Warning:Read all warning messages and instructions
before starting installation of this fan. Failure to follow
these safety instructions can result in injury or even
death. If you need assistance in understanding these
instructions or have questions or comments, please
call 1 (309) 692-6969. This is a toll-free call.
ELECTRICAL HAZARDS
Danger:The electrical installation and wiring of this fan
must be done by a qualified electrician in accordance
with all local codes and standards, including...
POWERCOOL
POWER ATTIC VENTILATORS
INSTALLATION INSTRUCTIONS / WARRANTY
ª
Warning:Read all warning messages and instructions
before starting installation of this fan. Failure to follow
these safety instructions can result in injury or even death.
If you need assistance in understanding these instructions
or have questions or comments, please call
1 (309) 692-6969.
ELECTRICAL HAZARDS
Danger:The electrical installation and wiring of this fan
must be done by a qualified electrician in accordance
with...
© Copyright 2014 Air Vent, Inc. Radiant Skylight Tube C01 ver 3
Static Roof Vents
1.) POSITIONING THE VENTS ON THE ROOF
Position the vents evenly spaced across the roof, below the ridgeline so that the vents can
only be seen from one side of the house, yet no greater than 2 feet below the ridgeline.
2.) DRILL THE GUIDE HOLE
Adjust placement of the vents to avoid drilling through any rafters. Drill a guide hole near the
center position of each vent.
3.) OUTLINING THE HOLE
Mark correct diameter for the vent you have selected using the chart below.
4.)...
WARNING: Read all warning messages and instructions
before starting installation of this fan. Failure to follow these
safety instructions can result in injury or even death. If you
need assistance in understanding these instructions or have
questions or comments, please call 1 (309) 692-6969.
ELECTRICAL HAZARDS
DANGER: The electrical installation and wiring of this fan
must be done by a qualified electrician in accordance with
all local codes and standards, including fire-rated construc-
tion....
Part No. 18365
Installation Instructions
Use this unit only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
Utilice esta unidad solamente de la manera indicada por el
fabricante. Si tiene alguna duda, contacte al fabricante.
Roof-Mounted Solar Attic Ventilator Ventilador de ático a energía solar, de montaje en techoModel NPSP8WW Modelo NPSP8WWImportant Safety Information Información importante de seguridad
IMPORTANT: Read all warning messages...
Part No. 18365
Installation Instructions
Use this unit only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
Utilice esta unidad solamente de la manera indicada por el
fabricante. Si tiene alguna duda, contacte al fabricante.
Roof-Mounted Solar Attic Ventilator Ventilador de ático a energía solar, de montaje en techoModel NPSP8WW Modelo NPSP8WWImportant Safety Information Información importante de seguridad
IMPORTANT: Read all warning messages...
WA R NING:Read all warning messages and instructions
before starting installation of this fan. Failure to follow these
safety instructions can result in injury or even death. If you
need assistance in understanding these instructions or have
questions or comments, please call 1 (309) 693-6969.
ELECTRICAL HAZARDS
DANGER:The electrical installation and wiring of this fan
must be done by a qualified electrician in accordance with all
local codes and standards, including fire-rated construction.
Failure to...
SHINGLEOVERFILTEREDRIDGEVENT
Installation Instructions
Fits roofs with 3/12 to 16/12 pitches.
1.On existing roofs, remove cap shingles. Mark
slot width at both ends of ridge. Use slot guides
imprinted on vent and refer to drawings below.
Snap chalk line on both sides of ridge.
4.Prefasten first section using roofing nails
through predrilled nail bosses. Continue to
prefasten remaining sections, making sure
support ribs are flat on the roof and filter is
secure between shingles and vent.5.Use utility...
SHINGLEVENT®II - 7A & II - 9A
Installation Instructions
ROOF PITCH:
PRODUCT FEATURES:CUSTOMER SERVICE:
BEFORE YOU INSTALL - Install only one type of exhaust vent, remove or plug any existing vents\
(gable vents, roof louvers, wind turbines and power fans). Install adequate Intake Ventilation for a Balanced System (50% Exhaust & 50% Intake) in accorda\
nce with state and local code requirements. Intake vents must be installed low at the roof’s edge or in the soffit/undereave. Products such as Air Vent’s...
SHINGLEVENT®II
Installation Instructions
ROOF PITCH:
PRODUCT FEATURES:CUSTOMER SERVICE:
BEFORE YOU INSTALL - Install only one type of exhaust vent, remove or plug any existing vents (gable vents, roof louvers, wind turbines and power fans). Install adequate Intake Ventilation for a Balanced System (50% Exhaust & 50% Intake) in accordance with state and local code requirements. Intake vents must be installed low at the roof’s edge or in the soffit/undereave. Products such as Air Vent’s Continuous Soffit...
Part No. 18381
Installation Instructions
Use this unit only in the manner intended by the manufacturer.
If you have any questions, contact the manufacturer.
Utilice esta unidad solamente de la manera indicada por el
fabricante. Si tiene alguna duda, contacte al fabricante.
Gable-Mounted Solar Attic Ventilator
Ventilador de ático a energía solar, de montaje en el alero Model NPSG8
Modelo NPSG8 Important Safety Information
Información importante de seguridad
IMPORTANT: Read all warning...
Installation and Mounting Guide
Florida Building Product Approval and Texas Department of Insurance (TDI) Approval. Use all 8 flashing screws include\
d in package to
comply with severe weather building codes. Includes Solar Controller™\
for after dark operation.
BEFORE YOU INSTALL - Install only one type of exhaust vent and remove or plug any existing ve\
nts (gable vents, roof louvers,
ridge vents and turbines). Install adequate intake ventilation for a Ba\
lanced System (50% Exhaust & 50% Intake)...
Part N o. 1838 2
Installation Instructions
Use this u n it on ly in the m ann er inten de d b y the manufact ure r.
If yo u ha ve a n y que stions, conta ct the manu factu rer.
U tili ce e sta un idad s o la m ente de la ma nera indi cada por el
fabrica nte. Si tien e alg un a du da, contacte al fabrica nte.
Ro of- M oun ted S olar A ttic V entilator
Ventila dor de ático a en ergía solar, de m on taje en tec ho
Model SC 8BL
Model o SC8B L
Im por tant Sa fety I n form...
