Zanussi Td 4112 W Manual

							11
The tumble dryer does not start
The door has not been closed. 

The plug is not properly inserted in the power
socket.

There is no current at the socket

The main fuse or the fuse in the plug has blown.

A drying time has not been selected.
Drying takes too long or laundry is not dry
enough.
The laundry has not been spun properly.

The filter is clogged up.

The room temperature is too high.

The selected time or sector was not suitable for
the laundry

There is too much laundry inside the appliance.

The dryer is not correctly installed.

The Low Temperature or Cool Tumble Button
has been depressed.
Something Not Working
Symptom Possible causes
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without
calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below.
IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect
use or installation, a charge will be made even if the appliance is under guarantee.
Service & Spare Parts
In the event of your appliance requiring service, or if
you wish to purchase spare parts, please contact your
local Zanussi Service Force Centre by telephoning:
0870 5 929929
Your telephone call will be automatically routed to
the Service Force Centre covering your post code
area.
For the address of your local Service Force Centre
and further information about Service Force, please
visit the website at www.serviceforce.co.uk.
Before calling out an engineer, please ensure you
have read the details under the heading “Something
Not Working”.
When you contact the Service Force Centre you will
need to give the following details:
1. Your name, address and post code
2. Your telephone number
3. Clear and concise details of fault
4. The model and serial number of the appliance
(found on the rating plate - see picture).
5. The purchase date
Customer Care
For general enquiries concerning your Zanussi
appliance or for further information on Zanussi
products, please contact our Customer Care
Department by letter or telephone as follows:
Customer Care Department
Zanussi
55-77 High Street
Slough
Berkshire
SL1 1DZ
Tel 08705 727727*
or visit our website at www.zanussi.co.uk
* calls to this number may be recorded for training
purposes.
	
	











125994670  TD4112 W.qxd  1/30/02  8:48 AM  Pagina  11    (Nero/Process Black pellicola) 
						

							12
Zanussi Guarantee Conditions
Standard guarantee conditions
We, Zanussi undertake that if, within 12 months of
the date of the purchase, this Zanussi appliance or
any part thereof is proved to be defective by reason
only of faulty workmanship or materials, we will, at
our option, repair or replace the same FREE OF
ANY CHARGE for labour, materials or carriage on
condition that:

The appliance has been correctly installed and
used only on the electricity supply stated on the
rating plate.

The appliance has been used for normal domestic
purposes only, and in accordance with the
manufacturer’s instructions.

The appliance has not been serviced, maintained,
repaired, taken apart or tampered with, by any
person not authorised by us.
All service work under this guarantee must be
undertaken by a Zanussi Service Force Centre.
Any appliance or defective part replaced shall
become the Company’s property.
This guarantee is in addition to your statutory and
other legal rights.
Home visits are made between 8.30amand 5.30pm
Monday to Friday. Visits may be available outside
these hours in which case a premiumwill be
charged.
Exclusions
This guarantee does not cover:

Damage or calls resulting from transportation,
improper use or neglect, the replacement of any
light bulbs or removable parts of glass or plastic.

Costs incurred for calls to put right an appliance
which is improperly installed or calls to
appliances outside the United Kingdom.

Appliances found to be in use within a
commercial environment, plus those which are
subject to rental agreements.

Products of Zanussi manufacture which are NOT
marketed by Zanussi.
European guarantee
If you should move to another country within Europe
then your guarantee moves with you to your new
home subject to the following qualifications:

The guarantee starts from the date you first
purchased your product.

The guarantee is for the same period and to the
same extent for labour and parts as exists in the
new country of use for this brand or range of
products.

The guarantee relates to you and cannot be
transferred to another user.

Your new home is within the European
Community (EC) or European Free Trade Area.

The product is installed and used in accordance
with our instructions and is only used
domestically, i.e. a normal household.

The product is installed taking into account
regulations in your new country.
Before you move please contact your nearest
Customer Care Centre, listed below, to give them
details of your new home. They will then ensure that
the local Service Organisation is aware of your move
and able to look after you and your appliances.
France Senlis +33 (0)344 62 29 29
Germany Nurnberg +49 (0)800 234 7378
Italy Pordenone +39 (0)434 39 4700
Sweden Stockholm +46 (0)8 672 53 90
UK Slough +44 (0)1753 219897
125994670  TD4112 W.qxd  1/30/02  8:48 AM  Pagina  12    (Nero/Process Black pellicola) 
						

							13
Installation Instructions
Technical Specifications
It is dangerous to alter the specifications or
attempt to modify this product in any way.
Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
DIMENSIONS  Height 85 cm (33.5”)
Width  60 cm (23.6”)
Depth  57 cm (22.4”)
POWER SUPPLY VOLTAGE  230-240 V/50 Hz
TOTAL POWER ABSORBED  2650 W (13A)
MAXIMUM RECOMMENDED LOAD  Cotton, linen 5 kg (11 lbs)
Synthetics 2.5 kg (5.5 lbs)
DRUM VOLUME 108 l
CONSUMPTIONS  3.30 kWh (5 kg store dry)
2.70 kWh  (5 kg iron dry)
This appliance complies with the following E.E.C. Directives:
- 73/23 EEC of 19.2.73 (Low Voltage Directive) and subsequent modifications;
- 89/336 EEC of 3.5.89 (Electromagnetic Compatibility Directive) and subsequent modifications.
125994670  TD4112 W.qxd  1/30/02  8:48 AM  Pagina  13    (Nero/Process Black pellicola) 
						

							14
Positioning
It is recommended that, for your convenience, the
machine is positioned close to your washing
machine.
Whilst drying, the tumble dryer will expel a certain
amount of warm, very moist air, and this should be
removed from the room as quickly as possible to
prevent condensation. In an extremely well ventilated
room or close to an open window, this may occur
naturally.
However, in general, it is better to carry the dryers
exhaust outside via a 100 mm diameter flexible hose
(supplied with the machine); ending either
temporarily at an open window, or permanently at a
fixed ventilation grille, fitted to an exterior wall or
window.
The tumble dryer must be installed in a clean place,
where dirt does not build up.
Make sure there are no obstructing items or material
near the air-intake louvres provided at the back (e.g.
paper, rags etc.).
To keep vibration and noise to a minimum when the
dryer is in use, it should be placed on a firm, level
surface.
Once in its permanent operating position, check that
the dryer is absolutely level with the aid of a spirit
level. If it is not, raise or lower the two adjustable
feet at the front of the machine until it is.
The feet must never be removed.
Do not restrict the floor clearance through deep-
pile carpets, strips of wood or similar. This might
cause heat build-up which would interfere with
the operation of the appliance.
Important
When operating the tumble dryer, the room
temperature must not exceed 35°C, as it may affect
the performance of the appliance.

Fitting the vent hose
To simplify the installation, there is a choice of vent
outlets: one at the back, the others in the left and
right-hand side.
Connect the hose to whichever is the more
convenient by pulling the ring nut (A) from the vent
outlet at the back, screwing it on to the hose and
pushing it firmly back into place.
The unused vents should now be sealed with the
special snap covers provided.



125994670  TD4112 W.qxd  1/30/02  8:48 AM  Pagina  14    (Nero/Process Black pellicola) 
						

							15 Advice: If the hose is long and the room temperature
low, the moisture might condense to water inside the
hose. This is an unavoidable natural phenomenon.
To prevent this water from lying in the hose or
flowing back into the tumble dryer, it is advisable to
drill a small hole (dia. 3 mm) in the lowest point of
the hose and to place a small container below it.(See
picture, point B).
Once connected to the dryer, run the vent hose to the
desired outlet point, ensuring that the run’s overall
length is less than 2.5 m, and that it contains no more
than two bends. As to the outlet itself, if you have
decided on a fixed wall/window grille, a good local
builder’s merchant should be able to supply you with
the necessary fittings and installation advice.
It is important not to connect the vent
hose to, for example, a cooker hood,
or a chimney or flue pipe designed to
carry the exhaust from a fuel burning
appliance.
Note that to avoid condensation problems, it is
essential that the dryer be fitted with the flexible hose
to carry its “exhaust” at least beyond the kitchen
units; preferable outside the kitchen.





In order to prevent the appliance from overheating, it
is important that the steam exhaust is unobstructed.
Therefore, in case of a permanent hose fitted to an
exterior wall or ceiling, it must have an exhaust
capacity of at least 150 m
3/h.
If the dryer is fitted next to kitchen units, make
sure that the vent hose is not squashed. If the hose
is partially squashed, drying efficiency will be
reduced, resulting in longer drying times and
higher energy consumption.
If the hose is completely squashed, the safety cut-
outs with which the machine is fitted may operate.
125994670  TD4112 W.qxd  1/30/02  8:48 AM  Pagina  15    (Nero/Process Black pellicola) 
						

							16
Door reversal
To make it easier to load or unload the laundry the
door can be reversed.
This operation must be carried out by qualified
personnel.
Operate as follows: 
-  Remove the door by unscrewing the two screws (1)
fastening the hinge to the cabinet (Fig. A).
- Remove the safety catch (2) and the plug (3) by
bending the two fastening tags (Fig. A).
-  Refit the safety catch (2) and plug (3) on the door
by reversing their positions (Fig. B).
-  Remove the plastic plate (4) by unscrewing the two
fastening screws (Fig.  A).
- Refit the plastic plate (4) on the opposite side 
(Fig.  B).
- Refit the door by screwing in the two screws (1)
which fasten the door to the cabinet (Fig. B).



 



	




Stacking kit
It should be possible to stack your new dryer on top
of your washing machine.
Please contact your Local Service Force Centre for
further advice.


125994670  TD4112 W.qxd  1/30/02  8:48 AM  Pagina  16    (Nero/Process Black pellicola) 
						

							17
Electrical connection
Any electrical work required to install this appliance
should be carried out by a qualified electrician or
competent person.
WARNING: THIS APPLIANCE MUST BE
EARTHED.
The manufacturer declines any liability
should this safety measure not be observed.
Before switching on, make sure the electricity supply
voltage is the same as that indicated on the
appliance’s rating plate. (See picture).
The appliance is supplied with a 13amp plug fitted.
In the event of having to change the fuse in the plug
supplied, a 13amp ASTA approved (BS 1363/A) fuse
must be used.
Should the plug need to be replaced for any reason,
proceed as described below.
The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow - Earth
Blue - Neutral
Brown - Live
The wire coloured green and yellow must be
connected to the terminal marked with the letter «E»
or by the earth symbol  or coloured green and
yellow.
The wire coloured blue must be connected to the
terminal «N» or coloured black.

 


	 

 



	
	











The wire coloured brown must be connected to the
terminal marked «L» or coloured red.
Upon completion there must be no cut, or stray
strands of wire present and the cord clamp must be
secure over the outer sheath.
WARNING:
A cut off plug inserted into a 13 amp socket
is a serious safety (shock) hazard.
Ensure that the cut off plug is disposed of
safely.
The power supply cable must be easily accessible
after installing the machine.
Permanent connection
In the case of permanent connection it is necessary
that you install a double pole switch between the
appliance and the electricity supply (mains), with a
minimum gap of 3mm between the switch contacts
and of a type suitable for the required load in
compliance with the current electrical regulations.
The switch must not break the yellow and green earth
cable at any point.
125994670  TD4112 W.qxd  1/30/02  8:48 AM  Pagina  17    (Nero/Process Black pellicola) 
						

							© Electrolux Household Appliances Limited 2001
From the Electrolux Group.The world’s No. 1 choice.
The Electrolux Group is the worlds largest producer of powered appliances for kitchen, cleaning and outdoor
use. More than 55 million Electrolux Group products (such as refrigerators, cookers, washing machines,
vacuum cleaners, chain saws and lawn mowers) are sold each year to a value of approx. USD 14 billion in
more than 150 countries around the world.
125994670  TD4112 W.qxd  1/30/02  8:48 AM  Pagina  18    (Nero/Process Black pellicola)