Zanussi Fae 1025 V User Manual

							WASHING MACHINE
PRALKA AUTOMATYCZNA
AUTOMATICKÁ PRACKA
AUTOMATICKÁ PRÁCKA
AUTOMATA MOSÓGÉP
FAE825V
FAE1025V
USER MANUAL
INSTRUKCJA OBSLUGI
NÁVOD NA OBSLUHU
NÁVOD K OBSLUZE
HASZNÁLATI ÚTMUTATÓ
35.292.844/0
SK
H
CZ
PL
GB
 
						

							2
Dear customer,
Please read these operating instructions carefully
and pay particular attention to the safety notes
indicated in the first pages. We recommend that you
keep this instruction booklet for future reference and
pass it on to any future owners.
Transport damages
When unpacking the appliance, check that it is not
damaged. If in doubt, do not use it and contact the
Service Centre.
The symbols you will see on some paragraphs of this booklet have the following meaning:
The warning triangle and/or the key words (Warning!, Caution!) emphasize information that is particularly
important for your safety or correct functioning of the appliance.
The information marked with this symbol provides additional instructions and practical tips on the use of
the appliance.
Tips and information about economical and ecological use of the machine are marked with this symbol.
Our contribution to the protection of the
environment: we use recycled paper.
 
						

							3
ENGLISH
Maintenance 22-23
Bodywork 22
Detergent dispenser drawer 22
Cleaning of the drainage area 22
Water inlet filter 23
Emergency emptying out 23
Frost precautions 23
Something not working? 24-26 Warnings 4-5
Disposal 5
Tips for environmental protection 5
Technical specifications 6
Installation 7-8Unpacking 7
Hydraulic connection 7
Levelling 8
Electrical connection 8
Your new washing machine 9
Description of the appliance 9
Detergent dispenser drawer 9
Use 10
Control panel 10
Controls 10-12
Washing hints 13
Sorting the laundry 13
Temperatures 13
Before loading the laundry 13
Maximum loads 13
Laundry weights 13
Removing stains 13
Detergents and additives 14
Quantity of detergent to be used 14
International wash code symbols 15
Operating sequence 16-18
Washing programmes 19-21
Contents
 
						

							4
Installation
• All internal packing must be removed before using
the appliance. Serious damage may be caused to
the machine or adjacent furniture if the protective
transit devices are not removed or are not
completely removed. Refer to the relevant
paragraph in the instruction book.
• Any electrical work required to install this appliance
must be carried out by a qualified electrician.
• Any plumbing work required to install this
appliance must be carried out by a qualified
plumber.
• After having installed the machine, check that it is
not standing on its electrical supply cable.
• If the appliance is placed on a carpeted floor,
ensure that air can circulate freely between the feet
and the floor.
• The power supply cable only can be replaced by a
person of the Technical Service.
Use
• This appliance is designed for domestic use. It
must not be used for purposes other than those for
which it was designed.
• Only wash fabrics which are designed to be
machine washed. Follow the instructions on each
garment label.
• Do not overload the appliance. Follow the
instructions in the instruction book.
• Make sure that all pockets are empty. Objects such
as coins, safety pins, pins and screws can cause
extensive damage.
• Do not machine wash garments saturated with
petroleum, methylated spirits, trichlorethylene, etc.
If such fluids have been used to remove stains
prior to washing, wait until they have completely
evaporated from the fabric before placing garments
in the appliance.
• Place small items such as socks, belts, etc. in a
cloth bag or pillowcase to prevent them getting
trapped between the drum and the tub.
• Use only the recommended quantities of fabric
softener. An excessive amount could damage the
laundry.
Warnings
• Leave the porthole door slightly ajar when the
appliance is not in use. This preserves the door
seal and prevents the formation of musty smells.
• Always check that water has emptied out before
opening the door. If not, drain the water following
the instructions in the instruction book.
• Always unplug the appliance and shut the water
tap after use.
General safety
• Repairs to the machine must be carried out only by
qualified personnel. Repairs carried out by
inexperienced persons could cause serious
danger. Contact your local Service Centre.
• Never pull the power supply cable to remove the
plug from the socket; always take hold of the plug
itself.
• During high temperature wash programmes the
door glass may get hot. Do not touch it! The following warnings are provided in the interests of overall safety. You must read them carefully before
installing or using the appliance.
 
						

							5
ENGLISH
Disposal
Tips for environmental protection
Packaging materials
The materials marked with the symbol  are
recyclable.
>PEPSPP
						

							6
DIMENSIONS Height 85 cm
Width 60 cm
Depth 60 cm
MAXIMUM RECOMMEND LOAD Cotton, linen 5 kg
Synthetics 2 kg
Delicates 2 kg
Woollens 1 kg
SPIN SPEED FAE825V 800 r.p.m. max.
FAE1025V 1000 r.p.m. max.
POWER SUPPLY VOLTAGE/FREQUENCY 220-230 V/50 Hz
TOTAL POWER ABSORBED 2100 W
MINIMUM FUSE PROTECTION 10 A
WATER PRESSURE Minimum 50   kPa
Maximum 800 kPa
This appliance complies with the following EEC Directives:
73/23/EEC of 19/02/73 relating to low voltage
89/336/EEC of 03/05/89 relating to electromagnetic compatibility.
Technical specifications
It is dangerous to alter the specifications or attempt to modify this product in any way.
Care must be taken to ensure that the appliance does not stand on the electrical supply cable.
Any electrical work required to install this appliance should be carried out by a qualified electrician or
competent person.
Any plumbing work required to install this appliance should be carried out by a qualified plumber or
competent person.
The power supply cable only can be replaced by a person of our  Service Force Centre.
Intallation instructions
 
						

							7
ENGLISH
Installation
Transit security bars
Before starting the machine up, the transport
security  bars must be removedas follows:
You are advised to keep all the transport security
bars in case the appliance has to be transported
again.
1. Unscrew and remove
the three rear screws
by means of a key.
2. Lean the appliance
back on the rear and
fit one of the
polystyrene angles
between the appliance
and the floor.
Make sure the hoses
are not squashed.
3. Carefully remove the
plastic bags on the left
and the right, pulling
them to the centre of
the appliance
4. Place the machine in an upright position and
remove the three plastic bolts.
5. Plug the 3 holes with the plastic plugs which you
can find in the envelope containing the instruction
booklet.
Hydraulic connection
There should be a COLD WATERtap near the
washing machine with a screwing on connection
pipe of 3/4 gas for the water supply, a sink, a wash
basin or a drainage system in the wall.
Previously check if:
— it is not a hot water tap.
— the running water is clean. If not, run off a
reasonable amount of water to flush out any
debris that may have collected in the pipes.
Have the permanent drainage system in the wall
checked by a plumber.
A) Place the enclosed
rubber joint, delivered in
a plastic bag together
with the appliance (A)
Fig.6), at the very end of
the inlet hose and
carefully screw the pipe
to the tap taking care not
to damage the
screwdrive and fix the
nut well on to the end in
order to avoid leaking.
B)If necessary turn the
hose adequately by
unscrewing the nut at the
rear of the appliance.
C) Now tighten the nut
anew to avoid leaks.
(Open the tap and asure
that it does not leak and
close it again.)
D) Place the discharging
hose in a washbasin or
sink with the aid of the
bent piece delivered
separately. The bent
piece has to be entered
into the tube’s mouth in
order to assure the
support. Aforesaid piece
allows the hose to be
fixed to the wall by means
of an opening on the
upper part and that way
the hose does not move
and its falling is avoided.
P0287
P0018
AL009
21
P0001P0002
P0021


AL013
A
 
						

							8
1,5 m. Max.
60 cm. Min.
90 cm. Max.
IMPORTANT: The distance from the floor to the
highest part of the hose should be between 60 to
90 cm. (It is advised to be between 60 and 70 cm).
The hose must not be bent nor twisted to avoid
clogging. Should a prolongation of the discharging
hose be unavoidable this must never surpass 1.5 m
and must be of the same diameter as the original
hose.
Make sure the hoses are not too tense.
Levelling
Level the appliance by loosening or tightening the
feet. Once in the right position fix the feet by
pushing  the nuts against the base of the case.
Accurate levelling will prevent vibration, noise and
displacement of the appliance during operation.
Some vibration is inevitable, especially if placed on
a wooden floor. Wooden floors are particularly
susceptible to vibrations. For advice, consult a
builder. If posible always place the appliance on a
solid floor.
Electrical connections
Before plugging the appliance make sure that:
1º.the mains of your installation is the same as on
the rating plate of your appliance (the plate is
sticked to the rear of the appliance).
2º.The meter, the fuses, the wiring and the socket
outlet can support the max. power absorbed stated
on the rating plate.
3º.The socket base and the plug must fit in
adequately without any reducing interposition,
multiple outlets or adapters. If necessary replace
the socket outlet by an adequate one. 
The applicable rules for electrical security
require an adequate earthing. The plug of the
appliance is provided with such a device.
Make sure your socket outlet is provided with
an adequate earthing too.
The manufacturer declines any liability in case
of accidents or incicents should these safety
measures not be observed. 
The power supply cable only can be replaced by
a person of our  Service Force Centre.
P0254
 
						

							9
ENGLISH
This new machine meets all modern requirements for effective treatment of laundry with low water, energy and
detergent consumption.
•The balance control deviceensures the machine is stable during the spin.
1 Detergent dispenser drawer
2 Programme chart
3 Control panel
4 Door handle
5 Drainage area door
6 Adjustable feet
Detergent dispenser drawer
Prewash
Main wash
Fabric softener, starch
Your new washing machine
Description of the appliance
R0001 3D
 
						

							10
Use
1. Detergent dispenser drawer
Programme option buttons
Depending on the programme, different option
buttons can be combined.
When these buttons are pressed, the corresponding
lights come on. When they are pressed again, the
lights go off.
If an incompatible option with the selected
programme has been chosen, the corresponding
light flashes for about 2 seconds.
The option buttons:
PRE-WASHorQUICK WASH;
EASY IRONand SUPER RINSE
must be selected after the required programme has
been chosen, by turning the programme selector
(see section 9) and before starting the machine, by
pressing buttonSTART / PAUSE.
2. PRE-WASH or  QUICK WASH
By pressing this button you have the possibility of
choosing between the following options:
•PRE-WASHoption: Adds a pre-wash phase
at the start of the cycle with water heating to 30° C.
In COTTON and SYNTHETIC cycles, performs a
short spin before passing to the washing phase.
This option cannot be selected for WOOL.
•QUICK WASHoption: Using this option, you
can get good washing results in a short period of
time, since with option, the COTTON,
SYNTHETICS, and DELICATES programmes are
modified in order to obtain short washing times
(recommended for small or lightly-soiled loads).
This modification consists of reducing the number of
rinse cycles (one less) and also increases the water
level used in the remaining two rinse cycles.
If both lights (PRE-WASH andQUICK
WASH) are not illuminated the programme will run
without either PRE-WASH orQUICK
WASH). 
3. EASY IRON button
This option is available for COTTON, LINEN and
SYNTHETIC programmes. By selecting this button
the machine will inserts a impulse spin and an
anticrease phase after final spin in COTTON
programs. In SYNTHETIC programs, by selecting
this button the machine will inserts a cool-down after
washing phase and an anticrease phase after final
spin.
In case you want to avoid wrinkles in your laundry
after washing,the EASY IRON option must be
selected.
4.  SUPER RINSE button
Can be used with all programmes, except wool. 
The machine will add 2 rinses to the selected
programme.
This option is recommended for people who are
allergic to detergents and in areas where the water
is very soft.
5.  START / PAUSE button
After selecting the required programme, by the
programme selector (see section 9), press this
button to start the machine; the corresponding light
stops flashing and will keep lighting until the
programme finishes.
To interrupt the running programme, depress 
START / PAUSE button: the corresponding
light starts to flash.
To restart the programme from the point at which it
was interrupted, pressSTART / PAUSE button
again.
Control panel