Zanussi Zbt 3234 User Manual

							1 2
Install the appliance in the
niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture. Make sure that
the distance between the
appliance and the cup-
board front-edge is 44 mm.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge. Make sure that the
clearance between the ap-
pliance and the cupboard
is 4 mm.
44mm
4mm
Adjust the appliance in the
niche.
The lower hinge cover (in
the accessories bag)
makes sure that the dis-
tance between the appli-
ance and the kitchen furni-
ture is correct.
Open the door. Put the low-
er hinge cover in position.
I
I
Attach the appliance to the
niche with 4 screws.Push the sealing strip be-
tween the appliance and
the adjacent cabinet.
Remove the correct part
from the hinge cover (E).
Make sure to remove the
part DX, in the case of
right hinge, SX in oppo-
site case.
BE
E
CD
Attach the covers (C, D) to
the lugs and the hinge
holes.
Install the vent grille (B).
Attach the hinge covers
(E) to the hinge.
Ha
Hb
Hc
Hd
Disconnect the parts (Ha),
(Hb), (Hc) and (Hd).
ca. 50 mm
ca. 50 mm21 mm
90°
21 mm90°
Install the part (Ha) on the
inner side of the kitchen
furniture.
 11
 
						

							Ha
Hc
Push the part (Hc) on the
part (Ha).
Ha
Hb
8 mm
Open the appliance door
and the kitchen furniture
door at an angle of 90°.
Insert the small square
(Hb) into guide (Ha).
Put together the appliance
door and the furniture
door and mark the holes.
Ha K
8 mm
Remove the brackets and
mark a distance of 8 mm
from the outer edge of the
door where the nail must
be fitted (K).
Hb
Place the small square on
the guide again and fix it
with the screws supplied.
Align the kitchen furniture
door and the appliance
door by adjusting the part
Hb.
Hb
Hd
Press the part (Hd) on the
part (Hb).   
Do a final check to make sure that:
• All screws are tightened.
• The magnetic sealing strip is attached tightly to the
cabinet.
Important!  If the ambient temperature is low (for
example, in the Winter), the size of the gasket
decreases. The size of the gasket increases when the
ambient temperature increases.
Environmental concerns
The symbol    on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of
electrical and electronic equipment. By ensuring this
product is disposed of correctly, you will help preventpotential negative consequences for the environment
and human health, which could otherwise be caused by
inappropriate waste handling of this product. For more
detailed information about recycling of this product,
please contact your local council, your household waste
disposal service or the shop where you purchased the
product.
12
 
 
						

							 13
 
						

							14
 
 
						

							 15
 
						

							 www.zanussi.com/shop
   
212721411-00-11052010