Zanussi Zx975 Manual

10
GUARANTEE CONDITIONS 
Standard guarantee conditions
We, Zanussi, undertake that if within 12 months of the date of purchase this Zanussi appliance or any part
thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option
repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that:
•The appliance has been correctly installed and used only on the electricity supply stated on the rating plate.
•The appliance has been used for...

11
Technical Specifications
A distance of 56mm must exist between the appliance and the wall, to allow the door to be fully opened.
The refrigeration system and the insulation of this appliance do not contain CFCs or HCFCs.
ZX99/5W(SI)          ZX97/5W(SI)          ZX99/3W 
Height (mm)2000 1850 1850
Width (mm)595 595 595
Depth (mm)670 670 670
Power Supply220-240V / 50Hz 220-240V / 50Hz 220-240V / 50Hz
Total Power Absorbed150W 150W 150W
Energy Consumption   kWh/year397.85 372.3 357.7
kWh/day1.09 1.02...

Installation
Unpacking
Remove all transit packaging, including the door transit
retainers located under the plinth. (Fig 1) and shelf
retainers (Fig 2).
Positioning
The appliance should be located in a well-ventilated,
dry room. To ensure correct operation the appliance
should:
•Not be exposed to direct sunlight.
•Not be installed next to radiators, cookers or other
sources of heat.
•Only be installed in a location where the ambient
temperature corresponds to the climate classifica-
tion for which the...

13
Electrical Connection
Any electrical work required to install this
appliance must be carried out by a quali-
fied electrician or competent person.
This appliance must be earthed.
The manufacturer declines any liability
should these safety measures not be
observed.
Electrical Requirements
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the appliance
rating plate.
The appliance is supplied with a 13 amp plug fitted. In
the event of having to change the fuse...

14
If you wish to change the opening direction of the
doors, proceed as follows:1. Open the freezer door. Remove the plinth (A) at the bottom of the appliance, by pushing downwards
and pulling outwards. (See fig 5)
2. Remove the hinge cover (B) in the plinth and repo- sition on the opposite side of the plinth.
3. Whilst supporting the lower door, use a 8mm nut driver to remove the 3 hinge retaining bolts and
remove the lower hinge.
4. Carefully lower the door off the central hinge.
5. Support the upper...