Wolf Cinema Projector Dcx 1000i Quickstart Manual

DCX-500iDCX-1000i
DCX-1500i
QUICK SETUP GUIDE 

Wolf Cinema Quick Setup Guidei
Introduction ........................................................................\
........................................................................\
.........................  1
Connecting the Projector  ........................................................................\
........................................................................\
....  1
Installing the Primary Lens  ........................................................................\...

Wolf Cinema Quick Setup Guide1
InTroduCTIon              
Wolf Cinema’s DCX line of projectors are designed to work in conjunction with the WC-Pro Scaler. The Scaler is calibrated at the factory 
and  is  to  be  used  to  route  the  variety  of  inputs  it  supports;  6  HDMI,  1  Component,  1  Component/RGB,  1  S-Video  and  1  Composite 
Video.
Each projector ships with 10 preset Channel Memories, which are programmed at the 
factory. These Channel Memories represent 10 aspect ratios per each...

Wolf Cinema Quick Setup Guide2
InsTallIng The PrImary lens            
Before installing any lens, be sure the projector is off. If the projector has been running, be sure to let it cool down completely. Ensure the 
front lens cap is on during installation.
noTe: Remove the small rear lens cap before installing!! Keep the large front \
lens cap on.
Electrical Connector:
1.   Line up the male connector on the lens with the female connector on the\
 slide assembly.
Insert Lens:
2.   Align the Tabs on the...

Wolf Cinema Quick Setup Guide3
The ProjeCTor Channel memorIes           
All  projectors  come  with  10  Channel  Memories  that  are  pre-set  for  the  Scaler's  inputs,  the  VariScope  lens  feature  and  VariScope  2.35 
Anamorphic lens configurations; all based on the installation specifications supplied by the dealer. Once the 10 Channel Memories are 
calibrated at the installation, those Channel Memories can be copied to \
the remaining empty Channel Memory slots (11-99).
See the entire...

Wolf Cinema Quick Setup Guide4
CoPyIng Channel memorIes            
To  select  a  Channel  Memory  to  be  copied,  press  the  Menu 
1. Menu  button  on  the  remote. The  projector's  On  Screen  Display  (OSD) 
will appear.
Scroll with the Up 
2. 

 or 
 Down buttons; highlight and select “Channel Setup” by pressing the\
 Enter  button.
The Channel Memory list from the OSD will appear.
3. 
Highlight the channel to be copied by scrolling with the Up 
4. 

 or 
 Down buttons.
Once the Channel...

Wolf Cinema Quick Setup Guide5
ChannelgPIo 
Control to 
Variscope  2.35 Input/gPIo 
selection at scaler
Channel 01 No HDMI 1
Channel 02 No HDMI 1
Channel 03 No HDMI 1
Channel 04 No HDMI 1
Channel 05 No HDMI 1
Channel 06 Yes HDMI 1
Channel 07 Yes HDMI 1
Channel 08 Yes HDMI 1
Channel 09 Yes HDMI 1
Channel 10 Yes HDMI 1
Channel 11 No HDMI 2
Channel 12 No HDMI 2
Channel 13 No HDMI 2
Channel 14 No HDMI 2
Channel 15 No HDMI 2
Channel 16 Yes HDMI 2
Channel 17 Yes HDMI 2
Channel 18 Yes HDMI 2
Channel 19 Yes HDMI...

Wolf Cinema . 2431 Fifth Street . Berkeley . CA 94710 . Ph: 510.843.4500 . Fax: 510.843.7120 . www.wolfcinema.com