Zanussi Fcs 920 C User Manual

Washing programmes
Programme/ TemperatureType of laundryOptionsDescription of the pro-gramme
COTTON
(COTTON)
90°White cotton  (heavily and
normally soiled cotton
items)SPIN REDUCTION/RINSE
HOLD - DELAY START-
PREWASH - QUICK
1) -
SUPER RINSE
Main wash
Rinses
Long spin max. 900 rpm
Max load 3 kg
Red. load 2 kg
White cotton economy
(This programme can be
selected for slightly or nor-
mally soiled cotton items.
The temperature will de-
crease and the washing
time will be extended. This
allows to obtain a...

Programme/ TemperatureType of laundryOptionsDescription of the pro-gramme
 WOOL
40°-COLD
Washing programme for
machine washable wool as
well as for hand washable
woollens and delicate fab-
rics.
SPIN REDUCTION/RINSE
HOLD - DELAY START
Main wash
Rinses
Short spin max. 900 rpm
Max Load 1 kg
MINI
(30)
30°For lightly soiled laundry
or for laundry which needs
freshening up.SPIN REDUCTION/RINSE
HOLD - DELAY START
Main wash
Rinses
Short spin max. 700 rpm
Max Load 1,5 kg
 RINSES
With this programme it is...

tions. This will help to prevent the formation of lime de-
posits.
Maintenance Wash
With the use of low temperature washes it is possible to
get a build up of residues inside the drum.
We recommend that a maintenance wash be performed on
a regular basis.
To run a maintenance wash:
• The drum should be empty of laundry.
• Select the hottest cotton wash programme.
• Use a normal measure of detergent, must be a powderwith biological properties.
External cleaning
Clean the exterior cabinet of the appliance...

The appliance is only to be used and stored indoors at
normal room temperature. The manufacturer is not re-
sponsible for any frost damage.
What to do if…
Certain problems are due to lack of simple maintenance or
oversights, which can be solved easily without calling out
an engineer. Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that the End pilot
light blinks to indicate that the machine is not working:
• 1 flash:  problem...

ProblemPossible cause/Solution
There is water on the floor:
Too much detergent or unsuitable detergent (creates too much foam) has been
used.
• Reduce the detergent quantity or use another one.
Check whether there are any leaks from one of the inlet hose fittings. It is not
always easy to see this as the water runs down the hose; check to see if it is
damp.
• Check the water inlet hose connection.
The drain or inlet hose is damaged.
• Change it with a new one.
Unsatisfactory washing results:
Too little...

ProblemPossible cause/Solution
No water is visible in the drum:Machines based on modern technology operate very economically using very
little water without affecting performance.
If you are unable to identify or solve the problem, contact
our service centre. Before telephoning, make a note of the
model, serial number and purchase date of your machine:
the Service Centre will require this information.
Mod. ... ... ...
Prod. No. ... ... ...
          Ser. No. ... ... ...
Technical data
DimensionsWidth...

ProgrammeEnergy consumption(KWh)Water consumption (litres)Programme duration (Mi- nutes)
Synthetic 40°0.2642~ 67
Delicate 40°0.3845~ 61
Hand Wash 30°0.2042~ 50
Wool 40°0.3545~ 50
Mini 30°0.1835~ 30
Rinses0.0330~ 27
Drain--~ 1
Spin--~ 5
1) «Cottons Eco» at 60°C with a load of 3 kg is the reference  programme for the data entered in the energy label, in compliance  with
EEC 92/75 standards.
The consumption data shown on this chart is to be considered purely indicative, as it may vary depending on the...

Return machine to its upright position and remove the
power supply cable and the draining and inlet hose
from the hose holders on the rear of the appliance.
With a suitable spanner unscrew and remove the three
screws and their spacers on machines rear.
The three holes must then
be plugged with the plastic
plug caps supplied in the
bag containing the in-
struction booklet, which
can be found inside the
drum.
Positioning
Install the machine on a flat hard floor. Make sure that air
circulation around the...

chase a new, longer hose specially designed for this type
of use.
Water drainage
The end of the drain hose can be positioned in three ways:Hooked over the edge of a sink using the plastic hose
guide supplied with the machine.
In this case, make sure the end cannot come unhooked
when the machine is emptying. This could be done by ty-
ing it to the tap with a piece of string or attaching it to the
wall.
In a sink drain pipe with a trap.
650-800 mm
The drain hose can be connected directly into the pipe...

Environment concerns
The symbol  on the product or on its packaging
indicates that this product may not be treated as
household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical
and electronic equipment. By ensuring this product is
disposed of correctly, you will help prevent potential
negative consequences for the environment and human
health, which could otherwise be caused by inappropriate
waste handling of this product. For more detailed...