ZALMAN Zm M215w Users Guide

							 
11
7-2. In 3D Mode 
1. Blurs and patterns are present when the screen is OFF.   
    - This phenomenon is the result of the interference of external light present on the air layer   
      between the LCD screen and the 3D filter. The intensity of this pattern is very weak,   
      which makes it unnoticeable when the LCD screen is ON so the monitor can be used   
   without any inconvenience.  
 
2. Images are presented as 2 images instead of in 3D.     
      1) If the enclosed polarized glasses are not worn   
          - This monitor must be viewed with the enclosed polarized glasses to view 3D effects. 
      [Note] 
      The enclosed glasses have been circularly polarized for compatibility with the monitor’s  
      3D filter. Using polarized glasses made by other manufacturers will not enable optimal 
            viewing of 3D images on this monitor, and even if they are circularly polarized glasses,   
            clear images cannot be viewed due to differences in optical characteristics.   
     
      2) If the monitor is viewed from beyond the viewing angle   
          - To view clear 3D images, the user’s eye level must be around the 3
rd horizontal quarter 
(from the bottom of the display) and the user should be approximately 30~60cm (1~2 
feet) away from the monitor. 
- The 3D effect is clearest within a horizontal angle of 90 degrees and a vertical angle of 
12 degrees relative to the monitor.   
 
      3) If the resolution adjustment has not been made     
          - Set the monitor’s resolution to its maximum resolution in the computer’s display settings.   
 
      4) If right/left images have been swapped   
          - For 3D videos, set the player’s Right Eye Images to line up with the display’s Odd 
Numbered Horizontal Lines.   
- For 3D pictures, set the viewer’s Right Eye Images to line up with the display’s Odd 
Numbered Horizontal Lines. 
- If the graphics signal is accurate but the image has shifted up or down a line, adjust the 
monitor’s V. Position under Menu-Picture settings.   
 
 
 
 
						

							 
12 3. If the image is seen in 2D and not 3D     
- This monitor is a 2D/3D Convertible Monitor. Media that was produced in 2D can only be 
viewed in 2D, and only media created in 3D can be viewed in 3D. 
 
4. Reflections are seen on the screen 
- This monitor has a glass 3D Filter attached to the front side of the LCD. It is not possible to 
remove the reflections on its surface. Therefore, it is a good idea to not place a light source 
behind the user. If a light source behind the user is unavoidable, adjust the monitor’s angle 
so that the light source’s reflection does not show on the display.