Zanussi Zwh 6160 P Manual

Programme - Maximum and Minimum Temperature -
Cycle Description - Maximum Spin Speed - Maximum
Fabrics Load - Type of LaundryOptionsDetergent
Compartment
MINI 30
30°
Main wash - Rinses - Maximum spin speed at 700 rpm
Max. load 3 kg
Synthetics and delicates. Lightly soiled items or which only
needs freshening up.
AUTOMATIC SPIN RE-
DUCTION
DELAY START
JEANS
60°- Cold
Main wash - Rinses - Maximum spin speed at 1200 rpm
Max. load 3 kg
Trousers, shirts or jackets in denim and jersey realized with hi-
tech...

Programmes
Load
(kg)
Energy consumption
(kWh)Water consumption
(litre)Approximate programme
duration (minutes)Remaining moisture (%)
1)
ZWH 6120P
Remaining moisture (%)
1)
ZWH 6140P
Remaining moisture (%)
1)
ZWH 6160P
Delicates 40
°C3,50.657177353535
Wool/Hand
wash 30 °C20.34855303030
Standard cotton programmes
Standard 60
°C cotton71.0750236535244
Standard 60
°C cotton3,50.7936192535244
Standard 40
°C cotton3,50.5736166535244
1) At the end of spin phase.
Off Mode (W)Left On Mode (W)
0.650.65
Care and...

• Use a stiff brush to clean and remove all
washing powder residue.
• Clean all the removed parts of the dispens-
er drawer under a tap to remove any traces
of accumulated powder.
• Use the previous
brush to clean the
recess, ensuring
that upper and
lower part of it is
well cleaned.
After having cleaned the dispenser and the
drawer recess, replace it.
Cleaning the drain filter
The filter permits to hold fluff or foreign bodies
left unawares in the laundry.
The pump must be cleaned regularly.
To clean the...

The filter is inserted correctly when the
indicator on its top is visible and
blocked.
• close the filter cov-
er;
• insert the mains
plug again.
Cleaning the water inlet filters
Important! If the appliance doesn't fill, it takes
a long time to fill with water, the starting button
flashes red or the display (if available) shows
the relevant alarm (see chapter "What to do
if..." for more details), check if the water inlet
filters are blocked .
To clean the water inlet filters:
• Turn off the...

The water tap is closed.
• Open the water tap.
The inlet hose is squashed or kinked.
• Check the inlet hose connection.
The filter in the inlet hose or the inlet valve filter are blocked
• Clean the water inlet filters (read "Cleaning the water inlet filters"
for more details).
The light of button 6 flashes and the light 7.2 illuminates: Problem with the water
drainage
The drain hose is squashed or kinked.
• Check the drain hose connection.
The drain filter is clogged
• If the appliance stops...

The door has not been closed or is not closed properly.
• Close firmly the door.
The appliance does not start or stops during
operation without any visible alarm.
Before contacting your local Service Centre,
please carry out the checks listed below.
MalfunctionPossible cause / Solution
The appliance does not
start:
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main...

MalfunctionPossible cause / Solution
The appliance vibrates
noisily:
The transit bolts and packing have not been removed.
• Check the correct installation of the appliance.
The appliance is not levelled correctly.
• Adjust the feet.
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
Maybe there is very little laundry in the drum.
• Load more laundry.
Spinning starts late or
the appliance does not
spin:
The electronic unbalance detection device has cut in because the laundry...

Mod. ... ... ...
Prod. No. ... ... ...
           Ser. No. ... ... ...
Mod. 
..
. ... ...
Prod. No
.
 .
.. ... ..
  
   
    
  
  
  
     
    
 S
er
. N
o
. ... ... 
...
Model description
(MOD.) ........................................
Product number
(PNC) .............................................
Serial number
(S.N.) .................................................
28
 
www.zanussi.com 

 29 www.zanussi.com 

30
 www.zanussi.com