 2-Bay UHF Antenna
BEFORE YOU BEGIN
Read this manual and separate Consumer Product Safety
Commission information. For your safety and convenience,
plan each step of the installation and purchase the nec-
essary hardware in advance. The order in which you
perform the steps and the...
Model Number: U-2000
General:
Channels14 - 69
Electronic Elements9
Output Impedance 300 ohms
Physical:
Boom Length 20
Maximum Width20 25
Engineering Specifications
U-2000.xls Rev. 8-1-2007
Maximum Width 20.25Vertical Height 21
Turning Radius 10.5
Element Diameter .375
Shipping Weight 3.0 lbs.
Carton Dimensions 21.5 x 5.75 x 20.625
Performance:
1Gain (dB) VHF Low BandN/AVHF High BandN/A
UHF Band6.7
2Half-Power Beamwidth (deg.) VHF Low BandN/AVHF High BandN/A
UHF Band54.6
Front-To-Back Ratio (dB)...
