Zanussi Zrg 31 Sw Instruction Manual

The temperatures in the refrigerator compartment and freezer compartment cannot be independently regulated.At a low ambient temperature of around 16℃, setting'1' should be selected. At ambient temperatures of around 25℃ , select setting'2' .If you require a lower temperature, select setting '3'or'4'. On this setting, you can be sure the fresh food will be reliably frozen and that a storage temperature of –12℃ will be maintained in the freezer compartment.If you want the...

Please do the same in reverse to insert the shelf at a different height.Correct storage1.Butter and cheese2.preserves3.Drinks4.Cheese storage, fruit, and vegetables5.Meat, salami, cold cuts, dairy produce6.Ready meals, pastries, preserves 7.Frozen food storage/freezing foodTip:Food in the fridge should always be covered or packaged, to prevent drying and tainting of other food.The following are suited for packaging:-Polyethylene airtight bags and wraps;-Plastic containers with lids;-Special plastic...

Bottles and cans must not be placed in the freezer. They can burst when the contents freeze, high carbonate content drinks can even explode! Never store lemonade, juices, beer, wine, sparkling wine etc.in the freezer compartment.All foods must be packed air tight prior to freezing, so that they do not dry out or lose their flavour, and so that no flavour contamination of other frozen goods occurs.Caution!Do not touch frozen food with wet hands. Your hands could stick to the food and cause skin...

DefrostingThe fridge defrosts automaticallyThe rear wall of the fridge covers with frost when the compressor is running, and defrosts when the compressor is off. The water from the thawing frost evaporates by itself.Defrosting the freezer compartmentDuring use and when the freezer compartment door is opened, moisture is deposited in the freezer compartment as frost. Remove this frost from time to time with the soft plastic scraper. Under no circumstances, use hard or pointed objects to remove frost.The...

Switching off the applianceTo switch off the appliance, turn the temperature regulator to position “0”.If the appliance is not going to be used for an extended period:Remove all refrigerated packages.Switch off the appliance by turning the temperature regulator to position “0”.Remove the mains plug or switch off or turn out the circuit breaker or fuse.Clean thoroughly (see section “cleaning and Care”).Leave the door open to avoid the build up of odour.Cleaning and CareFor hygienic reasons the appliance...

After cleaning wipe with fresh water and rub dry.Accumulation of dust at the condenser increases energy consumption. For this reason carefully clean the condenser at the back of the appliance once a year with a soft brush or a vacuum cleaner.Check the water drain hole on the rear wall of the fridge.After everything is dry place appliance back into service.Energy Saving TipsDo not install the appliance near cookers, radiators or other sources of warmth. High ambient temperatures cause longer, more...

A malfunction may be caused by only a minor fault that you can rectify yourself using the following instructions. Do not perform any other work on the appliance if the following information does not provide assistance in your specific case.Important!Repairs to refrigerators/freezers may only be performed by competent service engineers. Improper repairs can give rise to significant hazards for the user. If your appliance needs repairing, please contact your specialist dealer or your local Service Force...

Changing the light bulbWarning!There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it, or pull the fuse or the circuit breaker.Light bulb data:220~240 V, max. 15 WTo switch off the appliance, turn the temperature regulator to position“0”.Unplug the mains plug.To change the light bulb, undo the screw.Press the light bulb cover as shown and slide it backwards.Change the defective light bulb.Refit the light bulb cover and the screw.Put the refrigerator...

24Warning!This appliance must be earthed.The manufacture declines any liability should these safety measures not be observed.Important!Green and Yellow:Brown:Earth235431The wires in the mains lead are colored in accordance with the following code Blue:Neutral5LiveAs the colours of the wires in the mains lead of this appliance may not correspond  with the coloured markings identifying the terminals in your plug, proceed as follows:1. Connect the wire coloured green and yellow to the terminal marked either...