Zanussi Zbb 6297 Instruction Booklet

61
Never use sharp metal tools to scrape off frost
from the evaporator as you could damage it.
However, when the ice becomes very thick on the
inner liner, complete defrosting should be carried out
as follows:
1. pull out the plug from the wall socket or turn the
thermostat knob to the «O» setting;
2. remove any stored food, wrap it in several layers
of newspaper and put it in a cool place;
3. leave the door open, and insert the plastic
scraper in the appropriate seating at the bottom
centre, placing a...

62
Electrical connection
Before plugging in, ensure that the voltage and
frequency shown on the serial number plate
correspond to your domestic power supply. Voltage
can vary by ±6% of the rated voltage.
For operation with different voltages, a suitably sized
auto-transformer must be used.
The appliance must be earthed.
The power supply cable plug is provided with a
contact for this purpose.
If the domestic power supply socket is not earthed,
connect the appliance to a separate earth in
compliance with...

63
Instructions for totally built-in appliances
Door reversibility
Instructions for totally built-in
appliances
Dimensions of the recess
Height           (1)         1780 mm
Depth            (2)           550 mm
Width            (3)           560 mm
For safety reasons, minimum ventilation must be as
shown in Fig.Attention: keep ventilation openings
clear of obstruction.






 
	




Furthermore, it is necessary that the niche is provid
with a  conduct of...

64


Apply the sealing strip pushing it between the
refrigerator and the adjacent cabinet.
Fasten the appliance with 4 screws provided in the
kit included with the appliance.
(I = short) (P = long)
Make sure that a distance of 44 mm is maintained in
the lower part between the kitchen furniture and the
border of the appliance.
The lower hinge cover inserted in the accessories
bag, is useful to guarantee the exact position of the
kitchen furniture and the appliance.
Also make sure that the appliance...

65
Place guide (Ha) on the inside part of the furniture
door, up and down as shown in the figure and mark
the position of external holes. After having drilled
holes, fix the guide with the screws supplied.












Fix cover (Hc) on guide (Ha) until it clips into place
	




	




Open the appliance door and the furniture door at
90°. Insert  the small square (Hb) into guide (Ha).
Put together the appliance door and the furniture
door and mark the holes as...

66
If the appliance is fixed to the side of the kitchen
unit, simply slacken the screws in the fixing brackets
(E), move the brackets as shown in the figure and
re-tighten the screws.




After having reversed the opening direction of
the doors check that all the screws are properly
tightened and that the magnetic seal adheres to
the cabinet. If the ambient temperature is cold
(i.e. in Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natural
fitting of the gasket or...

67
DECLARATION OF GUARANTEE TERMS
Our appliances are produced with the greatest of care. However, a defect may still occur. Our consumer
services department will repair this upon request, either during or after the guarantee period. The service life of
the appliance will not, however, be reduced as a result.
This declaration of guarantee terms is based on European Union Directive 99/44/EC and the provisions of the
CE Civil Code. The statutory rights that the consumer has under this legislation are not...

68
These guarantee terms are only valid for appliances purchased and used in Belgium. For exported appliances,
the user must first make sure that they satisfy the technical conditions (e.g.: voltage, frequency, installation
instructions, type of gas, etc.) for the country concerned, and that they can withstand the local climatic and
environmental conditions. For appliances purchased abroad, the user must first ensure that they meet the
qualifications required in Belgium. Non-essential or requested...