Zanussi Essential 6 Kg Manual

• turn the drum and align
the filter cover (FILTER)
with the arrow on the
door seal;
• open the filter cover by
pressing the special
hook and by rotating
the cover upwards;
Warning! Keep the
filter cover open un-
til the filter removal.
• before removing the fil-
ter, remove any fluff or
small objects from
around the filter;
• remove the filter and clean it under the tap;
• if necessary, place the
filter cover in the right
position again.
• open the filter cover
and insert the filter
again;
The filter is...

• Screw the hose back onto the tap. Make sure the
connection is tight.
• Unscrew the hose from
the appliance. Keep a
towel nearby because
some water may flow.
• Clean the filter in the
valve with a stiff brush
or with the piece of
cloth.
• Screw the hose back to the appliance and make sure
the connection is tight.
• Turn on the water tap.
What to do if…
The appliance does not start or stops during operation.
Certain problems are due to lack of simple maintenance or
oversights, which can be solved with...

The drain hose is squashed or kinked.
• Check the drain hose connection.
The drain filter is clogged
• If the appliance stops working without discharging the water , first carry out an
emergency drain:
–
Turn the programme selector dial to 
 ;
– Unplug the appliance;
– Close the water tap;
– If necessary, wait until the water has cooled down;
– Unscrew the drain hose from the rear support (see Frost precaution) and un-
hook it from the sink or spigot;
– Let it run along the floor;
– Place a bowl on the...

MalfunctionPossible cause / Solution
The appliance does not start:
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The programme selector dial is not correctly positioned and the button 6 has not been
pressed.
• Please turn the selector dial and press the button 6 again.
The delay start has been selected.
• If the laundry are...

MalfunctionPossible cause / Solution
Spinning starts late or the ap-
pliance does not spin:
The electronic unbalance detection device has cut in because the laundry is not even-
ly distributed in the drum. The laundry is redistributed by reverse rotation of the
drum. This may happen several times before the unbalance disappears and normal
spinning can resume. If, after 10 minutes, the laundry is still not evenly distributed in
the drum, the appliance will not spin. In this case, redistribute the load...

26
  

 27 

 www.zanussi.com/shop
   
192987540-A-102011