Zanussi Zi 9155 A Instruction Booklet

11
Door reversal
The appliance’s door has been locked in position for
transport by means of pins on both sides. According
to the door opening direction, remove the relevant
pins at the top and at the bottom.Attention
After completion of the door reversing
operation, check that the door gasket adheres
to the cabinet. If the ambient temperature is
cold (i.e. in Winter), the gasket may not fit
perfectly to the cabinet. In that case, wait for
the natural fitting of the gasket or accelerate
this process by...

12
If you fit your own plug, the colours of the wires in the
mains lead of your appliance, may not correspond
with the markings identifying the terminals in your
plug, proceed as follows:
Connect the Green and the Yellow (earth) wire to the
terminal in the plug which is marked with the letter
«E» or the earth symbol  , or coloured green and
yellow.
Connect the blue (neutral) wire to the terminal in the
plug which is marked with the letter «N» or coloured
black.
Connect the brown (live) wire to the...

13
Dimensions of the recessZI 9155 AZI 9225 A
Height of housing (1) mm  880 1225
Depth of housing (2) mm  550 550
Width of housing (3) mm  560 560
It is necessary that the  cabinet has a ventilation
recess with the following dimensions:
Depth 50 mm Width 540 mm
Building in
PR0
54050
3
2 1
For appropriate venting, follow indications in the
figure.
50 mm
min.
200 cm2
200 cm
2
min.
D526
2. Press in the joint covers between the appliance
and the kitchen furniture.
D132
3. Open the door and push the appliance...

PR167
Ha
Hb
8mm
14
6. Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and
mark the position of external holes. After having
drilled holes, fix the guide with the screws
supplied.
8. Open the appliance door and the furniture door at90°. Insert the small square (Hb) into guide (Ha).
Put together the appliance door and the furniture
door and mark the holes as indicated in the figure. 
5. Separate parts  Ha, Hb, Hc, Hdas shown in the
figure.
7. Fix cover (Hc) on...

15
10. Place the small square on the guide again and fixit with the screws supplied.
Should the alignment of the furniture door be
necessary, use the clearance of slots.
At the end of  this procedure , it is necessary to
check if the door of the furniture closes properly.
PR168Hb
11. Fix cover ( Hd) on the small square (Hb) until it
clips into place.
PR167/1
Hd
Hb
 

© Electrolux plc 2007