Zenoah Blower HB2302 HBZ2601 Owners Manual

GB-11
G
B
HB2302 / HBZ2601
 
WARNING
Make sure that the engine has stopped and is
cool before performing any service to the
blower. Contact with rotating blower fan or hot
muffler may result in a personal injury.
AIR CLEANER
•Never operate the blower without an air filter or with a
deformed or broken filter element.
•Check the air cleaner before use.
A clogged air filter may increase fuel consumption
while cutting down the engine power. Never operate
the blower without the air filter or with a deformed...

GB-12
HB2302 / HBZ2601
•Note that failing to do so may result in the engine
catching on fire.
 
IMPORTANT
•Before starting operation, always make sure to check
if the muffler is properly held by three bolts to the cyl-
inder. (Fastening Torque : 8~12 N·m)
•Even if one bolt out of three bolts is loose, the muffler
may get loose during operation which may result in
engine catching on fire.
PROCEDURES TO BE PERFORMED AFTER EV-
ERY 100 HOURS OF USE
1.Remove the muffler, insert a screwdriver into the vent,...

GB-13
G
B
HB2302 / HBZ2601
AIR INTAKE SCREEN (AIR INLET NET)
 
IMPORTANT
•Blowing air is taken in from the air inlet net. When air
flow has dropped down during operation, stop the
engine and inspect the air inlet net for blocking by
obstacles.
•Note that failure to remove any such obstacles may
result in the engine becoming overheated and dam-
aged.
 
WARNING
•Never use the blower without the net of the blower.
Before each use, check that the net is attached in
place and is free from any damage.
9....

GB-14
HB2302 / HBZ2601
2.Align the  (5) indicated on the vacuum pipe (4)
with the 
 indicated on the blower. Then insert the
vacuum pipe (4) into the blower.
3. Turn the vacuum pipe (4) until the  (5) is aligned
with the 
 indicated on the blower to lock the vacuum
pipe.
 
WARNING
 •Hold the bottom of the vacuum pipe when turning the
vacuum pipe to install or remove it.
4) Installing Elbow and Dust Bag
1. Open the fastener of the dust bag.
2. Insert the elbow convex groove into the dust bag el-
bow...

GB-15
G
B
HB2302 / HBZ2601
3.Fit the elbow groove with discharge port projection,
turn the elbow and mount the dust bag to the main
unit.
DUST COLLECTING OPERATION
 • Put the dust bag belt on the shoulder, and adjust the
length of the belt so as to permit easy operation.
 •Confirm that the dust bag is not twisted, pull the throttle
trigger, and start dust collecting operation.
 • Detach the dust bag from the main unit when it is full
of dust, open the dust bag fastener, and dispose of
dust.
 
WARNING
 •...

GB-16
HB2302 / HBZ2601
Limited warranty
Should any failure occur on the product under normal oper-
ating conditions within the applicable warranty period, the
failed part will be replaced or repaired free of charge by a
KOMATSU ZENOAH
® authorized dealer.
WARRANTY PERIOD: 1 year (6 months if used profession-
ally, and 30 days if used for rental purpose) from the date of
initial purchase.
THE PURCHASER SHALL BEAR COSTS OF TRANS-
PORTING THE UNIT TO AND FROM THE KOMATSU
ZENOAH DEALER.
THE PURCHASER SHALL...