Zanussi Zdt 311 User Manual

2. Leave the door ajar to prevent the forma-
tion of any unpleasant smells.
3. Leave the inside of the machine clean.
Frost precautions
Avoid placing the machine in a location where
the temperature is below 0°C. If this is
unavoidable, empty the machine, close the ap-
pliance door, disconnect the water inlet pipe
and empty it.
Moving the machine
If you have to move the machine (moving house
etc....):1. Unplug it.
2. Turn the water tap off.
3. Remove the water inlet and discharge ho-
ses.
4. Pull the...

Something not working
The dishwasher will not start or stops during
operation.
Certain problems are due to the lack of simple
maintenance or oversights, which can besolved with the help of the indications described
in the chart, without calling out an engineer.
Switch off the dishwasher and carry out the fol-
lowing suggested corrective actions.
Fault code and malfunctionPossible cause and solution
•
1 intermittent audible signal
•
continuous flashing of the light of the running
programme
•1 flash of the...

If the malfunction or fault code reappears con-
tact the Service Force Centre.For other fault codes not described in the above
chart, please contact your Service Force Cen-
tre.
The wash results are not satisfactory
The dishes are not clean• The wrong washing programme has been selected.
• The dishes are arranged in such a way as to stop
water reaching all parts of the surface. The baskets
must not be overloaded.
• The spray arms do not rotate freely due to incorrect
arrangement of the load.
• The...

Consumption values
The consumption values are intended as a
guide and depends on the pressure and the
temperature of the water and also by the var-iations of the power supply and the amount of
dishes.
Consumption values
ProgrammeProgramme duration (in
minutes)Energy consumption (in
kWh)Water (litres)
Intensive 70°80-901,6-1,822-24
AUTO 45° 70°90-1251,1-1,612-23
65°A30300,99
BIO 50° (Test pro-
gramme for Test Insti-
tutes)1601,0514
Glass 45°60-700,8-0,914-15
Technical data
DimensionsWidth x Height x Depth...

rinse aid respectively and using the test pro-
gramme (see Consumption values).
Full load: 12 standard place settings
Amount of detergent required5 g + 25 g (Type B)
Rinse aid settingposition 4 (Type III)
Upper basketCutlery basketLower basket
cup racks: position A
Installation
  WARNING!
Any electrical and/or plumbing work required to
install this appliance should be carried out by a
qualified electrician and/or plumber or compe-
tent person.
Water connection
  WARNING!
The dishwasher must not be...

  WARNING!
Only use, for connection to the water mains,
new hose-set; old hose-set must not be reused.
  CAUTION!
If the machine is connected to new pipes or
pipes which have not been used for a long time,
you should run the water for a few minutes be-
fore connecting the inlet hose.
Water inlet hose with safety
valve
Connect the inlet hose to a water tap with an
external thread of 3/4”.
After connecting the double-walled water inlet
hose, the safety valve is next to the tap.
If the water inlet hose...

Drain hose
Connect drain hose to the
sink.Required height: 30 to 100
cm above bottom of the
dishwasher.Ensure that the hoses are
not kinked, crushed or en-
tangled.When connecting the
drain hose to an under
sink trap spigot, the entire
plastic membrane (A)
must be removed. Fail-
ure to remove all the mem-
brane will result in food
particles building up over
time eventually blocking
the dishwasher drain hose
spigot.
If you use a drain hose extension the total
length should not be longer than 4 metres....

Fitting under a counter
IMPORTANT!
Carefully follow the instructions on the enclosed
template for building in the dishwasher and fit-
ting the furniture panel.
  WARNING!
The dishwasher must be secured against tilting.
Therefore make sure that the counter it is fixed
under, is suitably secured to a fixed structure
(adjacent kitchen units cabinets, wall).
This dishwasher is designed to be fitted under
a kitchen counter or work surface.
No further openings for the venting of the
dishwasher are required,...

 29 

30