Xerox Documate 4799 User Guide

Safety
Xerox
® DocuMate® 4799
User’s Guide1-3
WARNING: This equipment must be connected to a protective earth circuit. 
This equipment is supplied with a plug that has a protective earth pin. This plug will only fit into an earthed electrical 
outlet. This is a safety feature. If you are unable to insert the plug into the outlet, contact your electrician to replace 
the outlet.
Disconnect Device
The power cable is the disconnect device for this equipment. It is attached to the back of the machine as a...

Safety
Xerox
® DocuMate® 4799
User’s Guide 1-4
Product Safety Certification
This product is certified by the following Agency using the Safety standards listed:
Environmental Health and Safety Contacts
Contact Information
For more information on Environment, Health, and Safety in relation to this Xerox product and supplies, please 
contact the following customer help lines:
Standard
UL60950-1 (USA)
CSA 22.2 No. 60950-1 (Canada)
IEC 60950-1
USA & Canada:1-800-828-6571
Europe:+44 1707 353 434 

Xerox® DocuMate® 4799
User’s Guide2-5
2Welcome
Your new Xerox scanner can quickly scan stacks of single-sided or double-sided pages and place their electronic 
images on your computer.
What’s in the Box
Before proceeding, check the contents of the box. If items are missing or damaged, contact the dealer where you 
purchased the scanner.
System Requirements
Pentium 4 PC or AMD equivalent with:
•A DVD-ROM drive
• An available Universal Serial Bus (USB) port
•Microsoft
® Windows® operating system: 
Xerox...

We l c o m e
Xerox
® DocuMate® 4799
User’s Guide 2-6– 32-bit Windows XP (Service Pack 1 and 2)
– 32-bit or 64-bit Windows Vista (Service Pack 1)
– 32-bit or 64-bit Windows 7
– 32-bit or 64-bit Windows 8
The scanner is compatible with Service Pack 3 for Windows XP, Service Pack 2 for Windows Vista, and Service 
Pack 1 for Windows 7.
• Minimum of 2 gigabyte (GB) of internal memory (RAM)
• 350 MB minimum of free hard disk space
A VGA or SVGA Monitor:
• The recommended settings for your monitor are:
– Color...

Welcome
Xerox
® DocuMate® 4799
User’s Guide2-7 •Patch code sheets—use with an application that supports detection of patch code data when using the 
TWAIN interface.  The patch code page layouts have been specifically designed for your scanner. The file 
contains Patch 2, 3 and T layouts for A4 and U.S. Letter size pages. 
Make sure you print the correct page size for the paper in your printer. Also, make sure the application you 
are using is not set to automatically scale the page to fit on the paper...

We l c o m e
Xerox
® DocuMate® 4799
User’s Guide 2-8 Pre-Imprinter door—Lift the output tray to access the pre-imprinter compartment.
Control panel—Scanner hardware controls.
•Hopper—Press the up or down arrow to manually adjust the height of the input tray level to match the 
height of the document stack. 
•ADF—Changes the scanner between automatic document feeding and manual document feeding. 
•Thickness—Press to change the roller position to match the paper thickness of the documents being 
scanned....

Xerox® DocuMate® 4799
User’s Guide3-9
3Scanner Setup
Unpack the Scanner
Use care when unpacking, moving and assembling the scanner. Follow these instructions to prevent injury and 
damage to the scanner.
1. Remove the scanner from the shipping box, verify all parts listed on page 5 are in the box.
We recommend that you keep the original packing materials in case you need them later.
2. Always have at least two people carry the scanner, lifting the scanner up from 
underneath.
3. Use a desk or table that...

Scanner Setup
Xerox
® DocuMate® 4799
User’s Guide 3-10
Install the Double Feed Prevention roller
1. Open the Pre-Imprinter door.
2. Release the retaining screw and then close the Pre-Imprinter door.
3. Pull on the scanner cover release and lift the lid to open the scanner. 

Scanner Setup
Xerox
® DocuMate® 4799
User’s Guide3-11 4. Flip open the double feed prevention roller cover.
5. Align the roller bar with the brackets in the roller compartment. Make sure the groove on the right side of the 
roller bar is aligned so that it slides in place into the U shape of the bracket. 
6. The roller is properly in place when you cannot rotate the metal bar of the roller.
7. Close the double feed prevention roller cover when you are finished. 

Scanner Setup
Xerox
® DocuMate® 4799
User’s Guide 3-12 8. Close the scanner when you are finished.
Connect the Scanner Power Cord
1. Select the appropriate power cord for your country.
2. Plug the power cord into the scanner and into a wall outlet.
Note: Do not turn on the scanner until after you install the software.